Only show results available in Virginia? Ok

emissions measurement system Applications

  • Premium

    Gas monitoring instruments and systems for engine emissions measurements

    The exhaust gas from combustion engines is a complex mixture of gases and particulate matter. The composition of the gas may change rapidly. Multicomponent analysis of exhaust gases can be performed with a Gasmet™ FTIR Gas Analyzer with a response time (T90) of one second. The winning combination is the result using of a small volume gas sample cell, a powerful sample pump and a fast detector with liquid nitrogen cooling. The analyzer, sampling system and computer can be assembled on a cart for use in a dynamometer laboratory, or the portable version can be used for roadside tests.

    By Gasmet Technologies Oy based in Helsinki, FINLAND.

  • Measurement solution for VOC emissions monitoring

    Protea has used our VOC gas analysers in many projects requiring the monitoring of complex mixes of VOCs. In the chemical and pharmaceutical industry, VOC abatement plants such as scrubbers and carbon-bed systems are typical installations where the use of Protea analysers and our VOC analysis expertise have proved valuable to plant operators. They prove a very powerful and flexible tool in both process gas measurements and VOC emissions monitoring. In the laboratory, Protea can deliver instruments with all the chemometric software and support to enable users to measure hundreds of gases.

    By Protea Limited based in Middlewich, UNITED KINGDOM.

  • Emissions testing for engines

    Rich-burn engine exhaust, when uncontrolled, can have wide concentration ranges and both CO and NOX can fluctuate significantly. The on-board CO dilution system will automatically set-up for optimum testing, perfect for a rich burn engine. Lean-burn engines have different exhaust characteristics, but NO2 can make up a significant portion of the total NOX measurement. The 350 measures both NO and NO2 for proper lean-burn engine set-up. Due to high concentration, replaceable interference filters keep the sensors stable and your readings accurate. High exhaust pressures and heavy particulate loading are easily controlled with the special pressure relief valve (standard) on the engine probe configuration.

    By Testo Inc. based in Sparta, NEW JERSEY (USA).

  • Premium

    PTR-TOFMS systems for Flux Measurement of BVOCs

    The ultra-fast analysis capabilities of IONICON PTR-TOF instruments are essential for eddy covariance flux measurements, allowing to study deposition and emission rates of biogenic volatile organic compounds (BVOCs).

    By Ionicon Analytik Ges.m.b.H. based in Innsbruck, AUSTRIA.

  • Premium

    Fence-Line Monitoring of Fugitive Emissions

    The Opsis open path monitoring system is an excellent tool for monitoring air quality, fugitive emissions and gas leaks at industrial sites. By arranging monitoring paths strategically at locations outside the borderline of an industrial area, fugitive emissions and gas leaks will effectively be detected. By combining the measured gas data with meteorological parameters information such as where the pollution sources are located and the strength of the emissions can be calculated, using the EnviMan software.

    By Opsis AB based in Furulund, SWEDEN.

  • Measurement solution for on-line carbon bed system

    Commonly, activated carbon beds are used as abatement systems on plant, with emissions being reduced by adsorption onto the bed. The efficiency of any abatement system is critical to its operation, not just in ensuring emissions are reduced as much as possible, but an efficient bed has cost savings for the operator.

    By Protea Limited based in Middlewich, UNITED KINGDOM.

  • Measurement solution for to multi-stream by-pass system

    A large pharmaceutical plant runs a Thermal Oxidiser on plant to incinerate their solvent-containing gas streams before emission. When the oxidiser is offline, then the plant must monitor the release of solvent to the atmosphere. A ProtIR 204C fixed monitoring system was installed that continually measures 24 plant solvents, including Acetone, Cyclohexane, DCM, DMF, IPA, MIBK, Toluene and THF. Given the high levels that are possible, the system has an active dilution system, reducing the concentration of the measured gas in the analyser to levels that can be analysed simply. Chemometric modelling enables interferences from the overlapping absorption spectra to be accounted for, ensuring accurate analysis of all 24 gases.

    By Protea Limited based in Middlewich, UNITED KINGDOM.

  • Premium

    Emissions Monitoring for Tunnels

    The Opsis monitoring solution is designed for high-quality gas measurement in traffic tunnels. The monitoring systems have been approved by the Germany TÜV and the U.S. EPA among others.

    By Opsis AB based in Furulund, SWEDEN.

  • Premium

    Continuous emissions monitoring for glass manufacturing industries

    Process control and emissions monitoring in a glass manufacturing plant is a challenge due to high temperature in the flue gas. The OPSIS DOAS system provides the glass industry with an accurate analyser that will operate with a minimum of maintenance. The OPSIS DOAS system is based on a non-contact method that uses an optical path to measure across the duct. A single OPSIS system will measure all relevant gas componensts such as NOX, SO2, CO, CO2, H2O, O2, and others.

    By Opsis AB based in Furulund, SWEDEN.

  • Premium

    Emissions monitoring for waste incineration

    Process control and emission monitoring in a waste to energy plant is a challenge. A large number of gaseous components need to be measured with high accuracy. Almost 100% uptime is required and the monitoring system needs to be easy to maintain and fast to calibrate.

    By Opsis AB based in Furulund, SWEDEN.

  • Measurement solution for CFC analyser

    CFCs are used in the manufacture of insecticides and herbicides and the environmental impact of their use must be well controlled. The treatment of CFC emissions to reduce the emissions in the intermediary steps of production needs to be monitored with 100% efficiency. Protea’s portable CFC analysers and continuous CFC monitoring systems can be configured with various sample inlets and analytical modelling to enable multi-samples to be measured on the one system. This means that both inlet and outlet to abatement systems can be monitored using the one analyser.

    By Protea Limited based in Middlewich, UNITED KINGDOM.

  • Premium

    Gas monitoring instruments and systems for greenhouse gas emissions from soil

    Measurement of greenhouse gases released from soil and water surface forms an important part of climate change study. Microbial activity in the soil or for instance the melting of permafrost releases greenhouse gases such as Methane and nitrous oxide N2O into the atmosphere. Measurement of the concentration for these gases inside an open-bottom soil chamber placed on the soil over time tells the emission rate (flux) per chamber footprint area.

    By Gasmet Technologies Oy based in Helsinki, FINLAND.

  • Premium

    Continuous emissions monitoring for sulphuric acid production plants

    The process control of a sulphuric acid plant needs good and reliable detection of gas phase sulphur dioxide (SO2). To measure SO2 is a challenge due to the corrosive environment and high concentration of SO2. Several places in the process needs to be monitored and to transport the sample gas is difficult. A large dynamic range is needed as the SO2 concentration can vary between 15% volume and a few mg/m3. Most systems installed need a lot of maintenance, sometimes as often as every day.

    By Opsis AB based in Furulund, SWEDEN.

  • Premium

    Continuous emissions monitoring for mercury monitoring

    Waste incinerators, cement plants and power plants need good and reliable measurements of total gaseous mercury. The measurement of total gaseous mercury is a challenge due to chemical reactions and contamination. The installed systems will often require a lot of maintanence still not giving reliable results.

    By Opsis AB based in Furulund, SWEDEN.

  • Premium

    Continuous emissions monitoring for mineral wool production

    Process control and emissions monitoring in a mineral wool plant is a challenge due to the presence of phenol and formaldehyde. To use an extractive system in this environment will demand a lot of maintenance. The OPSIS DOAS system is different and provides plants with an accurate analyser that will operate with a minimum of maintenance. The OPSIS DOAS system is based on a non-contact method using an optical measurement path that can operate across the duct.

    By Opsis AB based in Furulund, SWEDEN.

  • Fugitive emissions monitoring on industrial sites

    The real-time monitoring of odorous gases or more classical pollutants emitted by industrial sites (wastewater treatment plants, refineries, landfills, etc.) appears nowadays as a requirement, in order to optimize the site process and operations, or communicate towards the neighborhoods and local public bodies. While emissions can be measured directly at the source (in the stack, exhaust, etc.), ambient air measurement all around the sites provides a better accuracy and anticipate pollution episodes. This is why Cairpol developed around its Cairsens sensors a concept of smart and autonomous stations: Cairnet. Without any maintenance nor calibration, Cairnet is a completely autonomous system energy-wised, with user friendly and efficient interface, accessible from any internet-connected device.

    By Cairpol based in La Roche Blanche, FRANCE.

  • Integrated real-time gas analysis solution for emissions industry

    Pollutant emissions from industrial smoke stacks are a major national concern due to both health concerns and climate change. As a consequence, there are at least tens of gas analyzer manufacturers in the U.S. alone that compete in that market and have done so for years. What CIC Photonics brings to that competitive field is its expertise derived from its Combustion Efficiency Solution and its high performance IRGAS Systems. The IRGAS-CEM provides real-time and simultaneous measurements of the multitude of toxic combustion products, including CO, CO2, NOx, SOx, CH4, CxHy, H2S, etc. The EP-IRGAS-SPA is also applicable for fast time responses.

    By CIC Photonics, Inc. based in Albuquerque, NEW MEXICO (USA).

  • Indoor air quality measurement

    CairTub allows the easy deployment of autonomous measurement points virtually anywhere. The system can be used in harsh weather conditions. It is also the ideal tool for low cost studies for the optimisation and setting-up of fixed air quality monitoring stations. Cairpol systems can be used for fugitive emissions and odour measurement on industrial sites like waste water treatment plants (WWTP), landfill, compost plant, along a street or motorway, or in any sensitive area. Cairpol monitoring systems also offer the possibility to measure continuously pollutant levels in workshop atmospheres, houses and public buildings.

    By Cairpol based in La Roche Blanche, FRANCE.

  • Odour measurement on industrial sites like waste water treatment plants (WWTP), landfill, compost plant...

    CairNet is a simple and efficient way to monitor processes and plant surroundings via a wireless communicating network and autonomous (solar panel and battery). CairNet surveys fugitive emissions of toxic gases or odourous gases around waste water treatment plants (WWTP), allowing you to react quickly to gas leaks. CairNet allows the wireless survey of hundreds of measurement points within a 200m radius of the wireless receiver for a much efficient installation cost. Cairpol systems can be used for fugitive emissions and odour measurement on industrial sites like waste water treatment plants (WWTP), landfill, compost plant, along a street or motorway, or in any sensitive area. Read more https://www.environmental-expert.com/products/cairpol-cairnet-autonomous-real-time-pollution-monitoring-network-274828

    By Cairpol based in La Roche Blanche, FRANCE.

  • Air cleaning system for the retail

    Of the almost 5 million commercial buildings in the U.S., retail buildings account for the largest energy bills and are responsible for the second largest percentage of greenhouse gas emissions, according to the EPA.  There are a growing number of retail companies that are embracing the principles of sustainability, taking actions that are tangible, measurable and meaningful in reducing the use of scarce resources and improving the efficiency of their businesses.  For a large company, this can add up to millions of dollars in annual savings.

    By Dynamic Air Quality Solutions based in Princeton, NEW JERSEY (USA).

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you