Only show results available in Virginia? Ok

air and dust monitoring Applications

  • Premium

    Dust on-line monitoring solution

    With the application of air quality PM2.5 standards, people have a clear understanding and attention on ambient air quality, countries also present clear requirements and control objectives. Due to the speeding up of development process of cities construction in recent years, unceasing expands of the urban area and population scale, sustained growth of energy demand, motor vehicle ownership, various construction projects, the situation of urban air quality improvement work is more severe.

    By HANGZHOU ZETIAN TECHNOLOGY CO., LTD based in Hangzhou, CHINA.

  • Dust monitoring and Sand Storm Monitoring

    The frequency and intensity of dust and sand storms in many parts of the world are steadily increasing due to droughts and climate change. The severity of such storms is anticipated to increase over the coming years. These dust storms may last hours or days and cause huge damage and imposed a heavy toll on society with its physical effects, such as visibility reduction, heavy winds, red sky, hailstone and severe lightning. Such Dust storms, have a negative impact on human health, and industrial products and...

    By Ecotech Pty Ltd based in Knoxfield, AUSTRALIA.

  • Premium

    Meteorological sensors for dust monitoring

    Air is lifeblood. Daily we inhale approximately 15.000 liter. Still, the air contains invisible pollutants, which vary in its composition and concentration depending on the location. Especially the respirable particles with a diameter of less than 2.5 µm (PM 2.5) were considered to be particularly dangerous.

    By G. Lufft Mess- und Regeltechnik GmbH based in Fellbach, GERMANY.

  • Premium

    Industrial monitoring solutions for the dust monitors areas

    For large combustion plants and power plants we offer the DCEM 2100 particulate monitor. This monitor is certified to EN 15267 part 3 QAL 1 for all industrial processes including waste incineration. It offers outputs in Transmission, Opacity and mg/m3 (when calibrated against a Standard Reference Method). The DCEM 2100 offers real-time zero and span calibration and an efficient air purge system to prevent optical contamination.

    By Codel International Ltd based in Bakewell, UNITED KINGDOM.

  • Premium

    Industrial monitoring solutions for the opacity and dust monitoring areas

    There is a requirement for many small boiler operators to monitor Opacity to determine the smoke density emitted from the boiler. On small boilers we recommend the DCEM 1001 Opacity monitor; this simple, low cost monitor has high efficiency air purges use compressed air to ensure that optical surfaces are virtually free of dust or debris contamination. This ensures minimal maintenance is required on the sensors.

    By Codel International Ltd based in Bakewell, UNITED KINGDOM.

  • Premium

    Industrial monitoring solutions for the dust collectors areas

    Most industrial processes have dust collectors of some form or other, the most popular being filter bag houses. Very few of these are covered by regulation other than to have a broken bag detector to prevent nuisance dusts escaping and creating a local nuisance. The CODEL StakGard is a low cost Tribo-electric monitor that directly measures mass particulate concentration by sensing the frictional charge created when particles collide with a conductor. The advanced electronics of the StakGard detect this signal and...

    By Codel International Ltd based in Bakewell, UNITED KINGDOM.

  • Gas analysis & monitoring systems for dust

    Particulate matter, suspended particulate matter, atmospheric dust, particulate matter, total suspended particulate (TSP), are terms that commonly identify the group of substances suspended in the air (fibers, carbon particles, metals, silica, polluting liquid or solid). Particulate matter is the pollutant that is now considered the greatest impact in urban areas, and is composed of all those solid and liquid particles dispersed in the atmosphere, with a diameter ranging from a few nanometers to 500 microns and...

    By ETG Risorse e Tecnologia S.r.l. based in Montiglio, ITALY.

  • Premium

    Industrial monitoring solutions for the flow monitoring areas

    Many large combustion plants are now required to monitor mass emissions of major pollutants and to do so requires an accurate measurement of stack gas velocity. The VCEM 5100 is certified to EN 15267 part 3 QAL 1 for all industrial processes including waste incineration. It has several key advantages, firstly the sensors optics are not in contact with the hot and dusty environment, the VCEM 5100 can monitor gases at temperatures exceeding 10000C and the analyser requires minimal maintenance. The VCEM 5100 can be...

    By Codel International Ltd based in Bakewell, UNITED KINGDOM.

  • Opacity monitoring for continuous emissions

    The history of air pollution regulation dates back as far as the 13th century when in 1273, Edward I (Longshanks) of England prohibited the burning of sea coal in London. The smoke produced by its combustion was considered detrimental to human health. By the late 19th and early 20th centuries, regulations were being passed that sought to control air pollution predominantly for smoke and odour control. Traditionally, regulators were concerned with the visual impact of the discharge from a stack or chimney. Therefore...

    By DynOptic Systems Ltd based in Brackley, UNITED KINGDOM.

  • Premium

    Environmental solutions for the flue gas temperature control

    Evaporative gas cooling and conditioning systems help protect your downstream equipment, enhance air pollution control performance, reduce gas volumes, and increase production capacity. Central to our systems are Turbotak atomizing nozzles, which introduce a controlled amount of finely atomized water into the hot gas stream to reduce and/or maintain gas temperature. The water evaporates, while absorbing heat from the gases, for free-flowing dust, zero liquid discharge, and minimal or no wall buildup.

    By Dürr Megtec LLC based in De Pere, WISCONSIN (USA).

  • Gas analysis & monitoring systems for semiconductor

    The Cleanroom is a combined laboratory chemical, mechanical and / or electronic whose main characteristic is the presence of very pure air, that is a very low content of fine dust in suspension. In the process of semiconductor production, the airborne particles (micro-powder) go to irreparably damage the micro-photoetched that form the chip, creating an electronic circuit defective, and then discarded. This process has forced the improvement of industrial production environments, removing particles from the air,...

    By ETG Risorse e Tecnologia S.r.l. based in Montiglio, ITALY.

  • Air sampling for emergencies

    Deployable battery operated monitoring systems for measurement of dusts (PM10, PM2.5), gases and vapours. Generally used for measurements of site boundaries or chemical incidents

    By Casella based in Kempston, UNITED KINGDOM.

  • Premium

    Visual inspection solutions for the duct HVAC camera

    Duct (HVAC) cleaning is an important part of maintaining good air quality in any building, if ducts are not being cleaned properly, air polluted by dust and other fine particles that can be harmful, will be circulated throughout the system. The best way to ensure ducts are being cleaned completely is to visually inspect them, this can now be accomplished using HVAC inspection cameras. These CCTV cameras are composed of a digital inspection camera attached to a push rod to enable the camera to access all parts of...

    By Fiberscope.net by Medit Inc. based in Winnipeg, MANITOBA (CANADA).

  • Air Quality & Emission Management Issues

    • Development of documents substantiating the volumes of emissions of pollutants into the air from stationary sources for enterprises, organizations and private entrepreneurs; • Inventory of air pollutants emissions from stationary sources; • Preparing, maintenance support of documentation for receiving a Permit for Emissions of Pollutants into the Air from Stationary Sources (PEPASS) *, issued by the Departments of Environment and Natural Resources of the regional state administrations of Ukraine; • Development...

    By PP `Tehnologia O` based in Vinnytsia, UKRAINE.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you