Only show results available in Virginia? Ok

nitrogen generator Applications

  • Nitrogen generation for the Marine, Oil & Gas industry

    Marine conditions pose a number of challenges and issues. Size, weight, rough sea conditions, corrosion, high temperatures, cargo needing protection, just to name a few.Oxymat’s Marine, Oil & Gas division produces nitrogen PSA generator systems to the marine industry with the necessary experience and know-how to address these issues. Compared to a traditional membrane based system, PSA systems significantly decrease redundancy and can cut energy consumption with up to 30%. In addition, a PSA system can produce 5% or lower oxygen levels.With the highest quality in components, PSA systems are extremely reliable with at least 48.000 running hours before CMS replacement is needed.

    By Oxymat A/S based in Helsinge, DENMARK.

  • Premium

    Nitrogen mass flow meters flow for solutions

    Sierra specializes in accurate mass flow measurement and/or control of Nitorgen gas. One of the most commonly measured gases, applications are found across numerous industries ranging from general process control to scientific research and development.

    By Sierra Instruments, Inc. based in Monterey, CALIFORNIA (USA).

  • Premium

    Gas analysis & monitoring system for gas generation

    The gas generators for calibration based on the use of “Method of Permeation Tubes.”. The permeation tubes are sealed capsules containing a small amount of the component that is in contact with a permeable membrane stable. The permeation through the membrane produces a vapor of the compound of the component of small quantity, very stable as a stream in time. This permeate stream by mixing with a dilution gas controlled and precise (for example nitrogen) creates a mixture in track at the desired concentration. The flow of the permeate is measured metrically through severe weight loss of the tube thus ensuring a standard high precision.

    By ETG Risorse e Tecnologia based in Montiglio, ITALY.

  • Oxygen Generating Systems for Sewage Treatment

    Using Oxygen to Solve Waste Water Problems Lack of oxygen can cause inadequate purification or even anaerobic decomposition, as well as offensive odors. Injecting oxygen into sludge beds &/or piping allows you to: * Reduce nitrogen levels * Meet peak O2 demands * Have a back up to your aeration system * Pre-purify waste water * Control odors * Deter corrosion damage * Meet increased requirements regarding waste water purification

    By Oxygen Generating Systems Intl. (OGSI) based in North Tonawanda, NEW YORK (USA).

  • Premium

    Continuous emissions monitoring in cement kilns

    Various pollutants form in the cement manufacturing process, especially when alternative fuels and waste-derived fuels are used. Typically a cement kiln using these fuels is a required to monitor hydrogen chloride (HCl). Gasmet CEM II is EN 15267-3 approved for HCl measurement in 0 … 15 mg/Nm3 range.High process temperatures result in generation of more nitrogen oxides (NOx) than in typical municipal waste incineration.

    By Gasmet Technologies Oy based in Helsinki, FINLAND.

  • Premium

    Gas monitoring instruments and systems for nitric acid process

    Modern production method of nitric acid production may lead to generation of several different gaseous emission components, such as nitrogen oxides (NOx), ammonia NH3 and nitrous oxide N2O. Nitrogen monoxide is an intermediate gaseous product in manufacturing of nitric acid HNO3. NO is formed in a catalytic reaction between ammonia and molecular oxygen O2. But undesirable side reactions may result in formation of nitrogen dioxide NO2 and nitrous oxide N2O. The NO and NO2 emissions can be reduced by use of Selective Catalytic Reduction unit (SCR), which deploys ammonia gas NH3 to limit emissions of NO and NO2. A modern nitric acid plant needs to monitor the emissions of these gases.

    By Gasmet Technologies Oy based in Helsinki, FINLAND.

  • Air Quality Monitoring Equipment for Combustion Industry

    Boilers and Combustion Research A fuel source burning with oxygen to produce carbon monoxide, carbon dioxide and water is an equation from school science lessons but looking into the fuel temperature and oxides of nitrogen produced along with the CO, CO2 and O2 is work that is being carried out by boiler makers, power generators and all sorts of industrial applications every day.

    By Signal Group Ltd based in Camberley, UNITED KINGDOM.

  • Premium

    Low concentrations monitoring of benzene and aromatic hydrocarbons (BTEX) for pollution control and environmental monitoring

    With over 15 years of experience in the measurement of volatile organic compounds (VOC), Environment SA announces the VOC72M, a new generation analyzer for the measurement of BTEX compounds by gas chromatography with photo-ionization detector (PID). The VOC72M can handle up to 40 compounds and eight configurations for analysis. This compact and fully automated analyzer with wide voltage range specifications (90-240V) provides equivalent performance to the laboratory chromatographs and is particularly suited to fixe or mobile ambient air quality monitoring laboratories. The VOC72M is fitted with a PID detector new generation, much more sensitive, more stable and whose lamp does not need to be cleaned; the analyzer integrates flow control fittings a 3 levels security system built on and uses only one gas (nitrogen). This robust and low maintenance instrument performs all the functions (sampling, analysis and data management) in a simple and completely autonomous mode. It is a particular

    By Environnement S.A based in Poissy, FRANCE.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you