Only show results available in Virginia? Ok

leak pressure testing Applications

  • Smoke generator device for leak testing & building envelope testing

    Smoke is the perfect medium for discovering where leaks are and how big they are! Filling a `leaky` building, ductwork, pipes, aircraft or containment area with smoke and ideally adding a small amount of pressure to the area being tested, will result in a visible discharge of smoke and, simply put, the greater the volume of smoke, the bigger the leak. After Concept developed a bespoke system for their aircraft testing requirements, a spokesperson for the RAF commented: `The use of smoke as a means by which to detect cabin pressurisation leaks has been shown to be extremely effective and is unquestionably superior to any alternative detection method used to date!`

    By Concept Smoke Systems based in Maidenhead, UNITED KINGDOM.

  • Premium

    SF6 Leak Detection

    Monitoring Sulfur Hexafluoride (SF6) in the Power Utility Industry. Monitoring Sulfur Hexafluoride in the Power Utility Industry The SF6 Leak Detector 3434i from LumaSense offers an unmatched combination of performance and convenience. Based on the company’s Photoacoustic Spectroscopy (PAS) technology, the system offers highly accurate, reliable and stable quantitative gas analysis and detection. The growing environmental requirements and pressures regarding the use of SF6 make LumaSense’s system a coveted tool designed for everyday use. The system is able to measure the total concentration of the SF6 gas in an enclosed area, where the switchgear (or other SF6 filled equipment) is tested. Although only the total amount leaked is required by today’s standards, it is also advantageous to be able to pin point the leaks. This makes it easier to improve the integrity of the equipment. The SF6 Leak Detector system meets all of requirements for confined area such as substation Monitoring.

    By LumaSense Technologies, Inc. based in Santa Clara, CALIFORNIA (USA).

  • Premium

    Compressed air measurement & control flow solutions

    Compressed air isn`t free, so more and more companies carefully monitor its usage. Thermal flow meters are ideal for this application. Because our thermal flow meters measure mass flow directly, no temperature or pressure compensation is required. Thermal flow meters also have a very high turndown, allowing the same flow meter to measure very low leak rates as well as full operational flows.

    By Sierra Instruments, Inc. based in Monterey, CALIFORNIA (USA).

  • Premium

    Sewage Treatment Plants and Flow Sensors for Industry Application

    In sewage treatment plants, flow sensors are primarily installed for internal reasons. Ultrasonic flow meters are used to control the flow velocity in partially filled and fulfilled pressurized pipes, specific plant components, for leak detection or to control the use of additives. International regulations such as the EU-Directive for handling municipal waste water require flow metering for a continuous surveillance of waste water flow. Defective flow monitoring in sewage-treatment plants can therefore influence their operation, but there can also be legal or environmental consequences.

     

    By HydroVision GmbH based in Kaufbeuren, GERMANY.

  • Smoke generator device for building envelope, energy studies & air tightness testing

    The air tightness or leakage rate of a building is the uncontrolled flow of air through holes, gaps and cracks in the fabric of a building, which may not be detectable simply by looking at the outside of the building. Filling a building or void with smoke and pressurising that volume, will result in a visible discharge of smoke from any problem areas. Smoke is the perfect medium for discovering where leaks are and how big they are! Filling a `leaky` building, ductwork, pipes, aircraft or containment area with smoke and ideally adding a small amount of pressure to the area being tested, will result in a visible discharge of smoke and, simply put, the greater the volume of smoke, the bigger the leak.

    By Concept Smoke Systems based in Maidenhead, UNITED KINGDOM.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you