Only show results in Massachusetts? Ok

cooling tower Applications

  • Premium

    Hand-Held & process control water testing instrument for Boilers and cooling towers

    Boilers and cooling towers share two major water related problems: deposits and corrosion. As steam is generated by a boiler or water evaporating from a cooling tower, dissolved minerals are left behind, increasing the concentration of these minerals. Additional minerals are introduced via the water added to makeup the water lost to steam/evaporation. Eventually, the minerals reach a level (or cycle) of concentration that will cause either loss of efficiency due to scale or damage from corrosion. This level can...

    By Myron L Company based in Carlsbad, CALIFORNIA (USA).

  • Biofilm effect on Cooling Towers for Industrial Purpose

    Cooling towers are used widely in the industry for cooling down a process, there exist many version or types of cooling towers, and each designed with its advantages for the process. The generic term "cooling tower" is used to describe both direct (open circuit) and indirect (closed circuit) heat rejection equipment. While most think of a "cooling tower" as an open direct contact heat rejection device, the indirect cooling tower, sometimes referred to as a "closed circuit cooling tower" is nonetheless also a...

    By Danish Clean Water A/S based in Sønderborg, DENMARK.

  • Industrial filtration & separation solutions for the cooling tower water industry

    Cooling Tower Water.

    By Filtra Systems based in Farmington Hills, MICHIGAN (USA).

  • Premium

    Water treatment solutions for industrial water & wastewater treatment industry

    Cooling tower. RO System. Biofilm, Air Scrubbers, Air Washers. Gas Scrubbers for H2S.

    By Jenfitch, LLC based in Walnut Creek, CALIFORNIA (USA).

  • Premium

    Fiber reinforced polymer solutions for cooling tower industry

    With superior strength and corrosion resistance, DuroSpan casing panels from Enduro Composites offer longer service life and span capability when compared to alternatives.

    By Enduro Composites based in Houston, TEXAS (USA).

  • Cooling tower water treatment

    The fresh water requirement for a cooling tower in a typical coal-based power plant is approximately 80% of the total consumption of water. These concentrated cooling water blowdown streams are extremely rich in silica, are characterized by higher hardness levels and include other organic loads. Aquatech has vast experience in recycle/reuse solutions for cooling tower blowdown and cooling tower water treatment.

    By Aquatech International Corporation based in Canonsburg, PENNSYLVANIA (USA).

  • Water treatment for cooling towers

    Controlling and preventing the growth of microorganisms in a cooling tower is extremely important and required to keep the system running at optimal levels. The presence of microorganisms will cause the system to breakdown and decreases the efficiency of the heat transfer. Typically oxidizing biocides such as chlorine and bromine have been used to treat cooling water. Unfortunately these chemicals are highly reactive with other chemicals and microbiological species found in the water. Chlorine dioxide however is...

    By Applied Oxidation LLC based in Chattanooga, TENNESSEE (USA).

  • Premium

    Industrial solutions for cooling tower, boiler feed pretreatment

    Cold Lime Softening: Hard water is water that has high mineral content. The name comes from the hard scale that forms when this water is boiled. It is not harmful to human health, but in the industrial setting it causes costly breakdowns in boilers, cooling towers, and other water handling equipment. The divalent cations Mg and Ca are the most frequently found minerals causing hard water. These ions enter water supplies by leaching from minerals in underground aquifers.

    By WesTech Engineering, Inc. based in Salt Lake City, UTAH (USA).

  • Cooling Tower, algae and biofilm control

    “Efficiently lowers algae, biofilm formation, bacterial counts and chemical consumption.” When temperatures are high, for example in cooling towers, a matrix of different microorganisms such as bacteria, fungi, EPS and algae can grow very rapidly. The disadvantages of biofilm formation in cooling towers can be enormous. Therefore water used in cooling towers needs frequent treatment and chemical shocks to keep levels of micro-organisms to a minimum.

    By LG Sonic based in Zoetermeer, NETHERLANDS.

  • Premium

    Industrial solutions for power and cogeneration industry

    WesTech engineers water and wastewater process solutions for the power industry including water pretreatment, cooling tower makeup water treatment, and ultrafiltration pretreatment to reverse osmosis, guaranteeing SDIs less than 3. ISO 9001:2008 certified and turnkey experienced, WesTech stands ready to meet deadlines and assure minimal downtime with focused service.

    By WesTech Engineering, Inc. based in Salt Lake City, UTAH (USA).

  • HVAC and Cooling Filtration

    Water from cooling towers attracts and absorbs airborne contaminants on a continuous basis. Typically, 85% of suspended solids in cooling water and hot water loops are smaller than 5 microns. Scientific studies have shown that these small particles (5 microns and less) are the adherent contaminants fouling cooling tower water, chilled water and heat exchangers, thereby reducing your cooling system efficiency.

    By Vortisand - a brand by Evoqua Water Technologies LLC based in St-Laurent, QUEBEC (CANADA).

  • Premium

    Water and wastewater treatment solutions for power generation sector

    No energy without the engineering and excellence of Enexio. The overall efficiency of thermal power generation (called “Carnot cycle”) inherently depends on the „cold-end” of the cycle, where the waste heat is dissipated by the heat sink: The cooling system of the power plant. This actually is the part of a power plant where ENEXIO supports its customers and partners with its rich product portfolio ranges from all dry air cooled condensers (ACC) and Heller Technologies to all wet cooling...

    By ENEXIO Water Technologies GmbH based in Hürth, GERMANY.

  • Water treatment solutions for industrial water treatment industry

    Boilers, heat exchangers, cooling towers, chillers, evaporative condensers, injection molding machines, annealing furnaces, reverse osmosis systems.

    By Superior Manufacturing Corporation based in Fort Wayne, INDIANA (USA).

  • Algae control in cooling towers

    Lower biofouling formation, bacterial counts, and chemical consumption in cooling towers with ultrasound. Prevent biofouling growth. Reduce chemical dosage. Reduce the risk of spreading legionella.

    By LG Sonic based in Zoetermeer, NETHERLANDS.

  • DOCUPAK LLC REDUCES COOLING TOWER CHEMICAL USAGE BY A THIRD

    Docupak LLC, a full service marketing company headquartered in Alabaster, Alabama, has reduced chemical usage by a third and removed all scale from its cooling tower at its plant after installing the patented, award-winning Scalewatcher computerized, electronic water-conditioner from Scalewatcher North America. In addition there are no longer signs of algae growth on the cooling tower louvres. Founded in 1998, Docupak, the operating name of Document and Packaging Brokers Inc., develops and distributes materials...

    By Scalewatcher North America Inc. based in Oxford, PENNSYLVANIA (USA).

  • Premium

    Emission control solutions for steel and ferroalloys sector

    Steel and ferroalloysmanufacturing processes involve high temperature exhaust streams, often at more than 900ºC. Typically, the gas flows from the furnace (usually electric arch type) and goes into a gas conditioning tower to cool down below 200ºC so that it can be treated by a Bag Filter. It`s also common to have ESP´s as end dedusters that can be preceded by a multicyclone serving as pre-separators.

    By Advanced Cyclone Systems, S. A. based in Porto, PORTUGAL.

  • Cooling & Drinkingwater: ATP monitoring of biomass growth in waters

    Monitoring Biomass in (Cooling Tower) Waters through ATP monitoring The TOXcontrol can be used for ATP monitoring. Currently our company is doing research for further developments for this application on the TOXcontrol. Monitoring the microbial population of cooling towers is necessary in order to maintain the proper operation of the system. Conventional methods for monitoring microbial populations work by culturing microorganisms, a time-consuming procedure that requires days or even weeks of incubation before...

    By microLAN B.V. - Aqualabo Group based in Waalwijk, NETHERLANDS.

  • Chlorine dioxide for industrial water treatment

    Chlorine dioxide is used as a biocide in many industrial water treatment applications including cooling towers, process water and mill water. Its selective oxidative properties usually results in lower dosages of ClO2 while also achieving improved microbial performance.

    By DuPont Chlorine Dioxide based in North Kingstown,, RHODE ISLAND (USA).

  • Controlled Hydrodynamic Cavitation Technology for HVAC

    A college operates four chillers with a cooling capacity of 1,600 tons. The cooling water system includes four individual cooling towers with a total water volume of 14,000 gallons. Scale and deposits became a serious issue under chemical treatment, and local effluent discharge regulations were requiring the water treatment system to be environmentally friendly.

    By Vortex CHC based in San Antonio, TEXAS (USA).

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you