Only show results available in Virginia? Ok

air voc monitoring Applications

  • Premium

    Measurement solution for VOC emissions monitoring

    Protea has used our VOC gas analysers in many projects requiring the monitoring of complex mixes of VOCs. In the chemical and pharmaceutical industry, VOC abatement plants such as scrubbers and carbon-bed systems are typical installations where the use of Protea analysers and our VOC analysis expertise have proved valuable to plant operators. They prove a very powerful and flexible tool in both process gas measurements and VOC emissions monitoring. In the laboratory, Protea can deliver instruments with all the chemometric software and support to enable users to measure hundreds of gases.

    By Protea Limited based in Middlewich, UNITED KINGDOM.

  • Premium

    Low level measurement of VOCs and Terpenes close to the sea and the Landes Forest

    It has been established that organic aerosol (OA) makes up for a major fraction of fine particulate matter in all region of the atmosphere. This fraction accounts approximately for half of the total PM2.5 dry mass.1,2 Primary OA is directly emitted in the troposphere from anthropological and natural sources whereas secondary OA (SOA) is formed in-situ in the atmosphere from the oxidation of biogenic or anthropogenic gas-phase precursors and subsequent partitioning of the less volatile products into the particle phase. The current number is that, on a global scale, SOA would represent around 60% of the overall OA.3 However, recent global mass-balance estimations for the removal of volatile organic compounds (VOC) suggest that this number could under-predicts SOA production.4 Recent field measurements in urban locations are also in support of a larger share, indicating that SOA is the dominant fraction of OA, with amounts considerably 20 greater than models predictions.

    By Chromatotec Group based in Val de Virvée, FRANCE.

  • BREEAM Air Quality

    The sustainability and environmental impact of a new build house is typically assessed using BREEAM. Part of the BREEAM assessment method is determining the air quality inside the house. Gradko can supply a range of products for qualified BREEAM assessors. We try to work with qualified BREEAM assessors to determine and meet their requirements. The products we normally supply are used for monitoring formaldehye and VOC levels in new build properties.

    By Gradko International Ltd based in Winchester, UNITED KINGDOM.

  • Premium

    Measurement solution for complex, real-time VOC measurement with atmosFIR FTIR gas analyser platform

    Introduction

    Volatile organic compounds (VOCs) are a group of organic compounds which have a low vapour pressure at room temperature, meaning that they will readily evaporate into the surrounding air. The term VOC refers to many different classes of organic compounds such as alkanes, alkenes, alcohols, aldehydes, aromatics and many more.

    By Protea Limited based in Middlewich, UNITED KINGDOM.

  • Premium

    Low concentrations monitoring of benzene and aromatic hydrocarbons (BTEX) for pollution control and environmental monitoring

    With over 15 years of experience in the measurement of volatile organic compounds (VOC), Environment SA announces the VOC72M, a new generation analyzer for the measurement of BTEX compounds by gas chromatography with photo-ionization detector (PID). The VOC72M can handle up to 40 compounds and eight configurations for analysis. This compact and fully automated analyzer with wide voltage range specifications (90-240V) provides equivalent performance to the laboratory chromatographs and is particularly suited to fixe or mobile ambient air quality monitoring laboratories. The VOC72M is fitted with a PID detector new generation, much more sensitive, more stable and whose lamp does not need to be cleaned; the analyzer integrates flow control fittings a 3 levels security system built on and uses only one gas (nitrogen). This robust and low maintenance instrument performs all the functions (sampling, analysis and data management) in a simple and completely autonomous mode. It is a particular

    By Environnement S.A based in Poissy, FRANCE.

  • Air monitoring equipments for material emissions and product testing

    A wide variety of products that are used in our indoor environments may emit harmful substances, raising health and safety concerns in homes, offices, public places and vehicles. There is increasing demand to reduce VOC emissions from indoor sources, backed by European legislation. REACH regulation is a European initiative for the Registration, Evaluation, Authorisation and Restriction of Chemical Substances. It was implemented to protect human health and the environment from harmful emissions of chemicals into the air we breathe. The REACH regulation places the responsibility on manufacturers and importers to test their products and provide safety information to the purchaser, end user or consumers.

    By Gradko International Ltd based in Winchester, UNITED KINGDOM.

  • Premium

    PTR-MS systems for indoor air quality monitoring

    Room-air VOC detection and monitoring. Measurement of most common VOCs causing smells or health effects. Real-time monitoring of emissions related to the Sick Building Syndrome. Ozone induced reactions in aircraft cabins.

    By Ionicon Analytik Ges.m.b.H. based in Innsbruck, AUSTRIA.

  • Air monitoring equipments for soil contamination monitoring

    Previous land uses or accidental spills can result in Volatile Organic Compound (VOC) contamination of soils. Volatile and semi-volatile compounds can then permeate through the soil and may persist for several years. This contamination can be traced and measured using our Soil Probes in conjunction with our VOC sorbent tubes. Soil probes are also useful in checking the effectiveness of remediation actions. This monitoring technique provides a cost-effective identification of hazardous gases.

    By Gradko International Ltd based in Winchester, UNITED KINGDOM.

  • Premium

    Equipment

    Omnitec Design manufactures negative air machines, scrubbers, moisture extractors, heaters, pressure monitors, and water filtration equipment used by abatement and restoration contractors, health care facilities, in industrial and commercial applications and a wide range of environmental cleanup projects. Our equipment combines the best technologies available for HEPA air filtration, control of VOCs, odor and biological contaminants and heaters for structural drying and sanitizing. Our mission is to provide high quality and reliable filtration equipment. Our equipment is used for Abatement, Remediation, Construction and renovations, labs and healthcare facilities, and more. When you purchase our equipment you will receive not only a quality product, built in the USA, but also our customer service which is the best in the industry. By purchasing our filtration, dust collecting, and purifying equipment, to will receive from Omnitec our complete support. Breathe easy.

    By Omnitec Design, Inc. based in Mukilteo, WASHINGTON (USA).

  • Air and particule sampling for the oil and gas industries

    Ormantine offers a wide range of products and services to meet the array of different needs that arise in the oil and gas industries. Volatile Organic Compounds (VOCs), benzene, and other compounds are released during drilling, hydraulic fracturing (fracking) and other extraction procedures. Monitor NOx emissions from heavy duty equipment, particulate matter, and ground level ozone, the formation of which is contributed to by VOCs from processing, transportation, and storage of oil and gas.

    By Ormantine USA Ltd., Inc. based in Palm Bay, FLORIDA (USA).

  • Premium

    Infrared sources for environmental sector

    Axetris infrared sources are used in a variety of environmental applications: Heating, Ventilating and Air Conditioning (HVAC), Indoor Air Quality (IAQ) and VOC Monitoring, Air Quality Monitoring.

    By Axetris Ag based in Kaegiswil, SWITZERLAND.

  • Premium

    Abatement and Remediation

    Containment and safety issues are a critical consideration when working on any mold, asbestos, or lead remediation/abatement projects. Improperly contained, the dust and bio-contaminants released can, be very harmful for both on-site workers and occupants in neighboring areas. Exactly how you approach your containment and capture solutions will depend on the individual site’s risk assessment report. If you need help identifying solutions to the issues raised in the report, feel free to contact our customer service department and we can review your options together. In most cases, however, there are four common considerations that will be relevant: -Meeting Containment and Air Change Requirements -Monitoring of Containment Pressure -Sterilization of Filtered Air -Removal of Odors, Mold Spores, VOC’s and other Airborne Bio-Contaminates

    By Omnitec Design, Inc. based in Mukilteo, WASHINGTON (USA).

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you