Only show results available in Virginia? Ok

cable monitoring Applications

  • Wireless monitoring in EX areas

    The DX 99 battery operated remote IO unit allows to monitor sensors situated in EX areas (zone 0 and 20) whithout the need for costly and complicated cable runs. Thanks to elaborate power management, the radio unit can power the sensor from the battery (up to 19V for a warm up time of 1 min)

    By Banner Engineering Corp. based in Minneapolis, MINNESOTA (USA).

  • Premium

    Marine monitoring solutions for the SO2/CO2/NOx monitoring

    Process control of a SO2 scrubber on a ship is a challenge due to wet and corrosive gases. In such environment, extractive gas sampling systems require high levels of maintenance in order to operate correctly. OPSIS monitoring system solves this by using an optical, non-contact, cross-duct technique. A light beam is sent across the duct or stack to be measured, and the captured light is sent through an optical fibre cable to an analyser. The analyser measures SO2, CO2 and NOx concentrations using UV and IR...

    By Opsis AB based in Furulund, SWEDEN.

  • Temperature monitoring in a rotary kiln

    Taking measurements on rotating equipment, such as a kiln or rotary table, usually requires a complex and expensive system of cabling. Even taking precautions and using specialized equipment doesn’t eliminate cable tangles and breaks. The SureCross Wireless Network eliminates complexities associated with data acquisition from rotating and moving machinery such as a rotating kilns in cement or composting industry. Crucial temperature data is acquired using a thermocouple and transmitted from the FlexPowered...

    By Banner Engineering Corp. based in Minneapolis, MINNESOTA (USA).

  • Premium

    Fire detection solutions for the oil rigs

    The worse event that can befall on off shore oil rig is fire. The Model 125 is a smoke monitor designed to operate in hazardous areas, especially in oil rig air conditioning and ventilation ducts. The electronics are contained in an explosion proof container rated as EEX de II B T5; the sensing head uses fibre optic cables to transmit the near infra-red light to a reflector where it is returned to another fibre optic cable. The light level is then monitored by a photo-electric cell. The Model 125 gives an...

    By Codel International Ltd based in Bakewell, UNITED KINGDOM.

  • Water Pump Vibration Monitoring

    The water and wastewater industry uses a large number of pumps of all sizes and ratings, along with their associated driving motors, and they are often run continuously. Monitoring the health of their bearings using vibration sensors enables faults to be detected early, reducing unplanned maintenance shutdowns and supply interruptions.

    Typical locations where vibration sensors can be fitted include vertical pump upper and lower bearings, horizontal pump and compressor inner and outer bearings, and...

    By Monitran Ltd based in Penn, UNITED KINGDOM.

  • Patented Innovative Monitoring Technology for Bridges Industry

    SoundPrint is a patented innovative monitoring technology that can detect and locate failures in high-strength steel wire, strand or cable through continuous, non-intrusive remote monitoring.

    By Pure Technologies - a Xylem brand based in Calgary, ALBERTA (CANADA).

  • Patented Innovative Monitoring Technology for Buildings & Structures Industry

    SoundPrint is a patented innovative monitoring technology that can detect and locate failures in high-strength steel wire, strand, or cable through continuous, non-intrusive remote monitoring.

    By Pure Technologies - a Xylem brand based in Calgary, ALBERTA (CANADA).

  • PEHD membrane sealing systems for retrofitting in existing landfill site

    It is also possible to retrofit a monitoring system in existing surface sealing liners without impairing the synthetic liner sheet or the immediately adjacent functional layers. For this purpose, cable trenches must be dug in the recultivation layer above the drainage layer. The detection cables are then laid in these trenches.

    By ELD Environmental Leak Detection GmbH based in Berlin, GERMANY.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you