Real Tech’s analyzers can be used in municipal wastewater treatment applications to ensure environmental compliance and to increase process efficiency by continuously monitoring the incoming loads and making process adjustments accordingly to optimize aeration rates, and nutrient and chemical dosing.
Pollution Risk: Surface water encompasses storm water derived from hard standing areas, river water and reservoirs. All types of surface water are at risk from ingress of pollution and therefore need to be monitored. On-line continuous monitoring can identify and alarm pollution so corrective action can be taken
Industry and municipal waste-water (sewage) treatment plants have had to respond to environmental legislation such as the Urban Waste Water Directive, IPC, IPPC and now the EPR (Environmental Permitting Regulations). As successive legislation becomes more stringent, discharge consents have been progressively tightened, and the need for self-regulation has become more important. As a consequence, on-line instrumentation has been installed throughout waste-water industry to continuously to provide final effluent...
Industry has had to respond to the requirements of progressive environmental legislation such as the Urban Waste Water Directive, IPC, IPPC and now the EPR (Environmental Permitting Regulations). As successive legislation becomes more stringent, discharge consents have been progressively tightened, and the need for self-regulation has become more important. As a consequence, on-line instrumentation has been installed throughout waste-water industry to continuously to provide trade discharge monitoring and perform...
Improved monitoring and automation can deliver more efficient waste treatment and reduced energy consumption and improved effluent quality. The cost of treatment and the quality of effluent discharge can thus be significantly reduced.
Improved waste management through automation can deliver more efficient waste treatment, reduced energy and chemical consumption and improved effluent quality. The cost of treatment and trade discharge can thus be significantly reduced.
Demineralization is the process of removing mineral salts as well as organic impurities from water by means of ion-exchange and can be found in various industries such as the chemical, food & beverage, irrigation and filtration industries. The consuming side of the industry relies on ever increasing quality and availability of demi-water while the manufacturers have to balance cost/output. AppliTek provides high quality analytical tools to increase process efficiency and quality control. Continuous measurements...
Automation can save money, optimise a process and give warning of potential breeches of discharge consent. However, instrument selection is fundamentally important if a control system is to function efficiently. The measurement device must accurately and quickly respond to process variations and it must be reliable in operation if the control system is to function as intended. Designed properly, energy and chemical use can be significantly reduced, saving money and ultimately improving effluent quality.
Sometimes an `off the shelf` water quality monitoring product is just not available and it is necessary to engineer a complete bespoke monitoring solution. System integration demands a diverse range of abilities. PPM is experienced in designing the correct suite of instrumentation combining manufactured, distributed and factored products.
Problem: Trace contamination in ultrapure water (UPW) can have detrimental effects on a manufacturing process in Semiconductor, Power Generation and Pharmaceutical industries. Onsite treatment is conducted to further remove trace impurities from source water.
Boost operational efficiency, prevent fracking water contamination and ensure regulatory compliance at your shale oil and gas site. In-Situ’s EPA-approved fracking water quality technologies help you achieve best practices at lower cost, protecting your company and water resources.
Easily and accurately assess the physical, chemical, and biological characteristics of any aquatic system. From spot sampling to long-term remote monitoring, In-Situ has the right equipment for your surface water quality monitoring project.
Intake protection systems have been extensively installed to protect water treatment works, from ingress of polluted water and waste-water plants from toxic chemical loads. A suitable system typically comprises a suit of instrumentation, measuring key chemical, physical and indicator parameters dependant upon the identified risks, associated with the individual site activity or discharges from neighbouring industry.
The monitoring of Turbidity is key requirement of the water industry in both water supply and water recovery systems. Within the water supply process, monitoring of turbidity allows operators to assess the efficiency of filters for particulate removal through the process. Similarly, with water recovery (Waste Water Treatment Works), the measurement of turbidity is a key parameter to track the removal of particulate through the process. CTG can provide turbidity measurements with the UniLux sensor, or provides...