Only show results available in Virginia? Ok

oil contamination Applications

  • Contaminated Soils with Diesel Fuel and Heating Oils

    Sitelab's UVF-3100D is used to test soil to help investigate and clean up sites contaminated by above ground or underground storage tanks (USTs). Soils can be analyzed for extended diesel range organics (EDRO) or extractable petroleum hydrocarbons (EPH). Results correlate well to confirmatory lab methods.

    By Sitelab Corporation based in West Newbury, MASSACHUSETTS (USA).

  • Rugged Mobile Technology for Contaminated Sites

    These handhelds use precise GPS information to speed cleanup of oil spill sites.

    By Hand based in Lidköping, SWEDEN.

  • Oil spill detection for offshore

    Leakwise systems can be installed off rivers, oil terminals, oil ports and other locations for the early detection of oil spills. Leakwise can significantly reduce the risk of major environmental contamination.

    By GE Analytical Instruments based in Boulder, COLORADO (USA).

  • Water removal filtration

    SAF is the key component for a wide range of enhanced nonwoven filter media fabrics that are designed for the removal of water and particulates from aviation fuel, automotive diesel and a wide range of oils. Such fabrics help reduce problems associated with water contamination in such situations. Its versatility gives rise to cost savings over traditional cellulosic-based absorption media, while offering full compliance potential to stringent international filtration standards – particularly in the aviation fuel and hydraulic oil markets. Applications: A significant reason for the majority of oil and fuel system failures is the presence of high water levels in dissolved, dispersed and free water. SAF-based filter media fabrics can remove both dispersed and free water to very low ppm levels at industry leading rates. This leads to reduced fuel and oil degradation and provides the required filter quality for efficient machine operation.

    By Technical Absorbents based in Grimsby, UNITED KINGDOM.

  • Sorbents

    SorbEater is a synthetic super-absorbent with the highest oil recovery ratio of ANY known absorbent material resulting in less product required and less product to dispose of. This provides significant savings on the costly disposal fees associated with hazardous waste. It is highly effective on fresh water, soil, sand and sea. During development it outperformed the traditional organic peat products in every test. Ideal for: Any hydrocarbon spills or contamination. It has been used successfully with Petrol, Diesel, Oil, Crude, Jet Fuel, Gasoline, Solvents, Paints, Resins, Blood, Molasses, Edible Oils, Certain Acid, Brake Fluid,Transformer Oils and Hydraulic Fluid.

    By Skyhawk Global Ltd based in Barry, UNITED KINGDOM.

  • PAHs in Sediment

    Sitelab's laboratory performed a 4 day site investigation testing PAHs in sediment on the West Branch Grand Calumet River in Indiana. Test data was used to fingerprint and map the river bottom contaminated with heavy crude oil.

    By Sitelab Corporation based in West Newbury, MASSACHUSETTS (USA).

  • Monitoring TPH in Produced Sand for Overboard Discharge

    Sitelab's TD-500D analyzer is used on offshore oil platforms to test TPH in produced sand. The sand is contaminated by crude oil and must be treated prior to overboard discharge in order to meet regulatory limits.

    By Sitelab Corporation based in West Newbury, MASSACHUSETTS (USA).

  • Industrial wastewater treatment systems for oil and gas industry

    Ecolotron, Inc. manufactures the world’s best electrolytic equipment and systems used in a variety of water and wastewater treatment applications. Ecolotron, Inc. applies patented E – FLOC technology to design and build electrolytic wastewater systems for the treatment and beneficial reuse of frac, flow-back and other produced waters associated with oil and gas exploration and production activities. E-FLOC technology uses a low Voltage electric current to destabilize multiple contaminates simultaneously via a single unit process. Both dissolved and suspended contaminates are removed, emulsions are split and water soluble hydrocarbons (TPH / BTEX) are oxidized as bacteria is also destroyed. With over 20 year of success in the oil & gas and water treatment industries, Ecolotron, Inc. provides custom engineered, turn-key solutions for the construction of centralized, produced water treatment systems and facilities.

    By Ecolotron, Inc. based in E. Dickinson, TEXAS (USA).

  • Premium

    Oil vapour removal for the manufacturing industry

    The mist eliminator prevents oil mist from contaminating air or soil, helping facilities to comply with environmental regulations. It also makes for a cleaner safer work environment by eliminating oil residue built-up on engine room floors, enclosure and stairwells, while improving indoor/outdoor air quality and reducing fire hazards. 

  • Instrumentation technologies for refineries

    The petroleum refining industry uses a wide range of processes, from separation, petroleum conversion, and petroleum treatment to waste water management. Each of these processes has its own challenges and all are made more complex by the variety of products and contaminants in the process.  Two key areas, from the water management perspective, are cooling water and waste water treatment.

    By Advanced Sensors Ltd. - part of PAC L.P. based in Carrickfergus, UNITED KINGDOM.

  • Oil Mist Separators for Shipbuilding

    A  Contec oil mist separator (COMS), type 9.200/762, with special frame construction for the lubrication system of the energy supply is being used on the latest cruise ship of the Celebrity Cruises shipping line. The energy requirements of the cruise ship - built by Meyer Werft Papenburg - is covered by four MAN Diesel & Turbo SE, type 14V48/60CR, diesel engines. The Contec oil mist separator, type 9.200/762, with upstream demister and M6 filter cartridge ensures the reduction of particle contamination. Throughput: 1,200 Nm³/h @ 50 Hz.

    By contec GmbH Industrieausrüstungen based in Bad Honnef, GERMANY.

  • Fat, Oil and Grease treatment

    Industrial and municipal waste contaminated with fat – a frequent problem for companies maintaining wastewater network infrastructure and municipal wastewater treatment facilities. We recommend the use of GREASOLUX fat dissolvent cartridges to avoid the problems of pipeline chocking, equipment damage, offensive odors, formation of filamentous bacteria, poor wastewater treatment results, poor sedimental properties of activated sludge. GREASOLUX – is a cartridge that slowly dissolves in water, enriched with special fat dissolvent microorganisms and enzymes. GREASOLUX – is an especially efficient product for low cost solutions to problems caused by fat: only few strategically placed cartridges will remove or minimize the problems caused by fat.

    By Ecochemicals UAB based in Kaunas, LITHUANIA.

  • Crude Oil Applications in Canada

    Sitelab's UVF-3100D analyzer is used in Canada for sites contaminated with heavy crude oil and bitumen.

    By Sitelab Corporation based in West Newbury, MASSACHUSETTS (USA).

  • Premium

    Machine condition monitoring for oil in water/soil


    Being able to trust your instruments to make quick, easy and accurate measurements in the field is key when dealing with regulatory requirements. The InfraCal2 infrared analyzer is the choice of experts for measuring oil in produced water; oil contamination in soil; and fats oil and greases in waste streams.

    By Spectro Scientific based in Chelmsford, MASSACHUSETTS (USA).

  • Gas detection analyzers for semiconductor industry

    Semiconductor manufacturing facilities employ a number of hazardous gases in their production processes. Whenever these gases are stored, distributed or used in manufacturing processes, there exists the potential for a hazardous condition. The primary hazards associated with these gases include fire, explosion, and contamination resulting in product loss or unscheduled preventative maintenance. These gases must be continuously monitored to ensure the health and safety of employees, to protect property, as well as to maintain regulatory compliance. Continuous gas monitoring in semiconductor facilities is a requirement of local and state regulations.

    By Control Instruments Corporation based in Fairfield, NEW JERSEY (USA).

  • Product and services for industrial - refineres industry

    For industrial customers, we offer cost-effective and environmentally attractive alternatives to oxidize, precipitate, segregate and remove unwanted pollutants, contaminants and by-products from waste streams and industrial processes. Whether using our time-proven CAIROX®, AQUOX®, and LIQUOX® permanganate-based products, our manganese based CARULITE® catalyst, or any of our other newly developed technologies, our long history and unmatched experience and environmentally friendly expertise provides customer specific solutions to many diverse industries.

    By Carus Corporation based in Peru, ILLINOIS (USA).

  • Aquatech Enhanced Oil Recovery (EOR)

    In a Steamflood Enhanced Oil Recovery (EOR) process, steam is injected in the well, lowering the viscosity of heavy oil suitable for extraction through the production wells. The fluid from the wells is a mixture of oil, water and gas and goes through a separation system to separate the three. The separated produced water is heavily contaminated with dissolved solids and hydrocarbons. Aquatech’s Steamflood Enhanced Oil Recovery (EOR) Technology offers the integrated solutions for the treatment EOR produced water for boilers, generating a purified product that can be reused for the production and injection of steam. Our turnkey approach to treatment includes coordinating the logistics of wastewater removal off-site and any sludge disposal.

    By Aquatech International Corporation based in Canonsburg, PENNSYLVANIA (USA).

  • High performance filtration & separation system for amine

    There are a number of factors that affect the capacity and operation of a typical amine system. Solid or liquid contaminants in the system may cause foaming. The presence of foaming is typically addressed by the addition of expensive antifoam chemicals and/or by reducing the operating capacity of the amine system. In addition to this, the presence of contaminants in the system can foul heat exchangers and column packing or trays. These solid and liquid contaminants are either ingressed into the system with the feed stream, or generated within it as a result of the chemistry of the system. These contaminants are typically addressed by means of particle filters and carbon adsorption.

    By Pentair Filtration Solutions, LLC based in Conroe, TEXAS (USA).

  • Determine Saybolt Color #3067

    Accurate online saybolt measurements from zero to +36. - Quantify yellowness for manufacturing control and product uniformity. - Ensure your product meets customer expectations - Detect potential cross-over contamination in fill or supply lines in real-time - Take the guess work our of product appearance standards - Application Note #3067

    By Guided Wave, Inc. based in Rancho Cordova, CALIFORNIA (USA).

  • Laboratory equipments for fat oil & grease FOG in waste water

    Measurement of Fats, Oils and Grease (FOG) in waste water is a crucial parameter in water quality control and environmental monitoring performed by water suppliers’ laboratories and environmental authorities; the contamination builds up in the sewerage system and will eventually lead to blockages. Typically the waste water is analysed by first passing a large volume through a filter then selectively determining the grease build-up on the dried filter by an analytical method.

    By Oxford Instruments plc based in Abingdon, UNITED KINGDOM.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you