Only show results available in Virginia? Ok

energy efficiency control Applications

  • motor control & energy efficiency for mine lifting machine

    Mine resource exploitation industry has formed extensive type, high consumption, and high pollution development mode for a long time and has made resource and environment difficult to bear. Therefore it is of all-important strategy significance for mine resource exploitation enterprises to realize energy conservation and emission reduction. The hoist is a conveyor which is used most extensively in mine and is simply classified as single hook type and dual hook type.

    By V&T Technologies Co., Ltd. based in shenzhen, CHINA.

  • Primary air control for coal-fired power plants

    Power Generation Combustion Air Measurements: The need for accurate, repeatable & reliable combustion air measurements in power generation plants is critical to efficient operation and safety throughout the entire facility and processes. Coal-fired power plant applications pose a number of challenges to obtaining these critical flow measurements includ¬ing large ducts, limited metering runs, poor velocity and temperature profiles, high vibration, temperatures up to 750° F and dirty `Fly Ash` laden air.

    By Kurz Instruments, Inc. based in Monterey, CALIFORNIA (USA).

  • Variable frequency drive controls AC motors

    Consider integrating a variable frequency drive. It often can optimize energy efficiency by enabling you to match motor speed to the demands of the system. Look for opportunities, for example, to replace throttle valves or dampers used to restrict flow. However, a variable frequency drive may not make sense if the load on the motor is relatively small and constant — because speed changes will occur infrequently and any benefits from varying the speed will be negligible. So, thoroughly assess the system load profile to determine the scale and frequency of required speed changes before deciding about installing a variable frequency drive.

    By Variable Frequency Drives based in NSW, AUSTRALIA.

  • Premium

    Biogas Monitoring for the Renewable Energy Industry

    AppliTek`s solutions in this field concentrate on the process efficiency of anaerobic digesters. Many existing digesters give unnecessary problems, which arise due to inadequacies in the process or process control system. AppliTek has developed a unique instrument to measure and control the key processes in the anaerobic fermentation. Compact gas analyzers with proprietary technology can be implemented to check the biogas yield.

    Parameters: Volatile Fatty Acids - Alkalinity - pH - Bicarbonate

    Gas parameters: CH4 - CO2 - O2 - H2S

    By AppliTek NV based in Nazareth, BELGIUM.

  • Premium

    Thin-film solar cells analysis for energy industry

    The research and development in the field of thin-film solar cells is an on-going process to improve efficiency even further, and to reduce manufacturing costs. X-ray fluorescence (XRF) is a field proven technology enabling users to control critical properties during development and manufacturing of the solar cells, such as elemental layer thickness and composition, improving quality and productivity, with resultant cost savings.

    By Oxford Instruments plc based in Abingdon, UNITED KINGDOM.

  • Premium

    Air pollution control for the composite & carbon fiber industry

    Anguil is intimately familiar with emission capture, control and compliance hurdles that composite and carbon fiber producers face. We specifically address the needs of our carbon fiber customers with proprietary oxidizer designs for furnace and oven emissions. Our systems are recognized for energy efficient operation and destruction capabilities by the U.S. Federal Government at their Oak Ridge National Laboratories (ORNL). Anguil continues to help producers drive down energy consumption and emission output through our participation in The Beacon, an initiative at the forefront of green manufacturing practices for fiber production.

    By Anguil Environmental Systems, Inc. based in Milwaukee, WISCONSIN (USA).

  • Metrology for the photovoltaics industry

    Quality control to maximize efficiency is critical in the competitive photovoltaic industry. For some time solar texture has been thought to qualitatively affect solar cell efficiency. However, through large-area, 3D measurements and areal feature parameters, quantitative correlation of texture to efficiency has only recently been obtained. We now know that ISO 3D surface parameters linearly correlate with solar cell efficiency.

    By Bruker Corporation based in Billerica, MASSACHUSETTS (USA).

  • Premium

    Air pollution control (APC) equipments for forest industry

    In the forest industry, it becomes increasingly important to improve energy efficiency. EnviBAT specializes in gas/gas heat exchange where heat is recovered from the outgoing gas streams, and mist gas condenser, where large amounts of heat can be recovered from the sulphate pulp mills.

    By Envibat AB based in Skellefteå, SWEDEN.

  • Process monitoring and controlling for wastewater treatment industry

    Automation can save money, optimise a process and give warning of potential breeches of discharge consent. However, instrument selection is fundamentally important if a control system is to function efficiently. The measurement device must accurately and quickly respond to process variations and it must be reliable in operation if the control system is to function as intended. Designed properly, energy and chemical use can be significantly reduced, saving money and ultimately improving effluent quality.

    By Pollution & Process Monitoring Ltd based in Sevenoaks, UNITED KINGDOM.

  • Premium

    High quality gas sensor solutions for biogas

    Fast, accurate and reliable measurement of CO2 and CH4 concentration. Methane and CO2 concentration measurements are a key part of the evaluation of the anaerobic digestion process. Too high or too low gas concentration levels can indicate a change in the efficiency of the fermentation process. AD process control systems measure the Methane content (and often the CO2 content) of the gas stream to control or evaluate the AD process and warn of problems. Edinburgh Sensors provide high performance OEM gas detectors that are able to give fast, accurate and reliable measurements of both CO2 and Methane concentrations.

    By Edinburgh Instruments Ltd based in Livingston, UNITED KINGDOM.

  • Premium

    Chemical Analyzing in Photovoltaics for the Solar Power Industry

    In the earlier days, the chemistry involved in solar cell manufacturing was relatively simple, using commodity chemicals. With cell efficiencies continuously on the rise and new cell concepts slowly being introduced with increased speed of processing, precise chemical concentration control is becoming crucial to obtain consistency and more cost-effective manufacturing of solar panels. This is possible by monitoring on-line the etching bath composition, a small but genuine step forward in your competitive advantage.

    Typical parameters: NaOH – Si – HF – HNO3

    By AppliTek NV based in Nazareth, BELGIUM.

  • Premium

    Chemical Water Treatment for membrane treatments

    Membrane units, in our days are widely used in the water pre-treatment preparation and are becoming one of the most important technologies in the production of high pure water. Nevertheless they often face problems with scaling and fouling and are therefore limited by frequent maintenance, downtime and high costs. Our treatment programs are specifically designed for membrane units like reverse osmosis, ultra- and nanofiltration and enable to remove or preventive control scaling and fouling. Our main target is to run these plants under environmentally friendly and beneficial economic conditions. Special attention is given to an efficient utilization of energy as well as saving precious water. Kurita develops an efficient and effective treatment concept achieving an optimal economic operation and a maximum operational reliability of a plant.

    By Kurita based in Ludwigshafen, GERMANY.

  • Premium

    Carbon Dioxide Monitoring for Indoor Air Quality

    Introduction: Accurate control of critical indoor environmental parameters is not only essential for the well-being and comfort of building occupants, but also has a major impact on energy efficiency. A multitude of parameters can affect indoor air quality (IAQ) from gases such as carbon dioxide, carbon monoxide and volatile organic compounds to particulates, humidity and bacteria such as legionella. Carbon dioxide is one of the greatest variables affecting indoor environmental quality since it is produced by people occupying the building. Carbon dioxide production is a function of the number, size and activity levels of the people present in the building. Local concentrations can therefore vary dramatically – for example when a meeting room is occupied, or while workers are on lunch or coffee breaks.

    By Edinburgh Instruments Ltd based in Livingston, UNITED KINGDOM.

  • Premium

    Waste Compaction for the Logistics Industry

    Efficiency, performance, reliability and effectiveness; these are qualities that we know professionals in the logistics and packaging industries want from their on-site baler.

    HSM can supply customers with a wide range of balers from our comprehensive range of models; we pride ourselves on using our experience to find the best solution, every time. Our balers have touch-screen control panels, are operationally efficient, simple to maintain and offer an excellent return on investment.

    Energy efficiency is of the utmost importance to HSM and we know that our German-designed, manufactured and tested balers exceed all operational and safety standards and offer an environmentally-sound method of waste removal.

    Our new generation of modern balers have been created to use low levels of energy, generate a minimum level of noise and operate without the need for constant supervision.

    By HSM GmbH + Co. KG based in Frickingen, GERMANY.

  • Premium

    Indoor Air Quality Monitoring

    Accurate control of critical indoor environmental parameters is not only essential for the well-being and comfort of building occupants, but also has a major impact on energy efficiency. A multitude of parameters can affect indoor air quality (IAQ) from gases such as carbon dioxide (CO2), carbon monoxide (CO) and volatile organic compounds to particulates, humidity and bacteria such as legionella. CO2 is one of the greatest variables affecting indoor environmental quality since it is produced by people occupying the building. CO2 production is a function of the number, size and activity levels of the people present in the building. Local concentrations can therefore vary dramatically – for example when a meeting room is occupied, or while workers are on lunch or coffee breaks. Excess CO2 levels can lead to tiredness and a lack of concentration and can contribute to the symptoms of Sick Building Syndrome such as headaches, eye, nose and throat irritation, itchy skin and nausea.

    By Edinburgh Instruments Ltd based in Livingston, UNITED KINGDOM.

  • CUSTOMER CONFIRMS LONGEVITY OF SCALEWATCHER ELECTRONIC WATER CONDITIONER

    Scalewatcher North America, manufacturer of the original, patented and award-winning computerized electronic water-conditioner, states in its literature that the device is produced to last at least 20 years and comes with a 10 year warranty. However, no reports have been received on the longevity of the units sold since the company was launched over 20 years ago. Now a customer in Gilroy, California has come forward requesting a new Scalewatcher unit after the device she purchased in 1992 finally stopped working. She purchased the new Scalewatcher from local dealer, Aqua Genesis, and reported that: “ I noticed that the sprinklers are covering more of an area than before. When I squirt water on the black and white tile patio table there are no longer any calcium spots even if I do not dry it off. The tile shower and the clear shower door are easier to wipe down after my shower. The new ScaleWatcher is much better than before. It certainly was time to replace the old one.” The new, innovative, electronic Scalewatcher water conditioner uses proven technology to quickly and effectively dissolve existing limescale and prevent it recurring, returning water systems and water-fed appliances such as kettles, washing machines and dishwashers to their former efficiency. It also removes scale around faucets, sinks, baths, plugholes and shower roses as well as preventing white marks on shower screens and mould on shower curtains. The system requires no plumbing, chemicals or maintenance and is environmentally friendly. In addition scale costs money for householders through additional cleaning products, the early renewal of water–fed equipment and additional costs to heat water. It is estimated that 40% more energy is needed to heat water in a system fouled with ¼ inch of limescale. Commenting Jan de Baat Doelman, President of Scalewatcher North America says: “We have always built Scalewatcher electronic water conditions to last and this latest information confirms the device’s longevity. Scalewatcher will pay for itself in less than three years and then carry on providing homes with a scale free environment many more years to come. ” Scalewatcher models are based on continuous research and over 20 years experience and expertise as market leaders in electronic scale control with countless units sold worldwide. The patented Scalewatcher systems start at $248.00 USD and are capable of treating pipe sizes from one to 120 inches. All Scalewatcher systems come with a full performance guarantee and include free shipping throughout North America.

    By Scalewatcher North America Inc. based in Oxford, PENNSYLVANIA (USA).

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you