Applications available in Belgium
-
Premium
Process instrumentation and analytics solutions for HVAC-R industry
Siemens is a trusted partner for single-source solutions that bring your Heating, Ventilation, air conditioning and refrigeration systems (HVAC/R) installations to a whole new level of energy efficiency. From cogeneration energy production, district heating and cooling systems to compressed air and steam applications, we maximize your energy conservation and optimize the cost effectiveness of every ...
By Siemens Industry, Inc. - Process Analytics based in Houston, TEXAS (USA).
-
Premium
Compressed-air technology
You are looking for a compressed-air station which is specially optimized for your case of application? In addition to customised product solutions, AERZEN supports you within the entire development cycle, from the conception to the implementation and commissioning of your compressed air ...
By Aerzener Maschinenfabrik GmbH based in Aerzen, GERMANY.
-
Premium
Gas detection in industrial gases
Industrial gases include all companies which manufacture atmospheric Gases, specific gases, semi-conductor gases and supply them to end users in different ways: on-site, cylinders, tanks to be used in lot of industrial manufacturing ...
By Teledyne Gas and Flame Detection based in Arras Cedex, FRANCE.
-
Premium
Refineries and hazardous areas gas analyzers for industrial air monitoring
Chromatotec can propose for hazardous areas (for instance refineries) specific boxes for our analysers : category 1 IIc T4 for ...
By Chromatotec Group based in Val de Virvée, FRANCE.
-
Premium
Ozone Generator for Cooling Tower
The treatment of cooling towers with ozone is not only good for the environment but also good for the bottom line. Ozone, a powerful biocide and oxidant , affords several advantages over the traditional chemical treatment of cooling towers, ...
By Chemtronics Technologies (India) Pvt. Ltd. based in Mumbai, INDIA.
-
Premium
Gas analyzers and monitoring systems for carbon capture & storage (CCS)
Carbon Capture and Storage (CCS) is an emerging method of reducing greenhouse gas (GHG) emissions of power plants. In a process called ‘scrubbing’, the carbon dioxide emissions can be absorbed into chemical solvents consisting of amines or carbonates. Scrubbing is a well-established method of carbon capture, with virtually every commercial CO2 capture plant in operation using this process. In the process, the first step is the removal of impurities from the flue gas, such as hydrocarbons and oxides of ...
By Gasmet Technologies - a Nederman company based in Vantaa, FINLAND.
-
Premium
Blowers, compressors and gas meters for process gas technology
The differences in compressor technologies can be found right where thedemanding applicationsare. Where often highly critical processes gases and coolants are compressed. In thechemical, petrochemical, energy, food, or pharmaceutical industries.The demands on plant design, engineering, documentation and worldwide service in those industries are often just as high as thesafety and environmental guidelinesto be ...
By Aerzener Maschinenfabrik GmbH based in Aerzen, GERMANY.
-
Premium
Direct determination of mercury content in ambient air
Introduction: Mercury, being widespread in environment, has toxic effect on a human organism even at a low concentration. Therefore, quantitative e determination of mercury in various environments is one of the most important environmental monitoring problems. The use of a mercury analyzer RA-915M/RA-915+/RA- 915Light with Zeeman background correction provides direct real-time continuous determination of mercury in air from 0.5 ng/m 3 within the overall possible range of mercury concentration in ambient ...
By Lumex Instruments based in Mission, BRITISH COLUMBIA (CANADA).
-
Premium
Environmental Data Monitoring Solutions for Controlled Atmosphere
To reduce the introduction, generation and retention of particles in cleanrooms, particle concentration controls are set ...
By Ecomesure based in Saclay, FRANCE.
-
Premium
Blowers, compressors and gas meters for vacuum technology
Whether in foodstuff or pharmaceutical industry, in the chemistry or process engineering, metall processing or in automotive industry: in many branches of industry most different manufacturing processes require gas conditions with a pressure considerably below atmospheric pressure. A pressure of -700 mbar (300 mbar abs.) is considered as negative pressure. Below 300 mbar absolute the vacuum range begins, subdivided in rough, fine, high and ultra high ...
By Aerzener Maschinenfabrik GmbH based in Aerzen, GERMANY.
-
Premium
Respirometry solutions for modeling of methane and hydrogen production sector
Waste Type: Synthetic (Ethanol). Objective: To model the methane produced from acetate and from hydrogen in cultures receiving ethanol as an input substrate. The objective was to verify the accuracy of models developed on the basis of substrate ...
By Challenge Technology based in Springdale, ARKANSAS (USA).
-
Premium
Emission control solutions for clinker cooler and pre-heater dedusting sector
The control of clinker fines emissions after the heat exchanger, placed downstream of the clinker cooler, is usually a problem for cement plant managers. The process is characterized by high material abrasiveness, high loads and variable flow rate in normal and maximum ...
By Advanced Cyclone Systems, S. A. (ACS) based in Porto, PORTUGAL.
-
Premium
Gas monitoring instruments and systems for stack testing according to EPA test method 320
The United States Environmental Protection Agency (EPA) has two stack testing methods for FTIR gas analyzers. Method 320 is an FTIR method for measuring wide range of organic and inorganic pollutants. Method 321 is a specific version for measuring hydrogen chloride HCl at cement kilns producing Portland cement. These methods define a quality assurance and control processes for verifying the accuracy of the results. The requirements for analytical equipment and software are defined on 40 CFR Part 60 Appendix B ...
By Gasmet Technologies - a Nederman company based in Vantaa, FINLAND.
-
Premium
Continuous emissions monitoring for brick plants
Process control and emissions monitoring in a brick plant is a challenge due to the high concentrations of HF. The HF is generated in the process and gas phase HF can reach 50 mg/m3 or more. To use an extractive system in this environment will demand a lot of ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
Gas monitoring instruments and systems for DeNOx process control
In most combustion process atmospheric nitrogen reacts with oxygen in high temperature conditions to produce nitrogen oxides (NOx). Total NOx production is the sum of nitrogen monoxide NO and nitrogen dioxide NO2. The emissions of these gases are controlled through setting of emission limit values (ELVs) for power ...
By Gasmet Technologies - a Nederman company based in Vantaa, FINLAND.
-
Premium
Raw-gas monitoring for scrubber optimizing
The consumption of scrubbing material in a scrubber is related to the mass flow of acid gases. Hydrogen chloride (HCl) and sulphur dioxide (SO2) are the major acid gases in an incinerator. By measuring the mass flow of SO2 and HCl in the raw gas going into the scrubber, it is possible to calculate the required quantity of scrubbing ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
Gas analyzers for U.H.P. industry
Air Liquide, Praxair, Air Products, BOC, Messer, Linde, Takachiho, Aga, etc. need to control the amount of impurities before delivery to customer in petrochemical or chemical ...
By Chromatotec Group based in Val de Virvée, FRANCE.
-
Premium
On-Line gas, particulate analyzers, flow monitors, data acquisition for combustion
By ENVEA based in Poissy, FRANCE.
-
Premium
Mercury monitoring for manual analysis of air traps
The Tekran 2600 versatility is evident with the economical and convenient configuration for manual analysis of air samples collected on gold cartridges. Converting the instrument allows calibration by simple injection of gaseous Hg using the Tekran 2505. Once analyzed, the gold cartridges are immediately ready for ...
By Tekran Instruments Corporation based in Toronto, ONTARIO (CANADA).
-
Premium
Weather Monitoring for the Air and Climate Industry
OWI-430 DSP-WIVISTM Present Weather and Visibility Sensor Combines present weather identification, precipitation measurement and visibility into a single rugged package. • Outstanding performance yet low cost • DSP based – no field calibration required • Advanced scintillation technology • Intelligent algorithms based on over 800 million hours of OSi sensor field data • Rugged design – field proven from tropical to sub-arctic environments • Easy Installation and integration • Long-term reliability – designed for ...
By Optical Scientific Inc. (OSi) based in Gaithersburg, MARYLAND (USA).
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you