Only show results available in Virginia? Ok

petroleum contamination Applications

  • Contaminated Soils with Diesel Fuel and Heating Oils

    Sitelab's UVF-3100D is used to test soil to help investigate and clean up sites contaminated by above ground or underground storage tanks (USTs). Soils can be analyzed for extended diesel range organics (EDRO) or extractable petroleum hydrocarbons (EPH). Results correlate well to confirmatory lab methods.

    By Sitelab Corporation based in West Newbury, MASSACHUSETTS (USA).

  • Complete Bioremediation of site contaminated with Fraction 2 petroluem hydrocarbons

    Delta had been contracted during the 2014 remediation at the well site to apply their bioremediation process to excavated and stockpiled soil contaminated with Fraction 2 petroleum hydrocarbons (F2 PHC). Soil sample results from a 2014 Phase II ESA showed F2 PHC concentrations ranging from 170 mg/kg to 1210 mg/kg, with an average of 586 mg/kg in the four samples from the disposal area. Delta was on the site for around 10 hours using their hopper and amendment sprayer machine to treat the approximately 600 cubic meters of fine–grained contaminated soil. The treated soil was conveyed back into the excavation so the bioremediation process could continue. The client retained Gulo Environmental for sampling of the amended soil piles in May of 2015. Results from the analysis of the samples, taken approximately nine months after the bioremediation process, showed non-detection for F2 PHC, resulting in successful closure of the site.

    By DELTA REMEDIATION INC based in Spruce Grove, ALBERTA (CANADA).

  • Mining Applications Testing TPH in Soil

    Testing contaminated soils on-site for total petroleum hydrocarbons (TPH) is performed to monitor the progress of bioremediation activities at mining sites. Results only take a few minutes.

    By Sitelab Corporation based in West Newbury, MASSACHUSETTS (USA).

  • Premium

    Flare gas measurement flow meter applications

    Oil wells almost always produce natural gas (“associated gas”) along with the petroleum. In many cases, it is uneconomical to process due to heavy contamination. As a consequence, this gas is combusted, “flared” or simply vented as-is during upset conditions in the process. Newly updated EPA regulations like 40 CFR Part 60 Subpart OOOO (also known as Quad O) as well as the new RSR MACT rule for refineries, requires oil & gas companies to report the flare gas emitted to our atmosphere. Monitoring the fuel at the inlet of the flare is part of meeting these EPA requirements. Our QuadraTherm thermal mass flow meters with qMix gas mixing software are ideal for flare and combustion gas measurement.

    By Sierra Instruments, Inc. based in Monterey, CALIFORNIA (USA).

  • Instrumentation technologies for refineries

    The petroleum refining industry uses a wide range of processes, from separation, petroleum conversion, and petroleum treatment to waste water management. Each of these processes has its own challenges and all are made more complex by the variety of products and contaminants in the process.  Two key areas, from the water management perspective, are cooling water and waste water treatment.

    By Advanced Sensors Ltd. - part of PAC L.P. based in Carrickfergus, UNITED KINGDOM.

  • Soil and Groundwater treatment solutions for bioremediation industry

    Today bioremediation is successfully used as soil– and groundwater remediation technology. Many bioremediation systems, both in-situ as ex-situ techniques, usually result in considerable cost savings. Since the beginning of the 1980’s both in-situ and ex-situ bioremediation projects have been successfully completed worldwide through the use of preselected and adapted bacteria. QM Environmental Services supplies a range of microbial, bioactivator and nutrient products and gas delivery systems for the use in both aerobic and anaerobic bioremediation programs. Most common contaminants ranging from aliphatic hydrocarbons such as petroleum, lubrication oils, aromatic compounds like benzene and toluene to chlorinated solvents can be treated with these products.

    By QM Environmental International B.V. based in The Hague, NETHERLANDS.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you