Only show results available in Virginia? Ok

particle monitoring equipment Applications

  • Premium

    Aerosol and particle technology for process control industry

    In order to ensure that an industrial process can be controlled or even improved and optimized continually an analysis of the current situation in real time is necessary. Process data like temperature, pressure but also particle concentration and size distribution of a material flow can supply valuable information and be used for the regulation or the improvement of a process.

    By Palas GmbH based in Karlsruhe, GERMANY.

  • Premium

    Aerosol and particle technology for pressure & temperature industries

    The reproducibility of the devices has been approved by worldwide use. In order to avoid the condensation or vaporization of the particles during the particle measurement, the isothermal and isobaric particle generation and measurement is necessary.

    By Palas GmbH based in Karlsruhe, GERMANY.

  • Premium

    Gas analysis & monitoring system for semiconductor

    The Cleanroom is a combined laboratory chemical, mechanical and / or electronic whose main characteristic is the presence of very pure air, that is a very low content of fine dust in suspension. In the process of semiconductor production, the airborne particles (micro-powder) go to irreparably damage the micro-photoetched that form the chip, creating an electronic circuit defective, and then discarded. This process has forced the improvement of industrial production environments, removing particles from the air, for two purposes: to increase the efficiency of production, increasing the yield of quality, and requirement of the manufacturer (of course based on the demand of the market) in shrink increasing the area of etching of semiconductors (just think of the USB storage media in a few years, went from 16 MB to 16 GB without changing the external dimensions).

    By ETG Risorse e Tecnologia based in Montiglio, ITALY.

  • Radionuclide Monitoring for Nuclear Power Plants

    The continuing establishment of nuclear power stations around the world pose unique environmental challenges for their operators. Ecotech provides air samplers to nuclear power plants for sampling of radionuclides. A nuclear power plant`s radionuclide monitoring network enables continuous sampling of airborne particles onto sample filters contained within High Volume Air Samplers. These filters are then analysed in a laboratory in order to screen for any radiation releases. The challenge has always been to obtain a sufficiently large volume through the filter in order to exceed the laboratory methods minimum detection limits. Ecotech`s MegaVol Sampler, samples at a flow rate of between 120-150 m3/hr providing a high flow rate in order to collect a sufficient sample mass for laboratory analysis. The MegaVol will maintain volumetric flow rate at a preset volume until the filter is either changed or overloaded. The MegaVol can be equipped with a 3G modem in order to remotely monitor flow rate and other diagnostic parameters such as temperature, pressure and wind speed and direction.

    By Ecotech Pty Ltd based in Knoxfield, AUSTRALIA.

  • Filtration for Flue Gas Analysis and CEMS

    Three Steps of CEMS: 1st Step: Gas Sampling 2nd Step: Gas conditioning and treatment 3rd Step: Measurement/Calibration In first step, the function is to get sample gas and forward to 2nd step for treatment. During this step, it cannot block the probes and cannot result condensation of moisture. So a filter online back flushing should be equipped in this part. The filters to be used: 1, Filter is used to ensure the stability of system and reduce the maintenance 2, Filtration Grade: usually 2 or 3 micron 3, Temp. is around 0-180 deg C 4, Back flushing gas is heated, impulse flushing 5, Filter Material: Titanium Sintered, SS316L Sintered, PTFE sintered, Ceramic Membrane and so on 2nd Step Gas Treatment: #11;The coarse filters and the liquid particle filters The coarse and fine cartridge can filter the small particles in the gas and acid aerosol things to better protect the instruments. The micron can be 0.1micron, filtration rate can be up to 99.99%, two layers can be 99.9999%

    By Shanghai CMI Environmental Technology Co.,Ltd. based in Shanghai , CHINA.

  • Smoke generator device for PPV & impulse ventilation testing

    When water-based artificial smoke is introduced into a rapidly moving air stream, the particles that make up the artificial smoke evaporate much more quickly than they do in a static environment. So if you are looking to produce an artificial smoke that better represents the smoke created by a real fire, we would always recommend the ViCount smoke generator, the smoke from which is virtually unaffected by fast moving air streams. Used world wide PPV training centre`s and to test impulse ventilation systems. A Home Office report into PPV (Positive pressure Ventilation) by the Head of the Fire Experimental Unit, Fire Research & Development concluded that the concept behind the technique of PPV was relatively easy to understand and the equipment simple to operate, but stressed the need for extensive training.

    By Concept Smoke Systems based in Maidenhead, UNITED KINGDOM.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you