Whether you are flow coating miniblinds, magnetic tape, aluminum cans, coils, wire or paper, Anguil`s 35 years of pollution control experience has provided unique insight into the wide variety of applications in the coating industry. Anguil`s experience leads directly to savings for our customers. Determining your solution begins by quantifying the problem with a thorough assessment of your emissions. Utilizing proven principles of design engineering, your system will evolve to incorporate air volume reduction...
One-time, on-site final destruction of particulates. This is the key benefit gained from an Anguil solution to the emissions generated by the rubber curing process. Other advantages of an Anguil solution include the elimination of visible blue haze, guaranteed destruction efficiency compliance, and the elimination of costly mechanical filtration media and the lingering liability issue associated with filter disposal.
Anguil customers in the Semiconductor and Electronics industries include chip manufacturers, printed circuit board makers, LCD (Liquid Crystal Display) manufacturers and probimer operations. Each of these processes have unique emission control challenges that all require a custom engineered system designed around the given process parameters. With Anguil`s product breadth our customers are ensured that the proper technology will be chosen.
Anguil`s engineering expertise has led to numerous successful air pollution control and emission control installations in the automotive manufacturing industry. From painting vehicles to engine test stations and tire manufacturing, we have supplied oxidizers and heat recovery systems to both tier 1 and tier 2 automotive plants.
Ventilation Air Methane (VAM) is a Greenhouse Gas (GHG) released by coal or mineral mining operations, it is also commonly known as Coal Mine Methane (CMM). The air pollutants from this process have a global warming potential 21 times greater than carbon dioxide, which is another well known GHG. As alternative energy technologies have developed, methane is increasingly used to generate electricity and heat. Landfills and mines represent two of the most abundant sources, however reports indicate that more than...
From pill coating and mixing operations to Ethylene Oxide (ETO) sterilization, Anguil has had great success solving a wide range of emission control applications in the pharmaceutical industry. As companies struggle to comply with the EPA`s MACT (Maximum Achievable Control Technology) standards or international regulations, it is comforting to know that Anguil thoroughly understands your process. Over three decades of experience treating halogenated, VOC and HAP process streams enable us to efficiently solve your...
The remediation division of Anguil Environmental Systems (formerly known as Global Technologies) is focused on treating emissions and water contaminants extracted from below the earths` surface. Formed shortly after the 1990 Clean Air Act targeted emissions associated with the extraction of polluted compounds from contaminated sites, Global subsurface remediation equipment has been successfully applied on contaminated sites in North and South America, Europe, Asia and Australia.
Where molded plastic parts or vinyl fabrics are produced, scrubbers are used to capture the sub-micron fumes produced in the heating process. Also, scrubbers are commonly used to treat metal treating off-gases for removal of acid gases and/or fine mists.
The diversified consumer goods industry, with its broad range of products, is a significant area for air pollution control applications. Today, the ecological image of a company and its products is an important factor in the purchase decisions of customers. An increasing number of suppliers, therefore, aim to maintain their growth with ecologically sustainable production.
Environmental regulations for air pollution cotrol at metal decorating and packaging facilities usually address can makers, base coil coaters, or metal parts and packaging manufacturers. Metal Decorating can be classified as any process where metal is formed painted, or coated. Metal Packaging is generally considered processes involved in the production of aluminum cans, light metal containers, closures and components.