Only show results available in Virginia? Ok

air VOC Applications

  • Premium

    VOC and HAP Abatement

    As is the case for many industrial manufacturing processes, emissions are best destroyed through the use of thermal and catalytic oxidation technologies. Volatile Organic Compounds (VOCs) and Hazardous Air Pollutants (HAPs) are destroyed through the use of high temperature combustion with direct heat recovery. The harmful air pollutants are converted to heat, water vapor and carbon dioxide, creating a destruction efficiency greater than 99%.

    By Anguil Environmental Systems, Inc. based in Milwaukee, WISCONSIN (USA).

  • VOC RECOVERY

    7 Plants designed and operational 1. Viscose rayon plants. CS2 recovery, CS2 Conc. 5 to 15 gms/M3. Capacities up to 45000 M3/hr. approx 800 TPY. 2. Methanol recovery from 28 equip vents , batch processes. 180 TPY 3. Acyrlonitrile recovery from vents 600 TPY 4 Dichloromethane 900 kg/hr process vent.

  • Premium

    VOC Abatement Improves Air Quality

    By Munters based in Amesbury, MASSACHUSETTS (USA).

  • Premium

    VOC control for production painting and coating

    Catalytic Combustion Corporation has significant experience designing and building VOC controls for painting and coating industries in a wide variety of regulatory climates.

    By Catalytic Combustion Corporation based in Bloomer, WISCONSIN (USA).

  • Measurement solution for VOC emissions monitoring

    Protea has used our VOC gas analysers in many projects requiring the monitoring of complex mixes of VOCs. In the chemical and pharmaceutical industry, VOC abatement plants such as scrubbers and carbon-bed systems are typical installations where the use of Protea analysers and our VOC analysis expertise have proved valuable to plant operators. They prove a very powerful and flexible tool in both process gas measurements and VOC emissions monitoring. In the laboratory, Protea can deliver instruments with all the...

    By Protea Limited based in Middlewich, UNITED KINGDOM.

  • Premium

    Low level measurement of VOCs and Terpenes close to the sea and the Landes Forest

    It has been established that organic aerosol (OA) makes up for a major fraction of fine particulate matter in all region of the atmosphere. This fraction accounts approximately for half of the total PM2.5 dry mass.1,2 Primary OA is directly emitted in the troposphere from anthropological and natural sources whereas secondary OA (SOA) is formed in-situ in the atmosphere from the oxidation of biogenic or anthropogenic gas-phase precursors and subsequent partitioning of the less volatile products into the...

    By Chromatotec Group based in Val de Virvée, FRANCE.

  • Environmental monitoring solutions for the air stripping and VOC removal

    Remove volatile organic compounds (VOC) from groundwater.

    By QED Environmental Systems, Inc based in Dexter, MICHIGAN (USA).

  • Measurement solution for measuring total VOC via FTIR

    Current Total VOC Measurements

    The most common, and current standard, method for measuring Total Volatile Organic Compounds (VOC) is the use of a Flamed Ionisation Detector (FID). This gives a representative value of the total carbon content of a gas stream, as the FID cannot tell which specific organic compounds are present.

    By Protea Limited based in Middlewich, UNITED KINGDOM.

  • Oil Mist and VOC Collection

    Oil Mist is Unbreathable. Oil based cutting fluids are often used in CNC milling, machining and metalworking. During production, these processes can produce a mist that can threaten sensitive electronic circuitry and presents serious physical risks to employees (accidents from slipping, breathing hazards).? What are the risks in a workshop with oil mist? Exposure to oil mist for a prolonged period of time can cause a number of health issues. Dermatitis Eye, nose and throat irritation Damage to the respiratory...

    By Diversitech based in Montreal, QUEBEC (CANADA).

  • Premium

    VOC emission treatment for flexographic industry

    As for VOC emission treatment, each Industry has its own technical requirements. As a technology supplier, we at Tecam Group are familiar with the production processes and requirements of Flexographic manufacturers, and have a deep understanding of the technology they require for exhaust air emission treatment, and specifically, for Volatile Organic Compounds VOC emission treatment.

    By Tecam Group based in Llinars del Vallès, SPAIN.

  • Premium

    Waste to Energy

    We can treat the air streams from waste management plants, MBT (Mechanical Biological Treatment) reception and composting areas, Waste Water Treatment Plants (WWTP), Refuse Derived Fuel (RDF) Plants, gasification of waste, syngas, torrefaction, gas engines and biogas upgrading. In waste management plants and WWTP, we remove the odors that may be causing a nuisance to neighbors, with bioreactors using Biomass to degrade odorous components and where odors are particularly intractable or VOC emissions higher,...

    By Dürr Megtec LLC based in De Pere, WISCONSIN (USA).

  • BREEAM Air Quality

    The sustainability and environmental impact of a new build house is typically assessed using BREEAM. Part of the BREEAM assessment method is determining the air quality inside the house. Gradko can supply a range of products for qualified BREEAM assessors. We try to work with qualified BREEAM assessors to determine and meet their requirements. The products we normally supply are used for monitoring formaldehye and VOC levels in new build properties.

    By Gradko International Ltd based in Winchester, UNITED KINGDOM.

  • Premium

    PTR-MS systems for indoor air quality monitoring

    Room-air VOC detection and monitoring. Measurement of most common VOCs causing smells or health effects. Real-time monitoring of emissions related to the Sick Building Syndrome. Ozone induced reactions in aircraft cabins.

    By Ionicon Analytik Ges.m.b.H. based in Innsbruck, AUSTRIA.

  • Premium

    VOC emission treatment for pharmaceutical industry

    As for VOC emission treatment, each Industry has its own technical requirements. As a technology supplier, we at Tecam Group are familiar with the production processes and requirements of Pharmaceutical manufacturers, and have a deep understanding of the technology they require for exhaust air emission treatment, and specifically, for Volatile Organic Compounds VOC emission treatment.

    By Tecam Group based in Llinars del Vallès, SPAIN.

  • Premium

    VOC emission treatment for petrochemical industry

    As for VOC emission treatment, each Industry has its own technical requirements. As a technology supplier, we at Tecam Group are familiar with the production processes and requirements of Petrochemical manufacturers, and have a deep understanding of the technology they require for exhaust air emission treatment, and specifically, for Volatile Organic Compounds VOC emission treatment.

    By Tecam Group based in Llinars del Vallès, SPAIN.

  • Premium

    VOC emission treatment for Coating industry

    Specific characteristics of this Industry: Large air flows. Medium VOC concentrations.

    By Tecam Group based in Llinars del Vallès, SPAIN.

  • Premium

    VOC emission treatment for chemical industry

    As for VOC emission treatment, each Industry has its own technical requirements. As a technology supplier, we at Tecam Group are familiar with the production processes and requirements of Chemical manufacturers, and have a deep understanding of the technology they require for exhaust air emission treatment, and specifically, for Volatile Organic Compounds VOC emission treatment.

    By Tecam Group based in Llinars del Vallès, SPAIN.

  • Premium

    VOC emission treatment for automotive auxiliary industry

    As for VOC emission treatment, each Industry has its own technical requirements. As a technology supplier, we at Tecam Group are familiar with the production processes and requirements of Automotive manufacturers, and have a deep understanding of the technology they require for exhaust air emission treatment, and specifically, for Volatile Organic Compounds VOC emission treatment.

    By Tecam Group based in Llinars del Vallès, SPAIN.

  • Premium

    Air pollution control for the coating industry

    Whether you are flow coating miniblinds, magnetic tape, aluminum cans, coils, wire or paper, Anguil`s 35 years of pollution control experience has provided unique insight into the wide variety of applications in the coating industry. Anguil`s experience leads directly to savings for our customers. Determining your solution begins by quantifying the problem with a thorough assessment of your emissions. Utilizing proven principles of design engineering, your system will evolve to incorporate air volume reduction...

    By Anguil Environmental Systems, Inc. based in Milwaukee, WISCONSIN (USA).

  • Air pollution control for the expanded polystyrene industry

    Removal of pentane and other VOCs from the molding and extruding process – commonly use regenerative thermal oxidizers (RTO) for air pollution control needs.

    By Catalytic Products International (CPI) based in Lake Zurich, ILLINOIS (USA).

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you