Only show results in Virginia? Ok

power plant Applications

  • Premium

    Emissions Monitoring for Power Plants

    Opsis offers fully automated system solutions for continuous monitoring in power plants. The monitoring systems have been approved by the German TÜV and the U.S. EPA among others.

    By Opsis AB based in Furulund, SWEDEN.

  • Premium

    Flow measurement in turbine intake for power plants

    Application: Rectangular channel 7.8 x 2.0 m (w x h). Part filled. Concrete walls due to bridge. Natural bed.

    By NIVUS GmbH based in Eppingen, GERMANY.

  • Premium

    Control corrosion for power plants

    By InduMar Products, Inc. based in Houston, TEXAS (USA).

  • Premium

    Monitoring oil in power plant cooling water

    The TD-4100 utilizes a non-fouling, non-contact flow cell which requires little to no maintenance, and uses fluorescence technology to accurately detect oil in water from low ppb to high ppm. For this application, the TD-4100 monitors oil in water at 1 to 5 ppm and signals an operator with an alarm when the concentration exceeds the high alarm relay set-point.

    By Turner Designs Hydrocarbon Instruments, Inc. based in Fresno, CALIFORNIA (USA).

  • Premium

    Water treatment chemicals for power plants industry

    Today’s power industry is already subject to strict official regulations. These rules will only become more stringent in the future. As a result, environmentally friendly, cost-effective solutions that ensure plant and operational safety are in high demand.

    By Kurita based in Tokyo, JAPAN.

  • Premium

    Water treatment for power plants

    The process of electricity generation from fossil fuels such as coal, oil and natural gas is water-intensive. Between 40-50% of all water abstracted and used in developed countries is used in the generation of electricity. Thus, a reliable, abundant and predictable source of raw water supply to a power plant is a critical factor in site selection. Water supplies are required to provide various process waters for the following essential main purposes such as make-up water, cooling water for steam turbine condensers, and auxiliary plant cooling water.

    The primary application of modern water treatment technology is to maintain the integrity and performance of the power plant. Critical plant applications have water purity or conditioning requirements that must be adhered to for safe, reliable and efficient power generation.

    Experience has shown that integration of water technology treatments with power plant design can be very important in reducing operational problems and component failures 

    At power plant worldwide there are increasing limitations on water availability and environmental restrictions on discharges. This is expected to promote measures for water conservation and to have an increasing influence on water treatment decisions. At power plant, the recycling of internal wastewater streams can extend from the recovery of individual high-quality waste streams, which can be reused either directly or after only limited treatment, through to the development of fully integrated water/wastewater treatment systems for zero liquid discharge. However, the application of reuse schemes requires site-specific assessment, as not all waters may be viable options for recovery.

  • Water Treatment for Power Plants

    By Canamidex International Corp. based in Richmond Hill, ONTARIO (CANADA).

  • Premium

    Continuous emissions monitoring for power plants

    OPSIS offers fully automated system solutions for continuous monitoring in power plants. The monitoring systems have been tested and approved by the German TÜV and the U.S. EPA among others, for the best performance and longest calibration interval.

    By Opsis AB based in Furulund, SWEDEN.

  • Environmental monitoring solution for power plant

    The construction of coal and natural gas power stations is continuing at a steady rate along with older power stations being retrofitted with more effective flue gas cleaning systems. Both the community and environmental protection authorities are paying closer attention to both emission and ambient concentrations around power stations.

    By Ecotech Pty Ltd based in Knoxfield, AUSTRALIA.

  • Radionuclide Monitoring for Nuclear Power Plants

    The continuing establishment of nuclear power stations around the world pose unique environmental challenges for their operators. Ecotech provides air samplers to nuclear power plants for sampling of radionuclides. A nuclear power plant`s radionuclide monitoring network enables continuous sampling of airborne particles onto sample filters contained within High Volume Air Samplers. These filters are then analysed in a laboratory in order to screen for any radiation releases. The challenge has always been to obtain a sufficiently large volume through the filter in order to exceed the laboratory methods minimum detection limits. Ecotech`s MegaVol Sampler, samples at a flow rate of between 120-150 m3/hr providing a high flow rate in order to collect a sufficient sample mass for laboratory analysis. The MegaVol will maintain volumetric flow rate at a preset volume until the filter is either changed or overloaded. The MegaVol can be equipped with a 3G modem in order to remotely monitor flow rate and other diagnostic parameters such as temperature, pressure and wind speed and direction.

    By Ecotech Pty Ltd based in Knoxfield, AUSTRALIA.

  • Chlorine Dioxide Water Treatment for Power Plants

    Chlorine dioxide is a significant product in the control of algae, planktonic and sessile bacteria, bio-film and scale in power plants, cooling towers, loops and cooling systems. CleanOxide helps maintain the efficiency of heat exchanger surfaces, reservoir intakes and ancillary equipment. Traditional oxidising agents such as chlorine and bromine, on the other hand, are associated with pH constraints and corrosion problems.

    By NW Solutions based in Perth, AUSTRALIA.

  • Stack Testing for Power Generation Plants

    POWER GENERATION INDUSTRY: Conducted detailed measurements of volumetric flow, oxygen, and carbon dioxide levels in huge main ducts in the Economizer Outlet, Air Heater Inlet, and Exhaust Stack locations in order to evaluate overall plant and control system performance

    By AirSource Technologies, Inc. based in Shawnee, KANSAS (USA).

  • Premium

    Advanced water treatment equipments for power plants industry

    We offer a complete line of solutions as follow: Desalination by reverse osmosis, brackish water reverse osmosis, multimedia filters, feed pump & feed pump skids, EDI, pre & post treatment options, membranes, softners, services & maintenance.

    By Advanced Equipment and Services based in Hollywood, FLORIDA (USA).

  • Premium

    Mass transfer and chemical separations applications for power plants

    Sulphur Dioxide Capture. Carbon Dioxide Capture.

    By Raschig USA Inc. based in Arlington, TEXAS (USA).

  • Mixers, dryers, innovative solutions for power plant technology

    Conditioning of Ash and Dust

    No matter where ash and dust accumulate, AVA continuous or batch mixers can condition them to a transportable final product for disposal or recycling. The applications range from power plant ash derived from lignite, hard coal, biomass, or waste incineration power plants to filter dusts from steelworks and coking plants through to special applications such as hot or reactive ashes from various processes, such as shale oil production.

    By AVA GmbH u. Co. KG based in Herrsching, GERMANY.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you