Only show results in Virginia? Ok

liquid liquid separation Applications

  • Separation solutions for oil & gas industry

    Elgin Separation Solutions complete line of liquid / solid separation and dewatering equipment is fully compliant with all requirements for the oil & gas industry. Utilizing our closed loop technology project sites will be able to reclaim clean water and recovered drilling fluid that is cost effective and environmentally safe. Featuring shale shakers, decanter centrifuges, vertical cuttings dryers and dewatering systems.

    By Elgin Separation Solutions based in Stafford, TEXAS (USA).

  • High performance separation system for glycol dehydration

    Glycol dehydration is a liquid desiccant system for the removal of water from natural gas and natural gas liquids (NGL). It is the most common and economic means of water removal from these streams.Glycols typically seen in industry include triethylene glycol (TEG), diethylene glycol (DEG), ethylene glycol (MEG), and tetraethylene glycol (TREG). TEG is the most commonly used glycol in industry.

    By Pentair Filtration Solutions, LLC based in Conroe, TEXAS (USA).

  • High performance filtration & separation system for amine

    There are a number of factors that affect the capacity and operation of a typical amine system. Solid or liquid contaminants in the system may cause foaming. The presence of foaming is typically addressed by the addition of expensive antifoam chemicals and/or by reducing the operating capacity of the amine system. In addition to this, the presence of contaminants in the system can foul heat exchangers and column packing or trays. These solid and liquid contaminants are either ingressed into the system with the...

    By Pentair Filtration Solutions, LLC based in Conroe, TEXAS (USA).

  • Premium

    Filtration solutions for circuits protections; nozzles, injectors, etc.

    The installation of an AZUD System eliminates the risk of clogging of nozzles, injectors, tubes and other small openings by removing the larger particles from the liquid flow.  It also helps in decreasing scale build up in the system and the accumulation of solids settling in the collection sump.

    By Sistema Azud, S.A. based in Alcantarilla, SPAIN.

  • High performance separation system for fuel gas streams

    Fuel Gas Streams are frequently contaminated with liquid aerosols. The liquid exists as a stable and persistent “smoke” in the gas stream. The liquid contaminant can enter the gas stream through any one of a variety of events including – phase separation and condensation, compressor lube-oils from compression, chemical addition to pipelines (including corrosion inhibitors), and entrainment from overheads of contact towers.

    By Pentair Filtration Solutions, LLC based in Conroe, TEXAS (USA).

  • Natural gas gathering system for inlet gas separation

    Natural gas gathering systems deliver large volumes of gas via pipleline to the central inlet of the gas processing facility. Removal of solid contaminants and free liquids present in the inlet gas is critical to the downstream process. Iron oxides, iron sulfides, dirt and other deformable particles can flow into the processing system. Effective removal of these contaminants is needed to prevent fouling. Pentair Porous Media technologies will help with a clean, natural gas feed, reducing upsets and associated...

    By Pentair Filtration Solutions, LLC based in Conroe, TEXAS (USA).

  • Activated Carbon Filtration for the Water Filtration Industry

    General Carbon carries a complete line of activated carbon made from coal, coconut shell and wood for most liquid phase applications.  These include acid washed activated carbon for drinking water and food grade applications as well as products suitable for waste water remediation, decolorization applications, chemical and pharmaceutical purification. Additionally, our specialty medias are best for the treatment of non-emulsified oils and heavy metals. Our stock of activated carbon for liquid phase...

    By General Carbon Corp. based in Paterson, NEW JERSEY (USA).

  • Chlorine Dioxide Water Treatment for Reverse Osmosis Membranes Industry

    Biological fouling of reverse osmosis is a common problem leading to reduced efficiency and reduced membrane life. CleanOxide Liquid 75 is pure Chlorine dioxide which is a highly effective biocide ideal for use in reverse osmosis systems. CleanOxide Chlorine Dioxide has all the important regulatory approvals in Australia and overseas to be used in water treatment and food processing. Many strategies have been developed in an effort to control biofouling of Reverse Osmosis membranes including the use of sodium...

    By NW Solutions based in Perth, AUSTRALIA.

  • Premium

    Hazardous waste treatment solutions for metal industry

    Sludge by-products from the metalworking industry have a high potential for recycling. Prolonged grinding processes can generate large amounts of highly valuable, alloy-rich sludge; consisting of metal powder and cooling lubricants. Inside our VacuDry system, the thermal separation of the liquids (hydrocarbons, eventually water) and solids (metal powder) takes place in an oxygen free atmosphere. This absence of oxygen ultimately eliminates material degradation by oxidation, and self-ignition or explosion...

    By econ industries services GmbH based in Starnberg, GERMANY.

  • Premium

    Filtration technology for Industrial wastewater treatment

    AQQA is used in industrial wastewater treatment to: separate the sludge from the clear water in membrane bio reactors. constitute the final filtration of the effluent of standard sewage treatment plants (tertiary treatment). keep specialized bacteria in the system, that can biologically degrade organic matter. enable Zero Liquid Discharge: prefiltration for reverse osmosis systems.

    By Weise Water GmbH based in Hennigsdorf, GERMANY.

  • Premium

    Shredding solutions for aluminum cans

    The shredding process of aluminum cans, pressed or loosen, is done using two-shaft shredders. After that, in order to proceed with the briquetting phase, it is necessary to shred again the material using single-shaft, three- or four-shaft shredders for obtaining a controlled size. In addition to that SatrindTech offers customized solutions for a solid and liquid separation in case the material to be treated are filled cans.

    By SatrindTech Srl based in Arluno, ITALY.

  • Premium

    Wastewater evaporator Solutions for the air scrubber wastewater treatment

    Water wash air scrubbers are used for air pollution control in many industries that discharge gasses and smoke, to remove pollutants from the gas stream. A high-energy liquid spray washes the gas and removes pollutants from the air, These pollutants are then trapped in the water used for washing the gas. Safe disposal of air scrubber wastewater can be acheived by separating out the solids, using a Draygon Wastewater Evaporator.Draygon created the original "run-dry" evaporators, which can be run dry without...

    By Draygon LLC based in Venice, FLORIDA (USA).

  • Hydrogen sulfide removal in sludge management

    In the treatment of sanitary sewage, bio-solids are separated from the liquid. These bio-solids are concentrated and dewatered using filter presses, centrifuges, or other devices. Hydrogen sulfide and mercaptans are released during the dewatering operation.  Carus permanganates react quickly and produce immediate results for hydrogen sulfide removal in order to provide a safe, odor free environment and minimize corrosion due to sulfides.

    By Carus Corporation based in Peru, ILLINOIS (USA).

  • Oil skimmers for petro chemical industry

    The Mop type Oil Skimmer has many submissions in refinery plants. Some applications are comprised of cooling ponds, waste water, storage tanks etc. Due to its flexibility the Mop Skimmer can be functional to nearly any application during a refining plant where the fluctuating liquids and water needs separation. Ambar is experienced with explosion proof systems specifically designed for the Petro Chemical waste water applications.

    By Ambar Oil Skimmers based in Westwego, LOUISIANA (USA).

  • Environmental technology for gas cleaning industry

    For many decades now Körting gas scrubbing plants have distinguished themselves in diverse branches of industrial exploitation with great success. The principle components of these plants are the: The conversion of basic process engineering oparations for the exchanging of heat and materials such as cooling, physical and chemical absorption and dedusting permit separation and recovering of gaseous, liquid and solid materials from gases.

    By Körting Hannover AG based in Hannover, GERMANY.

  • Removal of impurities for food and beverage industry

    As a world leader in purification, separation, and concentration technologies, Calgon Carbon offers one of the largest selections of products and services in the food and beverage industry. By removing impurities such as color and odor from food liquids, syrups (e.g. sucrose, dextrose, glucose), organic acids, amino acids, vitamins, beverage alcohols, and glycerin, our products are vital to the production of high-quality, stable products.

    By Calgon Carbon Corporation based in Moon Township, PENNSYLVANIA (USA).

  • Oil Mist Seperator for Building Construction

    Contec oil mist separators ensures the façade design of ETFE cushions for efficient and environmentally friendly glare-, heat- and UV-protection. Contec GmbH, Bad Honnef is a leading manufacturer of filtration systems, oil mist separators and liquid level measuring technology. The use of the Contec oil mist separator (COMS) in the field of building construction is definitely very innovative and our system has proven again its advantages in environmental aspects.

    By contec GmbH Industrieausrüstungen based in Bad Honnef, GERMANY.

  • Wastewater Treatment for Municipalities

    PBS Velká Bíteš develops and manufactures machines for the separation of solid and suspended particles from liquids. The so-called "Decanter Centrifuges" can be used for a wide range of applications: from separation of municipal and industrial sludge in waste water treatment plants, through food and chemical industries up to agriculture. In the area of separation, we offer not only the decanter centrifuges themselves, but also the related services, including servicing of third-party...

    By PBS Velká Bíteš, a.s. based in Velká Bíteš, CZECH REPUBLIC.

  • Dominator despackaging machines for Plastics containers and bottles industry

    Depackage and separate plastic containers and bottles from their contents using the Dominator depackaging equipment. Recovered liquids or products can then either be pumped to a holding tank or conveyed into a bin for further processing. Recovered plastics can then either be sent for recycling or sent for reprocessing. Packaged microwave meals, plastic water bottles, fruit juice drinks, HDPE containers, liquid paperboard, polymer bottles can all be depackaged successfully.

    By Rowan Food and Biomass Engineering Ltd based in Gloucestershire, UNITED KINGDOM.

  • Filtration systems & solutions for biosciences and scientific industry

    The scientific community and in particular for that of the life science industries such as the medical, pharmaceutical  and healthcare, have a growing need for superior technologies and products in filtration, separation, purification, aeration and liquid transfer. The range of BioVyon materials and applications are continuously expanding, driven by new market requirements and available to both OEM and end user customers. Applications include separation or filtration for healthcare, medical and pharmaceutic...

    By Porvair Filtration Group based in Fareham, UNITED KINGDOM.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you