Only show results available in Virginia? Ok

gas calibrator system Applications

  • Production of high-accuracy ethanol calibration gas

    Fast and highly accurate analyzer system was needed for ethanol calibration gas standards. Precisive`s OXS-3100-HC configured for ethanol gas was selected due to its sub-ppm repeatability and high stability.

    By MKS Instruments, Inc. based in Andover, MASSACHUSETTS (USA).

  • Gas analysis & monitoring systems for gas generation

    The gas generators for calibration based on the use of “Method of Permeation Tubes.”. The permeation tubes are sealed capsules containing a small amount of the component that is in contact with a permeable membrane stable. The permeation through the membrane produces a vapor of the compound of the component of small quantity, very stable as a stream in time. This permeate stream by mixing with a dilution gas controlled and precise (for example nitrogen) creates a mixture in track at the desired...

    By ETG Risorse e Tecnologia S.r.l. based in Montiglio, ITALY.

  • Continuous Emissions Monitoring Calibration Systems (CEMCS)

    The Environics Series Continuous Emissions Monitoring Calibration Systems (CEMCS) have been used in CEM vans and laboratories for over twenty years. They meet or exceed the performance requirements of the United States EPA 40 CFR Part 51 Method 205 Appendix M. Our systems are custom built, computerized, mass flow controller based gas calibration systems which allow you to dilute a single high concentration cylinder of span gas to low levels for the calibration of gas analyzers.

    By Environics, Inc. based in Tolland, CONNECTICUT (USA).

  • Gas Detection

    Gas Detection is our core business, whether portable, colormetric, fixed systems or Hazmat. We do more than get you the equipment you need--we also help you select it, calibrate it, service it and maintain it. Our technicians, our sales reps and top management can speak with authority on the capabilities of our equipment and match it to your specific application. And we are the champions of the one-of-a-kind solution, because we have the know-how and the right tools.

    By Argus-Hazco based in Chesterfield, MICHIGAN (USA).

  • Premium

    Capabilities of the Adsorbent Tube Injector System (ATIS™)

    The Adsorbent Tube Injector System (ATIS) was developed at Supelco® by R&D Scientists, as a tool to assist in our comprehensive adsorbent research for thermal desorption tubes. The ATIS provides an efficient means of transferring calibration standards in either the gas or liquid phase onto the adsorbent packed tubes. The ATIS employs the technique of flash vaporization to vaporize the sample in a continuous flow of inert gas; the inert gas carries the sample to the tube. The sample pathway of the ATIS is construct...

    By Merck KGaA, Darmstadt, Germany based in Darmstadt, GERMANY.

  • Computerized instrumentation for the medical gas flow and scientific research

    Environics gas mixing, blending and dilution systems provide for precise mixing of gases for a wide variety of clinical applications. Our systems can produce gas concentrations from percent to ppb levels for single or multi-point calibration. The high accuracy of our mixers make them the units of choice for a wide variety of laboratory and research applications. For example, Environics Biological Atmosphere Incubation Mixers provide stable and accurate gas mixes for any laboratory or clinical need. You can...

    By Environics, Inc. based in Tolland, CONNECTICUT (USA).

  • Premium

    DETERMINATION OF FATTY ACID METHYL ESTER (FAME) CONTENT IN DIESEL FUEL OR DOMESTIC HEATING FUEL BY MID-IR SPECTROSCOPY

    Presence of fatty acid methyl esters (FAME) in diesel fuel or domestic heating fuel (both hereinafter referred to as diesel fuel) is a signal of blending with biodiesel. The control of FAME content in diesel fuel is an essential and actual task because of the need of the right fuel identification and registration of possible FAME impact on engines and fuel systems. To control the compliance one of the most accurate, rapid and simple methods is EN 14078:2014. Lumex Instruments provides user-friendly analytical...

    By Lumex Instruments Group based in Mission, BRITISH COLUMBIA (CANADA).

  • Capabilities of the Adsorbent Tube Injector System (ATIS™)

    The Adsorbent Tube Injector System (ATIS) was developed at Supelco® by R&D Scientists, as a tool to assist in our comprehensive adsorbent research for thermal desorption tubes. The ATIS provides an efficient means of transferring calibration standards in either the gas or liquid phase onto the adsorbent packed tubes. The ATIS employs the technique of flash vaporization to vaporize the sample in a continuous flow of inert gas; the inert gas carries the sample to the tube. The sample pathway of the ATIS is construct...

    By MilliporeSigma based in Bellefonte, PENNSYLVANIA (USA).

  • HCl Monitoring in Air

    Hydrogen chloride (HCl) is a colorless, sometimes slightly yellow, gas. It is an undesired environmental component that may be damaging to workers and the surroundings. Exposure limits have thus been established by industries to make sure that the workers operate in a safe environment. HCl monitoring is especially required for incinerators, coal-fired power plants, aluminum recycling and cement plants. Unisearch offers a reliable and easy-to-use HCl analyzer – the TDLAS-based LasIR system. Studies have...

    By Unisearch Associates Inc. based in Concord, ONTARIO (CANADA).

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you