Only show results available in Virginia? Ok

hazard monitoring Applications

  • Premium

    Gas monitoring instruments and systems for HAZMAT

    Accidents involving chemicals and other hazardous materials require fast and accurate gas measurements as part of the first response. The Gasmet™ DX4040 portable FTIR Gas Analyzer provides reliable identification and concentration measurements of hazardous gases in 60 seconds or less.

    By Gasmet Technologies Oy based in Helsinki, FINLAND.

  • Laboratory Weighing - Hazardous Area (Ex) Weighing

    Are you continuously seeking to improve your safety, health and environmental standards, while striving for increased productivity and product quality? With METTLER TOLEDO’s solutions for hazardous areas, apparent contrasts turn into one set of standards. Our wide selection of intrinsically safe weighing systems includes balances, indicators and accessories, weighing modules, and weighing platforms of several sizes, shapes and capacities.

    By Mettler - Toledo Int. Inc based in Greifensee, SWITZERLAND.

  • Gas Detection & Hazardous Gas Monitoring Equipment for Mining

    Depending on the type of mining, the requirements for gas detection can vary greatly, however, there are five main sources of hazardous gas in mining applications.

    By Armstrong Monitoring Corporation (AMC) based in Ottawa, ONTARIO (CANADA).

  • Gas Detection & Hazardous Gas Monitoring Equipment for Pulp and Paper

    Pulp and paper mills can present many dangerous situations, which can be significantly decreased by utilizing continuous gas monitoring.

    By Armstrong Monitoring Corporation (AMC) based in Ottawa, ONTARIO (CANADA).

  • Gas Detection & Hazardous Gas Monitoring Equipment for Waste Water Treatment

    Growing environmental concerns have resulted in the construction and upgrading of waste water treatment plants throughout North America.

    By Armstrong Monitoring Corporation (AMC) based in Ottawa, ONTARIO (CANADA).

  • Rugged Mobile Technology for Hazardous Areas

    You could say that all the work our computers do is environmental work, since holding up to any environment is exactly what these handhelds are made to do. No matter the environment, our devices have you covered.

    By Hand based in Lidköping, SWEDEN.

  • Industrial solutions for air quality monitoring

    To protect humans and the environment from damage by air pollution, it is of the utmost importance to measure the levels of pollutants in the air. Real time monitoring of dangerous gases is particularly interesting in hazardous areas, as the conditions can change dramatically very quickly, with serious consequences. ADVANTICSYS employs its knowledge in wireless sensor networks to develop customized solutions for our customers.

    By Advantic Sistemas y Servicios S.L based in Alcobendas, SPAIN.

  • Premium

    Air quality and industrial gas monitoring systems for Ambient air monitoring

    Ambient air quality monitoring is the systematic, long-term assessment of pollutant levels by measuring the concentration and types of certain pollutants in the surrounding, outdoor air. Some of these pollutants (commonly called ‘Criteria Pollutants’) are considered hazardous to human health and their levels are regulated by government agencies around the world, including the US EPA. Teledyne API provides a complete line of ambient air quality monitoring instruments, including those for both gas and...

    By Teledyne API based in San Diego, CALIFORNIA (USA).

  • Premium

    Processing of LCD screens

    The safe extraction of valuable raw materials: robots automatically dismantle monitors containing mercury, while protecting workers’ health at the same time. According to initial projections, around three million LCD screens will be recycled in Germany in 2016. However, their backlighting system often contains mercury, which means they are classified as 'hazardous waste' in accordance with the EWC, and as 'Collection Group 3' in accordance with the Electrical and Electronic Appliance Law. They also contain...

    By Erdwich Zerkleinerungs-Systeme GmbH based in Igling, GERMANY.

  • Sewer Meter -

    Sewer Meters monitor sewage level and flow within the sewers. Benefits gained by sewer monitoring include: (1) Detection of overflow conditions before overflow occurs thereby preventing hazardous environmental events. (2) Detection of blocked sewer pipes, allowing quick and focused maintenance thereby reducing maintenance costs. (3)Detection of over-used and under-used pipes for long term municipal planning. (4) Monitoring of sewage flow in sensitive sites such as flow to the river or sea. (5) Estimation of...

    By Solid Applied Technologies Ltd. (SolidAT) based in Ashkelon, ISRAEL.

  • Premium

    Online monitoring solutions for determination of hydrogen in gas vent

    Levels of of hydrogen in the gas vent of the HCl burner can be measured by means of AppliTek’s thermal conductivity analyzer system. The analyzer system is suited for use in hazardous environments and meets ATEX or NEC500 compliance standards.

    By AppliTek NV based in Nazareth, BELGIUM.

  • Premium

    Online monitoring solutions for determination of hydrogen in hydrogen feed

    Levels of of hydrogen in the hydrogen feed of the HCl burner are reliably measured and controlled by means of AppliTek’s thermal conductivity analyzer system. The analyzer system is suited for use in hazardous environments and meets ATEX or NEC500 compliance standards.

    By AppliTek NV based in Nazareth, BELGIUM.

  • Measurement solutions for hospital workplace exposure monitoring

    In taking a responsible stance on the exposure of workers to any potentially hazardous gases, there is a need for workplaces using anaesthetic gases, such as hospital operating rooms or research laboratories, to control the level of waste anaesthetic gas in the ambient air

    By Protea Limited based in Middlewich, UNITED KINGDOM.

  • Air monitoring equipments for soil contamination monitoring

    Previous land uses or accidental spills can result in Volatile Organic Compound (VOC) contamination of soils. Volatile and semi-volatile compounds can then permeate through the soil and may persist for several years. This contamination can be traced and measured using our Soil Probes in conjunction with our VOC sorbent tubes. Soil probes are also useful in checking the effectiveness of remediation actions. This monitoring technique provides a cost-effective identification of hazardous gases.

    By Gradko International Ltd based in Winchester, UNITED KINGDOM.

  • Premium

    Continuous Metals Stack Monitor (CEMs)

    Cooper Environmental's Xact® 640 has the unique ability to generate high time resolution metals measurement in stacks. This unique capability has the potential to qualify as a substitution for the combination of a Hg/ PM CEMs application as well as the potential for a pollution control system feedback loop that could result in the reduction of pollution control consumables. Our systems have been site certified for compliance measurements at hazardous waste incinerator and secondary lead smelter sites.

    By Cooper Environmental Services based in Beaverton, OREGON (USA).

  • Premium

    Tunnel solutions for the visibility monitor

    The TunnelTech 101 Visibility Monitor (VIS), is an essential part of any road or rail tunnel safety system. It monitors the Visibility within the tunnel and ensures that the tunnel ventilation system provides sufficient clean air for drivers to clearly see the road ahead. The TunnelTech 102 Cold smoke monitor (CSM detects smoke from a fire to rapidly warn the operator of the hazard. Secondly, used in combination with other TunnelTech 101 VIS monitors, the operator can quickly detect the locus of the fire if it is...

    By Codel International Ltd based in Bakewell, UNITED KINGDOM.

  • Premium

    Tunnel solutions for the light sensors

    According to the International Committee on Illumination CIE recommendations, luminance should be monitored as the luminance contained within in a conical field of view, subtending an angle of 20º. It is recommended that a luminance photometer is mounted in the tunnel approach road approximately 120 - 200 metres from the portal, depending on the approach speed of the vehicles and their stopping distance. The purpose of monitoring the luminance at the portal is to adjust the level of light intensity inside...

    By Codel International Ltd based in Bakewell, UNITED KINGDOM.

  • Contrail® - software for real-time Dam Safety Monitoring

    Combining locally sensed data with other data sources and forecasts, 24/7-supported Contrail® monitors customized alarm rules to notify safety officials of potentially hazardous conditions. Ask us about Contrail® for Dam Safety.

    By OneRain Incorporated based in Longmont, COLORADO (USA).

  • Premium

    Waste water treatment plants Personnel Safety & H2S filter management

    Context & Challenges Globally, the wastewater treatment is the first public health issue. Urban development leads to urbanization near waste water treatment plant and extension of sewerage network. These aspects induce to an augmentation of sulfur compounds (H2S, mercaptans and sulfides) which are very corrosive, odorant and toxic. To monitor this compounds online CHROMATOTEC® offers high meteorological solutions. As a result of the confinement of the waste water stations, toxic components such as H2S and...

    By Chromatotec Group based in Val de Virvée, FRANCE.

  • Premium

    Continuous emissions monitoring in waste incineration plants

    Waste-to-energy through incineration of waste is an effective way of producing electricity and heat, at the same time getting rid of the possibly hazardous or unrecyclable waste. The waste can be incinerated at specific WtE plants or at plants with permission for co-incineration of waste at biomass boilers or cement kilns. The waste incineration plants are, however, governed by strict emissions regulations.

    By Gasmet Technologies Oy based in Helsinki, FINLAND.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you