Only show results available in Virginia? Ok

dust monitor manufacturer Applications

  • Dust monitoring of exhaust gases from manufacturing processes

    DynOptic dust monitors use the innovative Dynamic Detection Principle (DDP) to measure dust and particulate within exhaust gases from various manufacturing processes. DDP, or optical scintillation as it sometimes referred to, measures the dynamic fluctuation in light transmission as dust particles move through a light beam. This dynamic fluctuation derives from temporal distributions of the dust particles which attenuate the light beam. The more dust present in the exhaust, the greater the amplitude of these fluctuations. DDP instruments calculate the dynamic response, or the ratio of light variation to light intensity, which for particular applications, is proportional to dust concentration and when calibrated against standard reference measurements, this can be presented as a reading in mg/m³.

    By DynOptic Systems Ltd based in Brackley, UNITED KINGDOM.

  • Premium

    Gas analysis & monitoring system for semiconductor

    The Cleanroom is a combined laboratory chemical, mechanical and / or electronic whose main characteristic is the presence of very pure air, that is a very low content of fine dust in suspension. In the process of semiconductor production, the airborne particles (micro-powder) go to irreparably damage the micro-photoetched that form the chip, creating an electronic circuit defective, and then discarded. This process has forced the improvement of industrial production environments, removing particles from the air, for two purposes: to increase the efficiency of production, increasing the yield of quality, and requirement of the manufacturer (of course based on the demand of the market) in shrink increasing the area of etching of semiconductors (just think of the USB storage media in a few years, went from 16 MB to 16 GB without changing the external dimensions).

    By ETG Risorse e Tecnologia based in Montiglio, ITALY.

  • Premium

    Equipment

    Omnitec Design manufactures negative air machines, scrubbers, moisture extractors, heaters, pressure monitors, and water filtration equipment used by abatement and restoration contractors, health care facilities, in industrial and commercial applications and a wide range of environmental cleanup projects. Our equipment combines the best technologies available for HEPA air filtration, control of VOCs, odor and biological contaminants and heaters for structural drying and sanitizing. Our mission is to provide high quality and reliable filtration equipment. Our equipment is used for Abatement, Remediation, Construction and renovations, labs and healthcare facilities, and more. When you purchase our equipment you will receive not only a quality product, built in the USA, but also our customer service which is the best in the industry. By purchasing our filtration, dust collecting, and purifying equipment, to will receive from Omnitec our complete support. Breathe easy.

    By Omnitec Design, Inc. based in Mukilteo, WASHINGTON (USA).

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you