Only show results available in Virginia? Ok

level monitoring system Applications

  • Premium

    Ambient air quality monitoring solutions for street-level monitoring

    To measure the air quality in a city is a challenge. A large number of gaseous components need to be measured with high accuracy. The monitoring site needs to be representative for the city and the system has to be easy to maintain and calibrate. The OPSIS open-path monitoring systems provide a flexible solution, giving the average concentration for an area. A single OPSIS system can measure all relevant gaseous components set by the authorities, such as NO, NO2, SO2, O3, BTX, NH3.

    By Opsis AB based in Furulund, SWEDEN.

  • Measurement and control systems for the Indicating the level - mechanically

    Depending on the regulations, a steam boiler must be equipped with one or more direct and/ or indirect level gauges. With direct level gauges, the liquid level can be seen directly through a glass or mica window. The use of a transparent level gauge with background illumination gives operating staff a clear separation between the water and steam zones even when viewed at a relatively long distance. Bicolour level gauges (black and white or green and red) are very suitable for camera transmission to the measuring...

    By IGEMA GmbH based in Münster, GERMANY.

  • Measurement and control systems for the controlling the level - electronically

    Discontinuous control is used mainly in smaller steam boilers with low output since the temperature fluctuations in the boiler are fairly great as a result of irregular refilling with water. Continuous control, on the other hand, permits still more economical steam generation with high quality.

    By IGEMA GmbH based in Münster, GERMANY.

  • Measurement and control systems for the Limiting the level - electronically

    A distinction is made between low water (LW) and high water (HW) limiters. Whereas LW limiters are in principle required for the safe operation of a plant in accordance with European regulations, HW limitation (overfill protection) is required only in accordance with TRD 604 for 72-hour operation.

    By IGEMA GmbH based in Münster, GERMANY.

  • Continuous Emissions Monitoring Calibration Systems (CEMCS)

    The Environics Series Continuous Emissions Monitoring Calibration Systems (CEMCS) have been used in CEM vans and laboratories for over twenty years. They meet or exceed the performance requirements of the United States EPA 40 CFR Part 51 Method 205 Appendix M. Our systems are custom built, computerized, mass flow controller based gas calibration systems which allow you to dilute a single high concentration cylinder of span gas to low levels for the calibration of gas analyzers.

    By Environics, Inc. based in Tolland, CONNECTICUT (USA).

  • Gas analysis & monitoring systems for greenhouse gases analysis

    The rising levels of manmade greenhouse gases (GHGs) in the atmosphere and their resulting impact on climate is now one of the single biggest technological and environmental challenges facing the world. This makes intensified monitoring of these gases more critical than ever in order to better quantify the role of the numerous natural and manmade sources, sinks and buffers involved in the cycles of GHGs. It also enables us to objectively audit GHG fluxes at the factory, city, country and continental level....

    By ETG Risorse e Tecnologia S.r.l. based in Montiglio, ITALY.

  • Premium

    Sound level meters & Noise dosimeters for Motorsport noise measurement and monitoring industry

    Our noise measurement instruments are used at high profile circuits and venues around the world, helping owners, operators, teams and officials comply with noise limits and regulations. With a range of noise measurement tools including drive-by test systems with permanently installed and portable monitors for continuous measurement of vehicles, to handheld sound level meters for pre and post race scrutineering, we can help you monitor and control your noise levels on track, in the pits and in the surrounding...

    By Cirrus Research plc based in Hunmanby, UNITED KINGDOM.

  • Premium

    Gas monitoring instruments and systems for process NOx measurement

    Nitric acid HNO3 is an important intermediate reagent for production of several important end products, such as fertilizers, explosives, dyestuffs/pigments, pesticides, pharmaceuticals, photographic materials, plastics, and synthetic fibers. At nitric acid manufacturing plants, the Gasmet™ FTIR Gas Analyzer can be used to measure several gaseous components from the process stream for purposes of process control. A single system can be used to measure the high levels of nitrogen monoxide NO and nitrogen...

    By Gasmet Technologies Oy based in Helsinki, FINLAND.

  • Premium

    Sound level meters & Noise dosimeters for Aircraft & airport noise monitoring industry

    In most applications, the object of an Airport Noise Monitoring System is to monitor and ultimately, manage and control the noise levels generated by aircraft movements in and around the airport.

    By Cirrus Research plc based in Hunmanby, UNITED KINGDOM.

  • Premium

    Marine monitoring solutions for the SO2/CO2/NOx monitoring

    Process control of a SO2 scrubber on a ship is a challenge due to wet and corrosive gases. In such environment, extractive gas sampling systems require high levels of maintenance in order to operate correctly. OPSIS monitoring system solves this by using an optical, non-contact, cross-duct technique. A light beam is sent across the duct or stack to be measured, and the captured light is sent through an optical fibre cable to an analyser. The analyser measures SO2, CO2 and NOx concentrations using UV and IR...

    By Opsis AB based in Furulund, SWEDEN.

  • Premium

    Monitoring solutions for the De-NOx plants

    In recent years the number of Selective Catalytic Reduction (SCR) and Selective Non-Catalytic Reduction (SNCR) plants for De-NOx have increased significantly. Continuous analysis of NOx prior to the de-NOx plant is often required to measure the concentration generated by the combustion process. This may be required to provide feed-forward to the Ammonia/Urea injection system and also to allow the effectiveness of the reduction process to be assessed. Continuous analysis of NOx post-reduction is required to...

    By Codel International Ltd based in Bakewell, UNITED KINGDOM.

  • Meteorological systems for weather sensors, components & accessories

    At the core of Climatronics’ meteorological monitoring systems is a complete complement of weather sensors, components and accessories. These weather sensors cover the range of each variables’ environmental range, and can be provided with a level of accuracy that matches each user’s requirements.

    By Climatronics Corporation based in Bohemia, NEW YORK (USA).

  • Measurement solution for to multi-stream by-pass system

    A large pharmaceutical plant runs a Thermal Oxidiser on plant to incinerate their solvent-containing gas streams before emission. When the oxidiser is offline, then the plant must monitor the release of solvent to the atmosphere. A ProtIR 204C fixed monitoring system was installed that continually measures 24 plant solvents, including Acetone, Cyclohexane, DCM, DMF, IPA, MIBK, Toluene and THF. Given the high levels that are possible, the system has an active dilution system, reducing the concentration of the...

    By Protea Limited based in Middlewich, UNITED KINGDOM.

  • Premium

    Air sampling & monitoring systems for biomedical, chemical & pharmaceutical industry

    HI-Q Environmental Product Company provides air sampling instrumentation & systems for several niche applications in a number of disciplines in the broad area of `Life Sciences`. In the Biomedical, Chemical, & Pharmaceutical industries, HI-Q has marketed instrumentation for certain applications for many years. Our ambient, in-door breathing level air samplers, commonly known in the industry as `Goose-Neck` or `Giraffe` air samplers have been instrumental in analyzing workplace exposure. HI-Q has also...

    By HI-Q Environmental Products Company based in San Diego, CALIFORNIA (USA).

  • Real-time In-situ Effluent Monitoring

    The UviLux BOD Indicator enables in-situ, real-time, reporting of BOD within both natural water systems and water processing plants. The monitor detects fluorescent proteins that are inherent within sewage and slurry and provides an output in BOD equivalent units. The principle behind the measurement is the excitation of Tryptophan-like fluorescence within UV wavelength band, which has been shown to correlate with both BOD and bacterial contamination. With complete flexibility of deployment methodology, the...

    By Chelsea Technologies Group based in West Molesey, UNITED KINGDOM.

  • Premium

    Data loggers and data acquisition monitoring solutions for the server room sector

    Large selection of high-accuracy data loggers suited for server room temperature monitoring. Monitor and record ambient temperature and RH%. LCD display, USB and WiFi communication options.Each server rack is vital to a data center’s operations, so server room temperature monitoring for this invaluable equipment isn’t optional; it’s necessary. Without environmental monitoring, businesses often suffer data loss or permanent damage to their server storage room equipment due to high temperatures,...

    By CAS DataLoggers based in Chesterland, OHIO (USA).

  • Measurement solution for ambient air workplace monitoring

    Protea can supply fixed workplace monitoring systems that can measure single or multi-points about the workplace. Specifically designed analytical systems can ensure detection limits down to ppb levels can be achieved for multiple gases with a single instrument. Controlling software can run automatically, providing instantaneous or time-weighted average readings.

    By Protea Limited based in Middlewich, UNITED KINGDOM.

  • Premium

    Data loggers and data acquisition monitoring solutions for the HVAC sector

    Large selection of cost-effective HVAC data loggers suitable for any application. Monitor and record temperature, RH% and CO2 levels. Simple, portable, easy-to-use models with WiFi, USB & Bluetooth options. HVAC data loggers for applications such as temperature monitoring in vents and ducts, humidity recording in storage areas, or logging CO2 levels in offices. Solutions are available to suit almost any application in need of HVAC monitoring systems that involve temperature, humidity, voltage or energy...

    By CAS DataLoggers based in Chesterland, OHIO (USA).

  • Cost effective, real-time pollution monitoring networks

    Ambient air pollution is a continuous problematic since many years, and the various organizations in charge of air quality monitoring work constantly on how to improve their structures and gain the most accurate and reliable data possible. Indeed, the changes in mentality and therefore in urbanism development for example, implies an access to the data faster and at multi-location level. Air quality monitoring reference stations used nowadays measure with an extreme accuracy in located areas, but requires a lot of...

    By ENVEA Cairpol (ex Environnement S.A) based in POISSY Cedex, FRANCE.

  • Premium

    Low concentrations monitoring of benzene and aromatic hydrocarbons (BTEX) for pollution control and environmental monitoring

    With over 15 years of experience in the measurement of volatile organic compounds (VOC), Environment SA announces the VOC72M, a new generation analyzer for the measurement of BTEX compounds by gas chromatography with photo-ionization detector (PID). The VOC72M can handle up to 40 compounds and eight configurations for analysis. This compact and fully automated analyzer with wide voltage range specifications (90-240V) provides equivalent performance to the laboratory chromatographs and is particularly suited to...

    By ENVEA based in Poissy, FRANCE.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you