Only show results in Virginia? Ok

gas power generation Applications

  • Premium

    Gas Detection Solutions for Power Generation Industry

    Boreal possess an array of products for the power generation industry from emissions stack monitoring, boiler room monitoring, chloride leak detection, and ammonia slip in deNOX. Boreal’s products are tailor made for coal fired power plants, natural gas fired, and waste-to-energy. Whether gas detection is used for safety, process, or environmental reasons, Boreal has you covered.

    By Boreal Laser Inc. based in Edmonton, ALBERTA (CANADA).

  • Premium

    Actuators for the power generation

    As well as traditional power stations, applications for Rotork products are found on renewable energy generation such as solar thermal plants and on CO2 emissions reduction processes such as flue gas desulphurisation and carbon capture and storage.

    By Rotork based in Bath, UNITED KINGDOM.

  • Power Generation

    Combustion turbines A gas turbine, also called a combustion turbine, is a type of internal combustion engine. It has an upstream rotating compressor coupled to a downstream turbine, and a combustion chamber in-between. The basic operation of the gas turbine is similar to that of the steam power plant except that air is used instead of water. The turbine shaft energy is used to drive the compressor and other devices such as an electric generator that may be coupled to the shaft. The energy that is not used for shaft work comes out in the exhaust gases, so these have either a high temperature or a high velocity. A catalyst is often used to treat these exhaust gases to comply with emissions regulations. EmeraChem has installed OEM and after-market catalyst in over 240 applications

    By EmeraChem based in Knoxville, TENNESSEE (USA).

  • Dustless Lead Paint Removal & Nuclear Decon Tools for Power, Oil and Gas Industry

    Pipelines, large fuel storage tanks, transformer pads and countless power generating systems have been decontaminated and prepared for a fresh coat of paint in one step! There is no costly containment to setup before starting the job or additional cleanup after it’s done, because our shrouded power tools capture dust before it’s emitted. Our powerful HEPA vacuum deposits hazardous waste directly into a 55-gallon drum, safely sealed and ready for transport when full.

    By Pentek Inc. based in Coraopolis, PENNSYLVANIA (USA).

  • Evaporators technology for power industry

    EVALED evaporators treat or minimize wastewater from the Power Generation Industry. Flue gas desulfurization effluents require different kinds of treatments depending on the type of fuel, water sources, and environmental regulations.

    By EVALED - Veolia Water Technologies based in Zoppola (PN), ITALY.

  • Premium

    Water treatment for power plants

    The process of electricity generation from fossil fuels such as coal, oil and natural gas is water-intensive. Between 40-50% of all water abstracted and used in developed countries is used in the generation of electricity. Thus, a reliable, abundant and predictable source of raw water supply to a power plant is a critical factor in site selection. Water supplies are required to provide various process waters for the following essential main purposes such as make-up water, cooling water for steam turbine condensers, and auxiliary plant cooling water.

    The primary application of modern water treatment technology is to maintain the integrity and performance of the power plant. Critical plant applications have water purity or conditioning requirements that must be adhered to for safe, reliable and efficient power generation.

    Experience has shown that integration of water technology treatments with power plant design can be very important in reducing operational problems and component failures 

    At power plant worldwide there are increasing limitations on water availability and environmental restrictions on discharges. This is expected to promote measures for water conservation and to have an increasing influence on water treatment decisions. At power plant, the recycling of internal wastewater streams can extend from the recovery of individual high-quality waste streams, which can be reused either directly or after only limited treatment, through to the development of fully integrated water/wastewater treatment systems for zero liquid discharge. However, the application of reuse schemes requires site-specific assessment, as not all waters may be viable options for recovery.

    By De Nora Water Technologies based in Colmar, PENNSYLVANIA (USA).

  • Moisture Monitoring for Nuclear Reactors

    The Advanced Gas Cooled Reactor uses carbon dioxide gas to transfer heat from the nuclear fission core to the water boiler for steam generation. The moisture content needs to be monitored to avoid corrosion damage, and continuous moisture monitoring acts as a boiler leak detector or bulk moisture meter.

    By Moisture Control & Measurement Ltd based in Wetherby, UNITED KINGDOM.

  • Energy from biogas and natural gas for agriculture

    You are a farmer and would like to make money from generating electricity and heat? Then you have come to the right place. Within just a few years Dreyer & Bosse Kraftwerke GmbH have advanced to become one of the leading manufacturers of combined heat and power stations on biogas basis - we have available a complete product portfolio for energy applications of biogases or biomethane.

    By Dreyer & Bosse Kraftwerke GmbH based in Gorleben, GERMANY.

  • Coal Combustion Residuals Disposal for Power Plants

    Coal combustion residuals (CCR) are generated during the power generation process and can include fly ash, bottom ash, boilerslag, and flue gas desulfurization (FGD) residuals. CCRs contain trace concentrations of heavy metals and therefore cannot be dumped or stored where rainwater can leach the metals. Liner systems can be used to contain the coal combustion by-products and protect them from leaching into the environment.

    By CETCO based in Hoffman Estates, ILLINOIS (USA).

  • Premium

    Single Gas Monitoring - Fixed in-situ Duct Path

    Application: Measurements of single gas species through a fixed in-situ duct path. Example: Monitoring NH3 emissions in coal fired power generating stations.

    By Boreal Laser Inc. based in Edmonton, ALBERTA (CANADA).

  • NOx analyzers for Source Emissions

    NOx analyzers for measuring emissions from refineries, power generation, industrial processes and other sources, as well as for combustion research. View Source Emissions Products

    By ECO PHYSICS, INC. based in Ann Arbor, MICHIGAN (USA).

  • Premium

    High quality gas sensor solutions for landfill

    State-of-the-art systems enabling easy monitoring of CO2 and CH4 gases. Capped Landfill Sites produce a range of gases, mostly methane and carbon dioxide. Legislation requires that these gases are safely removed from beneath the cap to avoid a physical explosion due to the build-up of pressure beneath the cap. Safe disposal usually entails burning such as flare stacks, internal combustion engines or by processing to produce Methane gas fuel. For large sites with access to power distribution infrastructure internal combustion engines are used to generate electricity which is fed into the local electricity grid. All of the above safe disposal process require the measurement of the Methane content (and in many cases the CO2 concentration). Edinburgh Sensors provide gas sensors for both Methane and CO2 that can be integrated into landfill gas processing systems enabling easy monitoring of these gases.

    By Edinburgh Instruments Ltd based in Livingston, UNITED KINGDOM.

  • Low emissions auxiliary boilers to coal or otherwise fired power plants

    Whether providing high-efficiency, low emissions auxiliary boilers to coal or otherwise fired power plants across the United States, or heat recovery steam generators to natural gas fired turbine plants you will find Superior Boilers serving the needs of power generation customers for years to come.

    By Superior Boiler Works, Inc. based in Hutchinson, KANSAS (USA).

  • Energy from biogas and natural gas for the waste to energy industry

    You are a farmer/entrepreneur and would like to make money from generating electricity and heat? Then you have come to the right place. Within just a few years Dreyer & Bosse Kraftwerke GmbH have advanced to become one of the leading manufacturers of combined heat and power stations on biogas basis - we have available a complete product portfolio for energy applications of biogases or biomethane.

    By Dreyer & Bosse Kraftwerke GmbH based in Gorleben, GERMANY.

  • Premium

    Measurement solution for hydrogen fuel cell testing

    As the alternatives to fossil fuels for power generation and automotive power become more widespread and preferred, so has increased the research and testing of hydrogen gas in fuel cells. The hydrogen (H2) gas used in fuel cell has to be free of impurities in order to make the fuel cell as efficient as possible and so quality thresholds have been set in legislation. Such legislation as SAE J2719 provides hydrogen fuel quality standards for proton exchange membrane (PEM) fuel cell vehicles. If impurities above these thresholds are present in the H2 fuel then there is a risk of not only making the cell inefficient, but also unrecoverable back to its peak operating voltage as the fuel cell electrode becomes poisoned.

    By Protea Limited based in Middlewich, UNITED KINGDOM.

  • Premium

    Measurement solution for CO2 capture by amine absorption

    The act of capturing and storing CO2 produced from large scale combustion plants such as power stations is becoming more and more favourable and feasible. One of the most common post-combustion CO2 capture methods is by absorption. The absorption plant can be added on to the existing combustion process, with the flue gas first passing through an absorption column where the CO2 reacts with an absorber. Amines of different types are used as the absorber. An amine CO2 capture plant can capture as much as 90% of the CO2 emitted from the power station and so has a real benefit for the environment. Having said this, care needs to be taken to ensure that amine emissions themselves are monitored, managed and prove no extra damage to the environment. Research is on-going to develop new amines or mixtures of amines to reduce emissions. The most common absorber in use in today’s first generation of industrial pilot plants is Monoethanolamine (MEA).

    By Protea Limited based in Middlewich, UNITED KINGDOM.

  • Premium

    Flow meters solutions for developing economies

    Mass flow meters and mass flow controllers help developing countries explore their natural resources. Our thermal flow meters are widely used in flotation cells in mining. Our multivariable mass vortex flow meters are used in the oil and gas industry both at the wellhead and in the refinery. Thermal mass flow meters also have a place in the power generation industry where they are used to measure and control fuel-to-fuel air ratios.

    By Sierra Instruments, Inc. based in Monterey, CALIFORNIA (USA).

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you