emissions data Applications
-
Premium
Flame Photometer for Measurement of Calcium in Fresh Fruit
In most cases, it was found that flame photometry was well suited for the determination of sodium, potassium and calcium in fresh fruits, using the wet ashing technique as given below. There are significant differences in the composition between different varieties of the same fruit, although these differences are not usually considered to be nutritionally ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Flame Photometer for Measurement of Trace Elements in Biodiesel
These methods are adapted from methods for the determination of sodium and potassium in fatty-acid methyl ester samples. The sample is diluted with an organic solvent (xylene, cyclohexane or petroleum ether) plus a stabiliser. The calibration standards which have a similar matrix to the prepared sample solutions, are prepared from sodium and potassium organometallic salts which are dissolved in a solution of xylene with a stabiliser. These European Standards specify a method for the determination of potassium of ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Flame Photometer for Salinity in Processed Foods
Sodium chloride is an essential ingredient of all processed foods; it is needed to enhance flavour and increase shelf life. In many processed foods, additional sodium is added as a flavour enhancer; potassium and calcium are also naturally present but not normally used as processing ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Flame Photometer for Measurement of Sodium and Potassium in Dried Milk
Dried milk was dissolved into an aqueous solution for analysis via flame photometry. The test solutions and reference solutions are measured directly following dilution with deionised distilled ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Flame Photometer for Measurement of Potassium and Sodium in Bread
Bread contributes about one-sixth of daily salt intake and is used to improve flavour and texture. The amount of sodium in bread can differ significantly, depending upon brand and type of grain used, ranging from 592mg/100g to 748mg/100g. The level of sodium in bread is primarily due to the amount of salt added to the dough during manufacture. The amount of potassium is determined by the type of flour and the washing and bleaching operations during cereal processing. Bread does not make a significant contribution ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Air pollution, emission and process monitoring systems for incineration
proportion of overall costs, therefore, quality data from emissions and process monitoring provides ...
By ENVEA based in Poissy, FRANCE.
-
Premium
Flame Photometer for Measurement of Low Concentrations of Sodium in Cement
This method allows the direct measurement of low levels of sodium without prior extraction procedures, which minimises possible sources of contamination. ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Fence-Line Monitoring of Fugitive Emissions
emissions and gas leaks at industrial sites. By arranging monitoring paths strategically at ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
Flame Photometer for Measurement of Lithium Sea Water
The effect of potential interference from other constituents of sea water was studied, including sodium, chloride and potassium. It was found that pre-concentration of the sea water was not necessary prior to analysis. A filtration of the sample was only necessary if sample contained suspended material. ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Flame Photometer for Determination of Sodium in Biodiesel by Flame Atomic
This method allows the analyte to be pre-concentrated in the final solution, decreases the volume of strong acid used in the dissolution stage and does not use organic ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Flame Photometer for Measurement of Na, K and Ca in Plant Extracts
The most important ions which naturally occur in plant tissues are sodium, potassium, calcium, magnesium, nitrate, sulphate and phosphate. A sample of 5 g of oven-dried plant material contains on average, 25 mg calcium, 9 mg magnesium, 80 mg potassium and 3 mg sodium. The recommended method for the measurement of calcium is to precipitate the calcium as an oxalate, the precipitate is then dissolved and measurement taken from the resulting solution. Sodium and potassium may be measured directly following an ashing ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Flame Photometer for Determination of Na in Biodiesel using Dry Decomposition for Sample Preparation
The sample of biodiesel is weighed into a crucible and placed in a heating muffle furnace. Two temperatures are used in the heating program for the dry decomposition: the first temperature (250ºC) is maintained for 1 hour to dry the sample. After this the temperature is progressively elevated to 600ºC and maintained for 4 hours to eliminate the remaining organic material. ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Flame Photometer for Recommended Sample Handling Techniques & Considerations
Preparation of Glassware: Thoroughly clean and rinse all glassware with the supplied BWB Technologies deionised distilled water to ensure that it is clean and free of extractable sodium and potassium. Glassware should be acid cleaned and rinsed thoroughly in deionised double distilled water prior to use to avoid contamination from extractable metals under ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Flame Photometer for Measurement of Potassium and Sodium in Wine
Wine is of particular interest nutritionally because it is typically low in sodium and relatively high in potassium. Sodium is the predominant cation in breakfast cereals, at levels reaching 8mg/g. Potassium and calcium also vary, particularly in wheat-based products and those enriched with milk products or calcium ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Carbon footprinting calculations for environmental management
With its expertise in calculating and managing emissions data, CERC offers a range of ...
By Cambridge Environmental Research Consultants (CERC) based in Cambridge, UNITED KINGDOM.
-
Premium
Waste Incineration Application Note
the continuous data required to ensure complete burn-up of the waste materials and minimise regulated ...
By AMETEK Land Instruments International Ltd based in Dronfield, UNITED KINGDOM.
-
Data Acquisition and Control
Many companies worry over the quality of emissions data reported to the EPA. CEMS ...
By CEMS Experts - a division of GK Associates, Inc. based in Moopark, CALIFORNIA (USA).
-
Gas Detection Solutions for GHG Monitoring
, open path area or perimeter monitoring provides more meaningful fugitive emissions data than an ...
By Boreal Laser Inc. based in Edmonton, ALBERTA (CANADA).
-
VOC abatement equipments for data center & telecom cooling
seeking solutions that reduce energy consumption and carbon emissions associated with data ...
By Munters based in Amesbury, MASSACHUSETTS (USA).
-
Marine And Offshore Emissions Monitoring & Analysis
industries. Fuels and exhaust gas emissions are subject to international, regional and national ...
By Procal - Parker Hannifin Corp based in Peterborough, UNITED KINGDOM.
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you