Only show results in Virginia? Ok

coal gas Applications

  • Premium

    Methane Sensing for Coal Mining

    Application: The majority (around 60%) of the coal seams currently being extracted worldwide are so far underground that open cast mining cannot take place and, therefore, underground mining techniques need to be used. Consequently, workers have to enter and work in confined spaces. One of the major problems that this creates is the dangers from Methane (CH4) gas which occurs in Mine gas.

    By Edinburgh Instruments Ltd based in Livingston, UNITED KINGDOM.

  • Premium

    CO gas monitoring for coal pulverising mills

    Our range of safety analysers can offer early detection of fire / explosive conditions. From CO monitors for pulverising coal mills through to UV flame and smoke detectors installed on oil rigs and the cross-channel passenger shuttles, operated by Eurotunnel.

    By Codel International Ltd based in Bakewell, UNITED KINGDOM.

  • Electrostatic Precipitator

    An electrostatic precipitator (ESP), or electrostatic air cleaner is a particulate collection device that removes particles from a flowing gas (such as air) using the force of an induced electrostatic charge. Electrostatic precipitators are highly efficient filtration devices that minimally impede the flow of gases through the device, and can easily remove fine particulate matter such as dust and smoke from the air stream.[1] In contrast to wet scrubbers which apply energy directly to the flowing fluid medium, an ESP applies energy only to the particulate matter being collected and therefore is very efficient in its consumption of energy (in the form of electricity).

    By MEVADHASHMA based in Coimbatore, INDIA.

  • Coal Combustion Residuals Disposal for Power Plants

    Coal combustion residuals (CCR) are generated during the power generation process and can include fly ash, bottom ash, boilerslag, and flue gas desulfurization (FGD) residuals. CCRs contain trace concentrations of heavy metals and therefore cannot be dumped or stored where rainwater can leach the metals. Liner systems can be used to contain the coal combustion by-products and protect them from leaching into the environment.

    By CETCO based in Hoffman Estates, ILLINOIS (USA).

  • Power Plant Coal Fired Boiler Filtration

    Dust filter PPS Filter Bags For Coal Fired Boiler Gas Filtration.

    By Zhejiang Grace Envirotech Co., Ltd based in XIAOSHAN, CHINA.

  • Low emissions auxiliary boilers to coal or otherwise fired power plants

    Whether providing high-efficiency, low emissions auxiliary boilers to coal or otherwise fired power plants across the United States, or heat recovery steam generators to natural gas fired turbine plants you will find Superior Boilers serving the needs of power generation customers for years to come.

    By Superior Boiler Works, Inc. based in Hutchinson, KANSAS (USA).

  • Premium

    Gas Sensing for Gasification

    Syngas (short for synthetic gas) can be burnt and used as a fuel source, the main constituents of syngas are Carbon Monoxide (CO) and Hydrogen (H), which amount for around 85% of Syngas, and it is produced by a process called Gasification. Gasification starts with a base material which can originate from a wide variety of materials for example wood chips and pellets, plastics, municipal solid waste, sewage, waste crops, and fossil fuels such as coal. During Gasification the base material is reacted at high temperature without combustion with controlled amounts of oxygen (O) or steam. The composition of the base material combined with the amount of oxygen and heat used in the process affects the composition of the resultant SynGas, in which the CO can vary between around 20 and 60%. In addition, large amounts of H and CO are also formed. The measurement of CO is therefore an important feature in the production of SynGas.

    By Edinburgh Instruments Ltd based in Livingston, UNITED KINGDOM.

  • Premium

    Gas monitoring and dust monitoring for the powerplants industry

    LaserGas measurements

    • Boiler combustion control, O2 and CO
    • DeNOx system, NH3 and NO
    • Electrostatic precipitators (ESP), CO monitoring for explosion prevention
    • Stack gas emissions, NH3, H2O, NO
    • Coal silos, CO monitoring for explosion prevention and detection of smouldering fires (only in coal fired plants)

    LaserDust measurements

    • Stack gas emission
    • Coal silo, explosion prevention

    By NEO Monitors AS based in Skedsmokorset, NORWAY.

  • Premium

    Fly Ash - Industrial Vacuum

    Fly Ash can cause many problems. The Vac-Con & Vector Pneumatic Vacuum systems can assist and solve many of these problems. Our high-performance vacuum systems are manufactured in three basic configurations: Truck mounted, Trailer mounted, and Fixed/static installed. Any of these systems can be integrated into the existing power plant design. All of our vacuum systems can be utilized to solve your plant’s fly ash removal/clean-up needs and can assist in many other maintenance projects. All can be tailored to fit into your power plant’s specific needs. Vac-Con Truck mounted Industrial vacuum systems are equipped with large storage debris tanks with self-cleaning intake filter systems. The Industrial Trucks vacuum the waste products through existing manifold piping or with hoses attached directly to the debris tank. When fully loaded, the truck can then drive directly to the disposal site and discharge the waste products. The Industrial Truck offers a great amount of flexibility of operation and can be utilized anywhere in your facility for many different types of normal and emergency maintenance operations. The Vac-Con Industrial Vacuum Truck can be utilized on both wet and dry materials. The same Vac-Con truck can be used for removing Fly Ash from your plant, coal from broken intake belt conveyors, or used to suck wet muddy material from storage lagoons. The Vector Trailer mounted Vacuum Systems are designed to be used in several locations around power plants. The Trailer mounted Vacuum Systems connect to Manifold piping located in key areas within your power plant. The Vacuum systems move the waste products from the plant and deposit these products into moveable storage containers. The loaded storage containers when full can then be moved to the disposal sites for discharge. Vector Static Mounted Vacuum systems are designed to vacuum and remove Fly Ash and other bulk waste products through manifold piping from operational areas of the plant and deposit these waste products into collection storage silos for later transport to disposal sites. The fixed vacuum systems are electric motor driven and are normally installed as a permanent addition to in-plant existing conveying systems. Please contact us with any requirements you may have. We will evaluate your request and respond with solutions specific to solve your problems and fit your needs.

    By Vac-Con, Inc. based in Green Cove Springs, FLORIDA (USA).

  • Premium

    High quality gas sensor solutions for mining

    Fast, accurate and reliable measurement of CH4. The extraction of coal releases methane gas, which can mix with the air in a mine to form a hazard due to its flammability. Ventilation with fresh air from the surface is used to dilute the methane and reduce the risk of explosion. Monitoring of the methane content of the stale air exiting the mine allows the amount of ventilation to be controlled. Although our sensors are not ATEX approved for use in potentially explosive atmospheres they are suitable for monitoring air containing methane concentrations below the lower explosive limit. Our OEM products can be built into equipment which is approved for use in the monitoring of mine exhaust gas and similar applications.

    By Edinburgh Instruments Ltd based in Livingston, UNITED KINGDOM.

  • Premium

    Agitation and mixing solutions for flue gas desulfurization

    FGD (Flue Gas Desulfurization) involves the treatment of flue gas from coal fired power plants.  The main goal is to remove sulfur, particulates, and other chemicals such as mercury from the flue gas prior to environmental release.  Governmental regulations by the EPA put limits on the amount of impurities which can be released into the air.   The use of mixers to clean and scrub the flue gas is utilized to help power companies meet permitted limits on the release of controlled substances.

    By National Oilwell Varco based in Dayton, OHIO (USA).

  • Premium

    Single Gas Monitoring - Fixed in-situ Duct Path

    Application: Measurements of single gas species through a fixed in-situ duct path. Example: Monitoring NH3 emissions in coal fired power generating stations.

    By Boreal Laser Inc. based in Edmonton, ALBERTA (CANADA).

  • Premium

    Gas monitoring and dust monitoring for the cement industry

    LaserGas measurements

    • Preheater exit, CO monitoring
    • Electrostatic precipitators (ESP) after pre-heaters, CO monitoring for explosion prevention
    • Coal silo, CO monitoring
    • Exit of coal mill, dust filter, CO monitoring
    • Stack gas emissions, HCl and HF

    LaserDust measurements

    • Stack gas emissions
    • Coal silo, explosion prevention

    By NEO Monitors AS based in Skedsmokorset, NORWAY.

  • Gas monitoring and dust monitoring

    Laser gas instruments Pulverized coal bunker, Exit of preheater, Main emission chimney, Cooler,exhaust emission chimney, O2, CO, CO2

    By HANGZHOU ZETIAN TECHNOLOGY CO., LTD based in Hangzhou, CHINA.

  • Premium

    Gas Detection Solutions for Power Generation Industry

    Boreal possess an array of products for the power generation industry from emissions stack monitoring, boiler room monitoring, chloride leak detection, and ammonia slip in deNOX. Boreal’s products are tailor made for coal fired power plants, natural gas fired, and waste-to-energy. Whether gas detection is used for safety, process, or environmental reasons, Boreal has you covered.

    By Boreal Laser Inc. based in Edmonton, ALBERTA (CANADA).

  • Gas monitoring during industrial process

    EM-5 CEMS Coal power plant: Entrance of SCR denitration device, NOx O2 Exit of SCR denitration device: Measure remanet NH3 after reaction and avoid blocking by crystallization, NH3; Calculate denitrification rate with Nox input, NOx O2 Gas-fired power plant: Counting tail gas emission and realtime concentration, NOx O2 SO2 Temperature pressure flow dust

    By HANGZHOU ZETIAN TECHNOLOGY CO., LTD based in Hangzhou, CHINA.

  • Material handling equipment for mining (except oil and gas) industry

    Coal Mining, Bituminous Coal and Lignite Surface Mining, Bituminous Coal Underground Mining, Anthracite Mining, Metal Ore Mining, Iron Ore Mining, Gold Ore and Silver Ore Mining, Copper, Nickel, Lead, and Zinc Mining, Uranium-Radium-Vanadium Ore Mining, Stone Mining and Quarrying, Crushed and Broken Limestone Mining nd Quarrying, Crushed and Broken Granite Mining and Quarrying, Sand, Gravel, Clay, and Ceramic and Refractory Minerals Mining and Quarrying, Construction Sand and Gravel Mining, Industrial Sand Mining, Clay and Ceramic and Refractory Minerals Mining, Nonmetallic Mineral Mining and Quarrying, Potash, Soda, and Borate Mineral Mining, Phosphate Rock Mining, Chemical and Fertilizer Mineral Mining.

    By TerraSource Global based in St. Louis, MISSOURI (USA).

  • energy conservation

    Liquid catalyst saving consumption of fuel sources like coal, liquid gas, bio fuel,etc

    By Energix Solutions based in jhb, SOUTH AFRICA.

  • Premium

    Applications and Air Pollutants Removed for Mineral Products Industry

    Removal of acid gases and particulate from cement, brick and other product kilns. Mineral product dryers including coal. Hot mix asphalt plant particulate control. Sulfur dioxide and hydrochloric acid gas removal.

    By Bionomic Industries Inc. based in Mahwah, NEW JERSEY (USA).

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you