Only show results available in Virginia? Ok

fugitive emissions monitoring Applications

  • Premium

    Fence-Line Monitoring of Fugitive Emissions

    The Opsis open path monitoring system is an excellent tool for monitoring air quality, fugitive emissions and gas leaks at industrial sites. By arranging monitoring paths strategically at locations outside the borderline of an industrial area, fugitive emissions and gas leaks will effectively be detected. By combining the measured gas data with meteorological parameters information such as where the pollution sources are located and the strength of the emissions can be calculated, using the EnviMan software.

    By Opsis AB based in Furulund, SWEDEN.

  • Premium

    Fugutive Emissions Measurement

    Emission Measurement – An estimate of the total fugitive emissions from a site can be determined using environmental data, EPA gas dispersion models, and GasFinder2 sensor data.

    By Boreal Laser Inc. based in Edmonton, ALBERTA (CANADA).

  • Premium

    Emissions Monitoring for Airports

    Opsis systems provide high-performance monitoring of the emission activities within an airport. The rapid system allows on-line monitoring of the emissions from each aircraft at take-offs and landings, monitoring of fugitive emissions from stationary sources and differing of the airport sources from the surrounding pollution sources.

    By Opsis AB based in Furulund, SWEDEN.

  • Premium

    Gas Detection Solutions for GHG Monitoring

    Most sources of fugitive emissions are from multiple points rather than single point sources. So, open path area or perimeter monitoring provides more meaningful fugitive emissions data than an array of point sensors or a program of grab sampling. Point measurements may underestimate emissions because of missing locations with high gas concentrations, or conversely overestimate because they are located in areas of high concentrations. Grab sampling programs typically check only a small percentage of potential leak locations and extrapolate results to an entire facility. Wide margins of uncertainty are associated with such extrapolations. Open path monitoring provides continuously updated, real-time, integrated emissions across a facility boundary.This provides a complete picture of the fugitive emissions across that boundary,enabling identification of specific operations and times that give rise to higher emissions, and so enabling these emissions to be properly managed and controlled.

    By Boreal Laser Inc. based in Edmonton, ALBERTA (CANADA).

  • Premium

    Fence-line Monitoring

    The OPSIS open-path monitoring system is an excellent tool for monitoring the air quality, fugitive emissions and gas leaks at industrial sites. By arranging monitoring paths strategically at locations outside the borderline of an industrial area, fugitive emissions and gas leaks will effectively be detected. By combining the measured gas data with meteorological parameters information such as where the pollution sources are located and the strength of the emissions can be calculated, using the EnviMan software.

    By Opsis AB based in Furulund, SWEDEN.

  • Premium

    Perimeter Ambient Air Monitoring

    Cerex Multi-Gas Open Path Analyzers are available in both FTIR and UVDOAS technologies to meet specific requirements for perimeter ambient air quality monitoring, leak detection, fugitive emissions monitoring and ambient air quality monitoring. Cerex multi-gas analyzers offer significant advantages over single gas analyzer arrays, electro-chemical sensor arrays and time integrated air sampling hardware

    By Cerex Monitoring Solutions, LLC. based in Atlanta, GEORGIA (US) (USA).

  • Premium

    Open Path Ambient Air Quality Monitoring

    Cerex Multi-Gas Open Path Analyzers are available in both FTIR and UVDOAS technologies to meet specific requirements for perimeter ambient air quality monitoring, leak detection, fugitive emissions monitoring and ambient air quality monitoring.

    By Cerex Monitoring Solutions, LLC. based in Atlanta, GEORGIA (US) (USA).

  • Environmental monitoring solution for mining industry

    Control of fugitive dust in the mining industry and in particular open cut operations is of great concern to the local community, environmental protection authorities and of course the mine operators. Dust emissions can cause both nuisance effects as well as health effects and so mines typically employ multiple dust suppression activities to minimise their environmental impact. Many of these activities can be expensive to operate and depending on environmental conditions, at the time, may not actually be effective or necessary.

    By Ecotech Pty Ltd based in Knoxfield, AUSTRALIA.

  • Premium

    Mercury monitoring for on-site remediation

    Fugitive emissions can be a health concern during removal and disposal of mercury-contaminated material at remediation sites. Thus, remediation projects either indoors or outdoors often require on-site, real-time mercury air monitoring with a Tekran 2537. This assures permitted levels are not exceeded during waste processing and human exposure levels are below government regulated toxicity thresholds. Often multiple sites must be monitored continuously. The Tekran 1115 Multi-Port Sampler is the ideal tool for multiplexing the Tekran 2537 for real-time continuous on-site monitoring of mercury fugitive emissions. Please contact us for more information on mercury remediation monitoring.

    By Tekran Instruments Corporation based in Knoxville, TENNESSEE (USA).

  • Premium

    Ambient air quality monitoring at airports

    To measure the ambient air quality at airports is a challenge. The monitoring site needs to be representative for background levels and not dependant on changes in local traffic. A large number of gaseous components need to be measured with high accuracy and high availability. The OPSIS DOAS system provides the user with a fast system that gives high availability at low cost. The impact of aircraft take-offs and landings can easily be followed on-line. The OPSIS system can also monitor fugitive emissions from other sources at the airport.

    By Opsis AB based in Furulund, SWEDEN.

  • Premium

    Laser gas detection for environmental compliance

    Axetris laser gas detection OEM modules are used in a variety of environmental applications: Biogas Detection, Continuous Emissions Monitoring CEM, Fugitive Emissions, Natural Gas Detection.

    By Axetris Ag based in Kaegiswil, SWITZERLAND.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you