Only show results in Virginia? Ok

contamination monitor Applications

  • Air monitoring equipments for soil contamination monitoring

    Previous land uses or accidental spills can result in Volatile Organic Compound (VOC) contamination of soils. Volatile and semi-volatile compounds can then permeate through the soil and may persist for several years. This contamination can be traced and measured using our Soil Probes in conjunction with our VOC sorbent tubes. Soil probes are also useful in checking the effectiveness of remediation actions. This monitoring technique provides a cost-effective identification of hazardous gases.

    By Gradko International Ltd based in Winchester, UNITED KINGDOM.

  • Premium

    Monitoring solutions for the opacity and dust monitoring

    There is a requirement for many small boiler operators to monitor Opacity to determine the smoke density emitted from the boiler. On small boilers we recommend the DCEM 1001 Opacity monitor; this simple, low cost monitor   has high efficiency air purges use compressed air to ensure that optical surfaces are virtually free of dust or debris contamination. This ensures minimal maintenance is required on the sensors.

    By Codel International Ltd based in Bakewell, UNITED KINGDOM.

  • Environmental Monitoring

    Environmental monitoring is becoming more important every day in local, national and international policies, showing the environmental awareness demanded by society.

    This fact gives rise to an increase in the amount of legislation that obliges companies to law enforcement. Thus, the necessity of making more pollutants controls means high analysis expenses to the companies, which need to subcontract this service.

    Although applications in this area advance, there is still a clear demand to get new...

    By MicruX Technologies based in Oviedo, SPAIN.

  • Premium

    Meteorological sensors for solar monitoring

    The most important measurement parameter is irradiation. Since PV systems are becoming ever larger, the accuracy of the irradiation measurement is increasingly important for the efficiency of the system. Wind cools the temperature of the module and must therefore be included in the efficiency calculation. Precipitation leads to contamination or covering (snow). With increasing temperature, the performance of the solar module decreases. Therefore, it is important to measure the temperature of the solar...

    By G. Lufft Mess- und Regeltechnik GmbH based in Fellbach, GERMANY.

  • Premium

    Continuous emissions monitoring for mercury monitoring

    Waste incinerators, cement plants and power plants need good and reliable measurements of total gaseous mercury. The measurement of total gaseous mercury is a challenge due to chemical reactions and contamination. The installed systems will often require a lot of maintanence still not giving reliable results.

    By Opsis AB based in Furulund, SWEDEN.

  • Water Contamination Detection

    Security of water assets is becoming an increasingly major issue that demands immediate and robust alarms for potential contamination. In addition to this, natural growth of algae is a common problem for water asset managers, the results of which can increase maintenance costs of water processing plants as well as directly effecting water taste. The CTG FastGuard fast repetition rate fluorometer analyses information on the physiological state of the algae it monitors within an in-line flow system. A number of...

    By Chelsea Technologies Group based in West Molesey, UNITED KINGDOM.

  • Gas analysis & monitoring systems for medical gases monitoring

    The measurement of occupational exposure to pollutants in the operating room is an essential tool for the detection of chemical, linked not only to the occurrence of infections and various diseases, but also to reduced alertness and performance of staff. To meet the above requirements, ETG proposes the use of ‘INFRARUN, thanks to the high sensitivity and stability and the very wide dynamic range, INFRARUN is the ideal tool to make a continuous sampling in the short and long-term gaseous contaminants in...

    By ETG Risorse e Tecnologia S.r.l. based in Montiglio, ITALY.

  • Real-time In-situ Effluent Monitoring

    The UviLux BOD Indicator enables in-situ, real-time, reporting of BOD within both natural water systems and water processing plants. The monitor detects fluorescent proteins that are inherent within sewage and slurry and provides an output in BOD equivalent units. The principle behind the measurement is the excitation of Tryptophan-like fluorescence within UV wavelength band, which has been shown to correlate with both BOD and bacterial contamination. With complete flexibility of deployment methodology, the...

    By Chelsea Technologies Group based in West Molesey, UNITED KINGDOM.

  • Premium

    Mercury monitoring for mercury flux measurement

    The Tekran 2537 has been used in numerous published studies to measure the deposition or evasion of mercury from natural or contaminated surfaces (i.e. flux measurements). It is anticipated that many mercury flux measurements will be needed in the future to assess the impact of climate change on mercury cycling in the environment. There are two basic ways to do mercury flux measurements. First, the dynamic flux chamber method utilizes a custom enclosure, with controlled air flow, to measure the...

    By Tekran Instruments Corporation based in Toronto, ONTARIO (CANADA).

  • Drinking water solutions for the nitrate monitoring

    Problem: Nitrate, the most stable form of nitrogen in water, is found in both ground and surface water and originates from both natural and anthropogenic sources. Due to its high solubility in water, nitrate is not filtered out from groundwater like other contaminants. Removing nitrates from source water is important as elevated levels in drinking water can cause serious health effects when ingested.

    By Real Tech Inc. based in Whitby, ONTARIO (CANADA).

  • Premium

    Measurement of hydrogen sulfide & carbon disulfide in air for continous emission monitoring

    The Series 8900 Hydrogen Sulfide and Carbon Disulfide Analyzer provides direct measurement of H2S and CS2 in ambient air. This instrument is utilized for continuous emission monitoring. The Series 8900 H2S and CS2 Analyzer employs a Photoionization detector (PID) as the sensing element. A dual column configuration with timed backflush to vent is used to strip off moisture and heavier hydrocarbons. A pre-cut column is used in series with the analytical column. At sample injection a fixed volume of sample is...

    By AMETEK MOCON - Baseline based in Lyons, COLORADO (USA).

  • Chromatography systems for environmental monitoring

    With the growth of contamination generated from agricultural and industrial production, it causes a threat to the enviroment including drinking water, atmosphere and soil. The chemists have always seeked out the effective analytical methods to detect and identify chemical contaminants. Dikma provides innovative products and application solutions according to government regulations and industry standards, for air and water quality monitoring, gas detection.

    By Dikma Technologies Inc. based in Lake Forest, CALIFORNIA (USA).

  • Contaminant Site Investigation Applications

    Characterization of contaminated groundwater requires detailed monitoring to eliminate data gaps, improve predictive numerical models, and track remedial efforts. The Westbay System is a reliable, cost-effective technology for obtaining detailed information, enabling groundwater professionals to carry out comprehensive and defensible contaminant site investigations and long-term monitoring.

    By Westbay Instruments based in Burnaby, BRITISH COLUMBIA (CANADA).

  • Premium

    Waste water treatment plants Air quality control by TRS MEDOR Online Odor Monitoring

    ontext & Challenges Globally, the wastewater treatment is the first public health issue. Urban development leads to urbanization near waste water treatment plant and extension of sewerage network. These aspects induce to an augmentation of sulfur compounds (H2S, mercaptans and sulfides) which are very corrosive, odorant and toxic. To monitor this compounds online CHROMATOTEC® offers high meteorological solutions. Odors are very distinct air contaminants as they generate nuisances. The factors playing a...

    By Chromatotec Group based in Val de Virvée, FRANCE.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you