air pollution monitor Applications in Latin America

  • Premium

    Continuous emissions monitoring for CO2 capture

    The process control of a CO2 capture plant needs good and reliable detection of gas phase NH3 and CO2. Measuring NH3 is a challenge due to the corrosive environment and high concentrations of NH3. Several places in the process needs to be monitored and to transport the sample is difficult. A large dynamic range is needed as the NH3 concentration can vary between 15% volume and a few mg/m3.

    By Opsis AB Distributor in Chapultepec, MEXICO.

  • Premium

    Low concentrations monitoring of benzene and aromatic hydrocarbons (BTEX) for pollution control and environmental monitoring

    With over 15 years of experience in the measurement of volatile organic compounds (VOC), Environment SA announces the VOC72M, a new generation analyzer for the measurement of BTEX compounds by gas chromatography with photo-ionization detector (PID). The VOC72M can handle up to 40 compounds and eight configurations for analysis. This compact and fully automated analyzer with wide voltage range specifications (90-240V) provides equivalent performance to the laboratory chromatographs and is particularly suited to fixe or mobile ambient air quality monitoring laboratories. The VOC72M is fitted with a PID detector new generation, much more sensitive, more stable and whose lamp does not need to be cleaned; the analyzer integrates flow control fittings a 3 levels security system built on and uses only one gas (nitrogen). This robust and low maintenance instrument performs all the functions (sampling, analysis and data management) in a simple and completely autonomous mode. It is a particular

    By Environnement S.A Group - envea Distributor in Rio De Janeiro, BRAZIL.

  • Premium

    Low level measurement of aromatic hydrocarbons (BTEX) for pollution control and environmental monitoring.

    The Series 8900 BTEX Analyzer with a high-sensitivity PID provides direct low level measurement of Benzene, Toluene, Ethylbenzene, and Xylene`s in ambient air. This instrument is utilized in ambient air networks around metropolitan areas and fence-line monitoring at industrial sites.

    By AMETEK MOCON - Baseline Distributor in Buenos Aires, ARGENTINA.

  • Premium

    Monitoring solutions for the flow monitoring areas

    Many large combustion plants are now required to monitor mass emissions of major pollutants and to do so requires an accurate measurement of stack gas velocity. The VCEM 5100 is certified to EN 15267 part 3 QAL 1 for all industrial processes including waste incineration. It has several key advantages, firstly the sensors optics are not in contact with the hot and dusty environment, the VCEM 5100 can monitor gases at temperatures exceeding 10000C and the analyser requires minimal maintenance. The VCEM 5100 can be used in extremely dust environments such as SCR’s when dust loadings exceed 10g/m3. The VCEM 5100 is in full compliance with EN/ISO 16911 part 2.

    By Codel International Ltd Distributor in São Paulo, BRAZIL.

  • Premium

    Continuous Metals Stack Monitor (CEMs)

    Cooper Environmental's Xact® 640 has the unique ability to generate high time resolution metals measurement in stacks. This unique capability has the potential to qualify as a substitution for the combination of a Hg/ PM CEMs application as well as the potential for a pollution control system feedback loop that could result in the reduction of pollution control consumables. Our systems have been site certified for compliance measurements at hazardous waste incinerator and secondary lead smelter sites.

    By Cooper Environmental Services Distributor in Nunoa, CHILE.

  • Premium

    Meteorological sensors for dust monitoring

    Air is lifeblood. Daily we inhale approximately 15.000 liter. Still, the air contains invisible pollutants, which vary in its composition and concentration depending on the location. Especially the respirable particles with a diameter of less than 2.5 µm (PM 2.5) were considered to be particularly dangerous.

    By G. Lufft Mess- und Regeltechnik GmbH Distributor in Orient, MEXICO.

  • Premium

    Ambient Stations for Ambient Air Quality Monitoring

    Ambient air monitoring involves the measurement of `representative` air in urban, industrial and rural areas. These measurements are used to determine the human exposure to pollutants and can be combined with trace/background monitoring.

    By Opsis AB Distributor in Chapultepec, MEXICO.

  • Premium

    Ambient air quality monitoring solutions for tunnel monitoring

    Car tunnels need ventilation in order to keep air pollution below the limits. When the pollution levels reaches a setpoint, the fans must be started and kept running until the pollution levels decreases.

    By Opsis AB Distributor in Chapultepec, MEXICO.

  • Premium

    Ambient air quality monitoring for governments

    SO2 monitoring for the US NCore network, a multi pollutant network to measure  particles, pollutant gases and meteorology.

    By Teledyne API Distributor in TRINIDAD & TOBAGO.

  • Premium

    Emissions Monitoring for Airports

    Opsis systems provide high-performance monitoring of the emission activities within an airport. The rapid system allows on-line monitoring of the emissions from each aircraft at take-offs and landings, monitoring of fugitive emissions from stationary sources and differing of the airport sources from the surrounding pollution sources.

    By Opsis AB Distributor in Chapultepec, MEXICO.

  • Air quality monitoring for health protection

    Vertical pollution monitoring at different levels of a high rise building can reveal exposure of inhabitants to pollution and inform guidance about ventilation.

    By AQMesh Office in Chacara Sto. Antônio, BRAZIL.

  • Premium

    Ambient air quality monitoring solutions for fence-line monitoring

    The OPSIS open-path monitoring system is an excellent tool for monitoring the air quality, fugitive emissions and gas leaks at industrial sites. By arranging monitoring paths strategically at locations outside the borderline of an industrial area, fugitive emissions and gas leaks will effectively be detected. By combining the measured gas data with meteorological parameters information such as where the pollution sources are located and the strength of the emissions can be calculated, using the EnviMan software.

    By Opsis AB Distributor in Chapultepec, MEXICO.

  • Air quality monitoring for traffic

    Modern intelligent traffic systems are designed to move traffic in an efficient manner as well as reduce the environmental impact of traffic on nearby populations. This includes the effects of noise, particle pollution and gases.

    By AQMesh Office in Chacara Sto. Antônio, BRAZIL.

  • Premium

    Measuring aromatic hydrocarbons (BTEX) for pollution control and environmental monitoring

    The Series 8900 BTEX Analyzer provides direct measurement of Benzene, Toluene, Ethylbenzene, and Xylenes in ambient air. This instrument is utilized in ambient air networks around metropolitan areas and fence-line monitoring at industrial sites. The Series 8900 BTEX Analyzer employs a photoionization detector (PID) as the sensing element. This detector is specific to volatile organic compounds. The Benzene, Toluene, Ethylbenzene, and Xylene`s in the gas sample are physically separated using proprietary GC columns.

    By AMETEK MOCON - Baseline Distributor in Buenos Aires, ARGENTINA.

  • Odour Monitoring

    Measurement of odours from pulp & paper, feedlots and natural sources is challenging and requires careful selection of instrumentation. Ecotech offers a complete monitoring solution designed for this application. Odours are one of the most common sources of air pollution complaints and may be due to a wide variety of sources from rotting vegetation, animal feedlots, pulp and paper manufacturing, sewerage treatment facilities etc. The measurement of odours is extremely difficult due to the variety of sources of odour and the often very low ppb concentrations that produce odour. However, some industries and applications have a known source of odour resulting from compounds such as mercaptans, hydrogen sulphide, ammonia, typically from industries such as pulp and paper manufacturing, fertiliser production or natural sources such as rotting vegetation. Ecotech is able to offer extremely sensitive instrumentation and systems that enables the low ppb monitoring of these species down to 1 ppb, fully integrated with our data evaluation and reporting software.

    By Ecotech Pty Ltd Distributor in ARGENTINA.

  • Noise monitoring for airport noise

    Air traffic is the source of several forms of disturbance to the surrounding area, including, in particular, noise pollution. Local residents in the vicinity of an airport are the most severely affected and are very conscious of the aircrafts` flight paths and the impact on their day-to-day living conditions.

    By ACOEM Office in Sao Paulo - SP, BRAZIL.

  • Roadside monitoring

    Traffic, especially in urban locations, is one of the greatest contributors to air pollution. Traffic produces a variety of different pollutants that include particulates, NO2, NO, CO, hydrocarbons and in some cases SO2. The monitoring of roadside pollution can be challenging as often it is difficult to find suitable locations for large air quality monitoring systems and many sites that are available can be too far away to be representative of roadside air pollution.

    By Ecotech Pty Ltd Distributor in ARGENTINA.

  • Mass Spectrometer for air consultancy

    Everyone has a responsibility to care for the environment to reduce the levels of pollution, including businesses that daily release emissions into the air and the ground. This is why we provide a full-service environmental testing service to help businesses identify problems and resolve them so they operate in the most environmentally-friendly method possible. We offer air emission testing, emissions monitoring services and stack emissions testing to businesses of all sizes.

    By Custom Stack Analysis, LLC. Office in Guaynabo, PUERTO RICO.

  • Air emissions testing for air regulations and compliance consulting

    There are many businesses that release emissions into the air due to their daily processes. Because there are regulations in place to minimize pollution, these businesses need the help of air testing companies to make sure they are in compliance with the regulations. We perform air emissions testing to let your business know whether it falls within the set guidelines, as well as emissions monitoring services to ensure you remain within the regulations. This will keep the environment around your plant healthy and ensure you don’t accrue fines for violations.

    By Custom Stack Analysis, LLC. Office in Guaynabo, PUERTO RICO.

  • Premium

    Measurement of methane and non-methane hydrocarbons for environmental air quality.

    The Model 8900 Methane/Non-Methane Analyzer provides direct measurement of Methane and Non-Methane Hydrocarbons. This instrument is utilized in ambient air monitoring networks around metropolitan areas, fence-line monitoring at industrial plants and hazardous waste sites, and in the production of high purity industrial gases. Methane is a naturally occurring gas generated from the decomposition of biological materials and industrial activity. Since Methane is not considered a pollutant it is the Non-Methane hydrocarbons that are of primary concern.

    By AMETEK MOCON - Baseline Distributor in Buenos Aires, ARGENTINA.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you