Only show results in Virginia? Ok

flow modeling Applications

  • Premium

    Open Channel flow monitoring for wastewater treatment plant

    After 16 years of service, the Long Sault WWTP replaced two older Greyline Open Channel Flow Monitors with new data logging OCF 5.0 models. This SBR treatment plant`s influent is measured with flow through two 6` Parshall Flumes.

    By Greyline Instruments Inc. based in Long Sault, ONTARIO (CANADA).

  • Data analysis and visualization tools for groundwater modeling

    Groundwater and Solute Transport modeling is a sub discipline of environmental sciences with unique needs. Modeling has long utilized 3D simulations, but the ability to visualize the results has lagged far behind the simulation technology. EVS-PRO and MVS have long offered professional level presentation tools worthy of the current state-of-the-art in modeling, and EnterVol now opens that door to GIS professionals around the world. Visualization of groundwater and solute transport modeling results can be performed from third party modeling systems such as USGS MODFLOW, MT3D, GMS©, Groundwater Vistas and Visual MODFLOW© using C Tech’s tools to convert these modeling outputs into EFF format. In conjunction with Lawrence Livermore National Laboratory and IT Group, C Tech performed the visualization and animation of the output from a Groundwater Vistas MODFLOW and MT3D99 simulation of a large industrial complex in the central valley area of California.  This site exhibits highly channelized flow which is evidenced by the flow paths. Note that flow in the lower aquifer crosses underneath the upper channels at about 30 degrees!

    By C Tech Development Corporation based in Henderson, NEVADA (USA).

  • Premium

    Fast Water, Rivers & Lakes

    Oil spill response operations are notably difficult in rivers with strong current. In addition, when considering response times for river spills in relation to the mobilisation time required for conventional land- or vessel-based boom systems, a timely response is often a logistic impossibility especially in the more remote regions. Therefore, equipment must be readily at hand near the sites of operation and pre-rigged lines, cables and mooring areas are a must. Selection of a good location to deploy the oil containment system is dependent upon prior planning and understanding of the currents. Drift studies, river run off histories, tidal current tables and charts, plus computer modeling are all useful tools to understand the flow patterns and to develop recovery strategies. Reading the currents and flow patterns require practice and understanding of the hydrodynamics involved.

    By DESMI A/S based in Noerresundby, DENMARK.

  • Biogas monitoring

    meet governmental regulations, it is important to accurately monitor methane gas production, removal, venting, and burning. Knowledge of both methane flow and temperature at the flare stack can define when CH4 is being emitted to the atmosphere. The DX99 FlexPower™ Nodes can be installed in EX area with a Zone 0 ATEX certification. Use the analogue input to determine methane production levels and flow and use the thermocouple model to measure the temperature of a vent to verify the continuous combustion of methane.

    By Banner Engineering Corp. based in Diegem, BELGIUM.

  • OneRainware™ - Radar rainfall for real-time and analytical applications.

    Accurate estimation of the spatial distribution of rainfall is critical to successfully model hydrologic processes. OneRain has worked with engineering firms and those with responsibilities in Stormwater and Wastewater Management across the U.S. to provide radar rainfall data to help characterize storm events or flow problems in collection systems and as a basis for both real-time and design-oriented modeling. OneRainware products and services offer: *Real-time gauge-adjusted radar rainfall (GARR) data *Real-time area-average rainfall *Real-time forecast rainfall *End-of-month archive quality gauge-adjusted radar rainfall data *Historical and post-event analysis using archived rainfall estimates *Web-delivered calibrated radar-rainfall data *StormProperties™ Analysis. GARR data are used in flood warning, runoff modeling, basin modeling, I/I studies, litigation, real-time control, design storms, and National Pollutant Discharge Elimination System (NPDES) compliance activities.

    By OneRain Incorporated based in Longmont, COLORADO (USA).

  • EDI Solutions

    QUA’s FEDI® (Fractional EDI) stacks have superior hardness tolerance compared to the other EDI products on the market. With a dual voltage process this allows for a higher flexibility and tolerance to inlet water conditions, thus lowering the risk of scaling, and improving the plant's design economics and reliability. FEDI stacks are available in three different models which can be applied either for higher hardness tolerance or high water flow rates. MEGA FEDI stacks are ideal for large capacity, high flow systems normally required in heavy industrial projects such as power, petrochemicals, & electronics for high purity water needs. Each stack can handle treated water flow of up to 75 GPM . MEGA FEDI’s unique stackable design minimizes piping, reduces footprint, and makes it simple and easy to install on skids. FEDI-Rx products are specially designed for applications in pharmaceutical, biomedical and laboratory applications where installations require hot water sanitization to meet

    By QUA Group LLC based in Canonsburg, PENNSYLVANIA (USA).

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you