Only show results in Virginia? Ok

environmental analyzer Applications

  • Premium

    Chemiluminescense based analyzer for environmental applications

    Focuses on low NOx and NOx-related concentrations up to 100 ppm where high resolution is required. Parameters included are NO, NO2, NOx and NOy. Target applications are ambient air monitoring, indoor measurement, clean room measurement and atmospheric research.

    By ECO PHYSICS AG based in Duernten, SWITZERLAND.

  • Testing linearity of Air quality analyzers

    To test gas analyzers for Air Quality monitoring, gas references must have concentration in the range of hundreds to tenths ppb. Test gas bottles with so small concentrations are expensive and unstable. With the gas divider BetaCAP30X100 it's possible to dilute high concentration test gases getting 30 dilution steps in the range from 1:100 to 1:3.000 of the original test gas bottle concentration. Traditionally MFC based diluters are used for this application, but now our capillaries based diluter is available,...

    By Be.T.A. Strumentazione Srl based in Borgolavezzaro, ITALY.

  • NOx Analyzers for environmental, ambient air and research industry

    Focuses on low NOx and NOx-related concentrations up to 100 ppm where high resolution is required. Parameters included are NO, NO2, NOx and NOy. Target applications are ambient air monitoring, indoor measurement, clean room measurement and atmospheric research.

    By Eco Physics Inc. based in Ann Arbor, MICHIGAN (USA).

  • Premium

    Instruments and analyzers for DHI measurements

    Diffuse irradiance measurements: Diffuse Horizontal Irradiance measurements are performed with a thermopile sensor called Pyranometer mounted on a Sun tracker or shading ring. When the pyranometer is installed on an automatic sun tracker, the diffuse radiation can be measured in two different ways. Measuring Diffuse irradiance requires an accurate pyranometer with low offset properties. Duirng clear sky conditions the DHI irradiance (W/m2) is less than 20% of the total irradiance. Zero offsets lead to underestimat...

    By EKO Instruments based in San Jose, CALIFORNIA (USA).

  • Premium

    Instruments and analyzers for DNI measurements with a pyrheliometer

    Solar Direct Normal Irradiance (DNI) represents the direct solar component and contains about 80% of the total solar energy budget on earth. Outside the atmosphere (AM0) the solar irradiance is considdered as a constant (1367 W/m2) that slightly fluctuates with a 11 year cycle. The DNI at the earth surface is highly variable due to the atmospheric conditions (clouds, aerosols, water vapor and molecules).

    By EKO Instruments based in San Jose, CALIFORNIA (USA).

  • Premium

    Instruments and analyzers for measuring spectral irradiance

    Spectral irradiance is the irradiance of a surface per unit frequency or wavelength. spectral irradiance of a wavelength spectrum is measured per watts per square metre per nanometre (W·m−2·nm−1). Spectroradiometers are devices designed to measure the spectral power distribution of a source. From the spectral power distribution, the radiometric, photometric, and colorimetric quantities of light can be determined in order to measure, characterize, and calibrate light sources for various...

    By EKO Instruments based in San Jose, CALIFORNIA (USA).

  • Premium

    Instruments and analyzers for spectral irradiance portable solutions

    Reflection and transmission measurements on materials, vegetation, water or atmosphere give valuable information about biological, physical and chemical processes. Processes driven by solar radiation, in particular bands of the spectrum through the so called action spectra, can be analysed or quantified with a sensor senitive in the particular spectral band. The MS-720 portable spectroradiometer gives total freedom to be used in different applications and range of the spectrum between 350 - 1050 nm.

    By EKO Instruments based in San Jose, CALIFORNIA (USA).

  • Instruments and analyzers for DNI measurements at CPV sites

    Concentrating Photovoltaics (CPV) is driven by only direct solar radiation. To quantify the energy efficiency of a CPV system the total DNI and direct spectral solar irradiance, called spectral DNI, can be measured. Solar sensors are crucial during the phase of development and operation. Even at high sunny places, the composition and variability of the atmosphere strongly affects the solar spectral distribution and will impact on the energy yield and the decision on which cell type to use. The pyrheliometer in...

    By EKO Instruments based in San Jose, CALIFORNIA (USA).

  • Premium

    Microbiological solutions for the environmental industry

    We are USDA certified to receive soil and groundwater samples from all over the world, including restricted areas in the southeastern United States. Typically, clients are provided sterile containers to collect soil and/or groundwater samples, and they ship them via overnight express mail in coolers packed with blue-ice. Our laboratory annually analyzes thousands of samples and issues hundreds of reports with full raw data appendix, with 100% on-time delivery.

    By Microbe Inotech Laboratories, Inc based in St. Louis, MISSOURI (USA).

  • Premium

    Measuring aromatic hydrocarbons (BTEX) for pollution control and environmental monitoring

    The Series 8900 BTEX Analyzer provides direct measurement of Benzene, Toluene, Ethylbenzene, and Xylenes in ambient air. This instrument is utilized in ambient air networks around metropolitan areas and fence-line monitoring at industrial sites. The Series 8900 BTEX Analyzer employs a photoionization detector (PID) as the sensing element. This detector is specific to volatile organic compounds. The Benzene, Toluene, Ethylbenzene, and Xylene`s in the gas sample are physically separated using proprietary GC columns.

    By AMETEK MOCON - Baseline based in Lyons, COLORADO (USA).

  • GIS software for archaeology

    Archaeologists, as researchers and resource managers, understand the importance of geography. Its variables exert a strong influence on human behavior today, and archaeologists are aware of the significance of this influence in the past. Geography also influences the degree of exposure of archaeological sites, and the impacts that they face from human activity and natural forces. GIS facilitates mapping to analyze depositional patterns as well as catalog and quantify artifacts. It can provide a well-structured...

    By Esri based in Redlands, CALIFORNIA (USA).

  • Premium

    Monitoring of mercury in ambient air

    Mercury, being widespread in environment, has toxic effect on a human organism even at a low concentration. Therefore, quantitativ e determination of mercury in vari ous environments is one of the most important environmental monitoring problems. The use of a mercury analyzer RA-915M/RA-915+/RA- 915Light with Zeeman background correction provides di rect real-time continuous determination of mercury in air from 0.5 ng/m 3 within the overall possible range of me rcury concentration in ambient air.

    By Lumex Instruments Group based in Mission, BRITISH COLUMBIA (CANADA).

  • Q-EHS Enterprise Application

    The Q EHS Enterprise system is a fully integrated, Environmental, Health and Safety (EH&S) analytical platform that simplifies your corporation-wide EH&S information management, increases workplace safety, and reduces risk exposure to regulatory citations. Q EHS Enterprise can help you: • Protect your employees’ health and safety in the workplace • Reduce your risk exposure associated with noncompliance through improved transparency of EHS management • Improve the efficiency of your current EH&S information...

    By Quantum Compliance based in Ann Arbor, MICHIGAN (USA).

  • Fire Danger Rating / Forecasting

    For various reasons, including the changing global climate, wildfires are getting bigger, more destructive and more expensive. Effective, consistent and reliable detection of climate parameters is the key to preventing wildfires and managing the impact they have. Our equipment resides for decades in solitary confinement generally in very remote areas (often at the tops of mountains or deep within a national forest), constantly measuring and recording weather data. Once per hour, this data is transmitted back to...

    By FTS based in Victoria, BRITISH COLUMBIA (CANADA).

  • Premium

    Data loggers and data acquisition monitoring solutions for the environmental sector

    Selection of environmental data loggers to measure, record and analyze historical data. Programmable, mixed-input models with single and multi-channel options. Remotely access data for real-time information. Environmental data loggers capture and record environmental data to satisfy a wide range of needs. These environmental monitoring solutions vary from simple 1- and 2-channel data loggers that monitor temperature and humidity to intelligent multi-channel instruments that can be used with weather stations and...

    By CAS DataLoggers based in Chesterland, OHIO (USA).

  • EDXRF spectrometers for forensics industry

    Fingerprinting all kinds of materials analyzed in forensic analysis Forensic scientists generally require fast and non-destructive analysis of a very wide range of materials. Often these materials are presented in very small quantity, as evidence collected from a crime scene. Using ED-XRF allows to measure a wide range of elements and concentrations: C(6)-Fm(100), without any need of sample preparations. Samples can be measured in many different formats such as powder, solid, liquid or in thin films.

    By Xenemetrix Ltd. based in Migdal Haemek, ISRAEL.

  • Premium

    Instruments and analyzers for accurate solar radiation measurements

    Conducting reliable and accurate solar radiation measurements requires some knowledge and attention: think of environmental influences (wind, rain/snow, soling), re-calibration (bi-annually), not to mention data processing, spectral effects, etc. Essentially, accurate broadband solar radiation measurements are obtained using two components: a suitable set of pyranometers, including an optional pyrheliometer (DNI sensor) with sun tracker, and an adequate data logger.

    By EKO Instruments based in San Jose, CALIFORNIA (USA).

  • RATA Relative Accuracy Test Audit or CAL2 (EN14181)

    An important step of CEMS testing is verifying of gas analyzers linearity : this step is well performed with a 30 steps gas divider. With just one test gas reference and a zero gas (diluting gas), the required 5 or 10 scaled concentrations may be easily produced "just in time". 30 steps dilution are available to allow using test gases with concentration up to 3 or 6 times the gas analyzer span.

    By Be.T.A. Strumentazione Srl based in Borgolavezzaro, ITALY.

  • Systems for the EPS foam processors industry

    Without an effective processing strategy, foam waste can easily overrun your valuable floor space. And depending on the volume and variety you accept, a simple compression solution might not be enough. Do you need a dedicated densifier for each grade? Is an air conveyance system right for your operation? OBC has years of experience analyzing and prescribing equipment configurations for effective foam processing solutions.

    By OBC Baling Equipment based in Cleveland, OHIO (USA).

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you