Only show results in Virginia? Ok

industrial gas generator Applications

  • Nitrogen generation for the Marine, Oil & Gas industry

    Marine conditions pose a number of challenges and issues. Size, weight, rough sea conditions, corrosion, high temperatures, cargo needing protection, just to name a few.Oxymat’s Marine, Oil & Gas division produces nitrogen PSA generator systems to the marine industry with the necessary experience and know-how to address these issues. Compared to a traditional membrane based system, PSA systems significantly decrease redundancy and can cut energy consumption with up to 30%. In addition, a PSA system can produce 5% or lower oxygen levels.With the highest quality in components, PSA systems are extremely reliable with at least 48.000 running hours before CMS replacement is needed.

    By Oxymat A/S based in Helsinge, DENMARK.

  • Premium

    High technology gas generators for laboratory industry

    Laboratory.

    By Leman Instruments SAS based in Archamps, FRANCE.

  • Premium

    Gas Detection Solutions for Power Generation Industry

    Boreal possess an array of products for the power generation industry from emissions stack monitoring, boiler room monitoring, chloride leak detection, and ammonia slip in deNOX. Boreal’s products are tailor made for coal fired power plants, natural gas fired, and waste-to-energy. Whether gas detection is used for safety, process, or environmental reasons, Boreal has you covered.

    By Boreal Laser Inc. based in Edmonton, ALBERTA (CANADA).

  • Nitrogen Generators for Gas Assist Injection Molding

    As someone who works in the injection molding industry, you understand just how important it is to work with a high level of nitrogen purity. That’s why here at Gas Control Systems we offer gas assist injection molding nitrogen generators with up to 99.999% purity.

    By Gas Control Systems, Inc (GCS) based in Sparta, MICHIGAN (USA).

  • Residual Gas Analysis

    Residual Gas Analysis is a general term for the analysis of gas and vapour species in vacuum chambers and vacuum processes. The Hiden RGA series quadrupole mass spectrometers provide for routine, fast, wide dynamic range residual gas analysis, measuring the partial pressures of the species that are critical to vacuum quality and process requirements. Applications include: vacuum chamber leak detection vacuum quality measurement and monitoring virtual leak detection outgassing studies bakeout cycle/vacuum pump down monitoring

    By Hiden Analytical based in Warrington, UNITED KINGDOM.

  • Premium

    Industrial Solution for gasification & synthetic gas

    Gasification and synthetic gas production from various waste products are becoming increasingly important energy recovery technologies. Often, the synthetic gas contains various hazardous contaminants including H2S, HCl and other acids, heavy metals, and tars. The gas requires cleaning before it is introduced in the engine or boiler. Most of these processes generate significant concentration of tars. The tars can vary from very low molecular weight to large and complex chains.

    By Macrotek Inc. based in Markham, ONTARIO (CANADA).

  • Premium

    High technology gas generators for air monitoring industry

    Air Monitoring Industry.

    By Leman Instruments SAS based in Archamps, FRANCE.

  • Oxygen Generating Systems for Waste Gas Treatment in the Semiconductor, PV and LED Industries

    Waste gas treatment is an often overlooked but important function of Semiconductor, PV and LED fabrication. Several serious accidents have taken place in factories where no abatement was installed. Even today waste treatment is often seen as a cost rather than a safety issue. There are three main reasons why waste gas treatment is installed in factories: health and safety, environmental factors, and quality control.

    By Oxygen Generating Systems Intl. (OGSI) based in North Tonawanda, NEW YORK (USA).

  • Premium

    Hazardous waste treatment solutions for oil and gas industry

    There are a wide amount of applications for our VacuDry® process within the oil and gas industry. A large variety of wastes and by-products that are generated in the oil & gas production chain can be treated effectively and sustainably. In past decades, numerous thermal desorption processes have been implemented worldwide, using a variety of heating chamber designs to separate hydrocarbons from the mineral solids. Such standard TDUs work under atmospheric pressure which can lead to safety risks, high energy consumption, larger emissions and limited flexibility regarding altering feed materials. Due to its unique design, the complications outlined above are avoided throughout the VacuDry® process. When it comes to treating standard oily wastes, mercury-containing waste streams, NORM, and especially for the recovery of highly valuable drilling fluids from drill cuttings; our vacuum thermal desorption process (i.e. vacuum distillation) is economically unbeatable.

    By econ industries GmbH based in Starnberg, GERMANY.

  • Waste gas treatment for the semiconductor industry

    In the early 1990s no appropriate and comprehensive technical solution had been available for waste gas treatment in the semiconductor industry. Back then as well as today many industrial and research production procedures use process gases and generate waste gases. These waste gases, considered greenhouse gases, are toxic and/or highly flammable and very often pose a significant risk to production facilities and the environment. The semiconductor industry, for instance, uses perfluorocarbons, whose global warming potential is extremely high and therefore requires an efficient waste gas treatment. Combining and transporting different gases into a fab’s central waste gas system might produce highly flammable and highly explosive gaseous mixtures, which in the past has occasionally caused the total loss of entire production facilities. Particles contained within gases may also cause exhaust blockages. To eliminate these risks, process waste gases need to be treated at the “Point-of-Use” (POU) where harmful exhausts are abated immediately.

    By DAS Environmental Expert GmbH based in Dresden, GERMANY.

  • Premium

    Single Gas Monitoring - Fixed in-situ Duct Path

    Application: Measurements of single gas species through a fixed in-situ duct path. Example: Monitoring NH3 emissions in coal fired power generating stations.

    By Boreal Laser Inc. based in Edmonton, ALBERTA (CANADA).

  • Premium

    Air filtration and gas purification solutions for industries

    Within the industrial sector there are specific installations which should pay maximum attention to the protection of their control rooms against corrosion. This is because their activities generate highly corrosive gasses which need to be eliminated in case they affect the functioning of critical electrical equipment. This corrosion compromises the efficiency and safety and can affect the production process itself.

    By Bioconservacion SA based in Barcelona, SPAIN.

  • High performance separation system for ethylene industry

    Fundamental building block chemical used in the production chain of polyethylene, PVC, styrene, ethylene glycol, vinyl acetate, linear ∂-olefins and a host of other chemical products. Eliminate hydrocarbons in Quench Water system, minimize fouling, provide greater system reliability, lower maintenance, lower energy costs. Quench water contains emulsified heavy aromatic hydrocarbon (SG = 0.975). Cracked hydrocarbons are extremely reactive. Polymerization leads to fouling of quench system, exchangers, dilution steam generator. Fouling reduces plant profitability and on-stream reliability.

    By Pentair Filtration Solutions, LLC based in Conroe, TEXAS (USA).

  • Dustless Lead Paint Removal & Nuclear Decon Tools for Power, Oil and Gas Industry

    Pipelines, large fuel storage tanks, transformer pads and countless power generating systems have been decontaminated and prepared for a fresh coat of paint in one step! There is no costly containment to setup before starting the job or additional cleanup after it’s done, because our shrouded power tools capture dust before it’s emitted. Our powerful HEPA vacuum deposits hazardous waste directly into a 55-gallon drum, safely sealed and ready for transport when full.

    By Pentek Inc. based in Coraopolis, PENNSYLVANIA (USA).

  • Oxygen Generating Systems for Use with Ozone Generators

    Twice the output of air-fed systems . . . As customers demand more ozone for less capital investment, oxygen is quickly replacing air as the industry’s preferred feed gas. Ozone output normally doubles when 93% oxygen is fed into the corona discharge.

    By Oxygen Generating Systems Intl. (OGSI) based in North Tonawanda, NEW YORK (USA).

  • Energy from biogas and natural gas for the waste to energy industry

    You are a farmer/entrepreneur and would like to make money from generating electricity and heat? Then you have come to the right place. Within just a few years Dreyer & Bosse Kraftwerke GmbH have advanced to become one of the leading manufacturers of combined heat and power stations on biogas basis - we have available a complete product portfolio for energy applications of biogases or biomethane.

    By Dreyer & Bosse Kraftwerke GmbH based in Gorleben, GERMANY.

  • Premium

    Gas analysis & monitoring system for gas purity

    The purity of a gas is an indication of the amount of other gases contained in it. A high purity refers to a low amount of other gases. High purity gas are considered to be of better quality and are generally more expensive. The purity of the gas can be expressed as a percentage or as a decimal fraction. Applications for checking the purity of the gases across different industrial sectors by air separation plants, cryogenic facilities, the quality control of industrial gases to the steel mills, etc.

    By ETG Risorse e Tecnologia based in Montiglio, ITALY.

  • Nitrogen Generator Specialty Beverage Systems

    The importance of the right nitrogen generation system for beverage storage, CO2 mixing, transporting, and dispensing to your end users can’t be overstated. That’s why it is critical to work with the right company to supply you with the best nitrogen generation beverage system in the industry, and that’s Gas Control Systems.

    By Gas Control Systems, Inc (GCS) based in Sparta, MICHIGAN (USA).

  • Premium

    Odor control for refining/petroleum

    You refine the fuel, we’ll remove the odors. Oil refineries and petrochemical plants may generate large volumes of odor from the processing and refining of different fuels. Sulfides, mercaptans, and hydrocarbon compounds are all closely related to the oil industry. The odors generated from these industrial compounds are of a high nuisance value and generally create concern among local air boards and the public. Ecosorb odor removal products may be used in a variety of areas around the refinery including water treatment facilities, sludge ponds, sulfur recovery units, and API separators. To remove odors during tank cleaning and maintenance operations, portable dispersion systems can be used in the immediate work area to control malodors. Ecosorb products can be directly injected into flues and stacks and may be used as a substitute scrubbing solution in some applications.

    By OMI Industries (OMI) based in Long Grove, ILLINOIS (USA).

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you