Only show results available in Virginia? Ok

process gas analysis Applications

  • Premium

    Medical Gas Analysis for Process Industry

    USP37 Medical Gas requires a specific, selective and positive identification test using a paramagnetic signal. Regular analysis of medical gas is required to ensure that the oxygen concentration is NLT 99.0% volume. Following the appropriate United States Pharmacopeia standards, in this case specifically USP37, requires an analyzer which uses a paramagnetic based technology.  The Systech Illinois Paramagnetic Oxgyen Analyzer PM700 is perfectly suited for this medical gas analysis application.

    By Systech Instruments Ltd based in Thame, UNITED KINGDOM.

  • Residual Gas Analysis

    Residual Gas Analysis is a general term for the analysis of gas and vapour species in vacuum chambers and vacuum processes. The Hiden RGA series quadrupole mass spectrometers provide for routine, fast, wide dynamic range residual gas analysis, measuring the partial pressures of the species that are critical to vacuum quality and process requirements. Applications include: vacuum chamber leak detection vacuum quality measurement and monitoring virtual leak detection outgassing studies bakeout cycle/vacuum pump down monitoring

    By Hiden Analytical based in Warrington, UNITED KINGDOM.

  • Flaring Solutions for Gas Processing Facilities

    ABUTEC’s proprietary technology was designed to provide cost-competitive solutions and the industry’s lowest operating costs and cost of ownership. Our uniquely engineered burner system offers a significant reduction in make-up fuel over premixed surface combustion systems, thermal oxidizers or traditional pipe flares. In addition, we meet EPA requirements for 40 CFR 60.18 and local BACT (Best Available Control Technology) and MACT (Maximum Achievable Control Technology) at the state and local levels. We will perform a complete return-on-investment analysis for you while showing you your total cost of ownership.

    By ABUTEC LLC based in Kennesaw, GEORGIA (US) (USA).

  • Premium

    Gas analysis & monitoring system for biogas analysis

    “Biogas” means a mixture of various types of gas (mostly methane) produced by bacterial fermentation in anaerobic conditions(absence of oxygen) of organic residues from waste, decaying plant, carcasses in putrescence. The analyzers of biogas by Infrared cells carry out the continuous analysis of CH4, O2, CO2, H2S and NH3. The whole process sees the decomposition of organic material by some types of bacteria, producing carbon dioxide, molecular hydrogen and methane(methane conversion of organic compounds).

    By ETG Risorse e Tecnologia based in Montiglio, ITALY.

  • Combustion gas analysis for the glass industry

    Flue-gas analyzers are designed to be rugged and accurate at the same time. They are used by the HVAC industry, energy industry, process control, glass industry, food industry, universities and analysis is required. 

    By IMR Environmental Equipment, Inc. based in St. Petersburg, FLORIDA (USA).

  • Premium

    Gas monitoring instruments and systems for process NOx measurement

    Nitric acid HNO3 is an important intermediate reagent for production of several important end products, such as fertilizers, explosives, dyestuffs/pigments, pesticides, pharmaceuticals, photographic materials, plastics, and synthetic fibers. At nitric acid manufacturing plants, the Gasmet™ FTIR Gas Analyzer can be used to measure several gaseous components from the process stream for purposes of process control. A single system can be used to measure the high levels of nitrogen monoxide NO and nitrogen dioxide NO2, as well as water vapor H2O, nitrous oxide N2O, carbon monoxide CO, carbon dioxide CO2 and ammonia NH3. The fixed installation products for these purposes are the Gasmet™ CEM II measurement system, and the Gasmet™ FCX Gas Analyzers, both of which utilize the FTIR measurement technique for simultaneous multicomponent analysis of the sample gas.

    By Gasmet Technologies Oy based in Helsinki, FINLAND.

  • Premium

    Gas analysis & monitoring system for medical imaging

    The molecules can be deliberately labeled with stable isotopes, in one or more positions, and since they are minimally discriminated in metabolic processes, may be used as a tracer in chemical and biological studies.

    By ETG Risorse e Tecnologia based in Montiglio, ITALY.

  • Premium

    Gas analysis & monitoring system for food traceability

    Recognition of raw materials: The analysis of stable isotopes is very important especially in studies of authenticity of the food. It, on the basis of different isotopic ratio, allows to recognize molecules, present in foods, having the same chemical structure but coming from different raw materials or processed by different processes, for example for biological synthesis or industrial.

    By ETG Risorse e Tecnologia based in Montiglio, ITALY.

  • Premium

    Gas analysis & monitoring system for water - natural sciences

    In nature, the chemical elements can be represented by more isotopes, or atoms of the same element, characterized by a different number of neutrons in the nucleus. When the proton / neutron ratio does not exceed that value likely to upset the balance of the atom, resulting in the phenomenon known as stabilization of radioactive decay, the isotope is called stable. That is, over time, will not tend to emit energy and sub-nuclear particles to gain energy stability, giving rise, at the end of the process, the daughter nucleus (a different element, characterized by stability energy).

    By ETG Risorse e Tecnologia based in Montiglio, ITALY.

  • Combustion gas analysis for the indoor environment industry

    Flue-gas analyzers are designed to be rugged and accurate at the same time. They are used by the HVAC industry, energy industry, process control, glass industry, food industry, universities and analysis is required. 

    By IMR Environmental Equipment, Inc. based in St. Petersburg, FLORIDA (USA).

  • Refineries & Refinery Emissions Monitoring & Analysis

    Procal supplies the oil refining industry with both process and emission monitoring analysers to meet a wide range of applications.

    By Procal - Parker Hannifin Corp based in Peterborough, UNITED KINGDOM.

  • Premium

    Gas analysis & monitoring system for leak searching

    Many chemical compounds and gas are invisible to the naked eye. But there are many companies that make intensive use both during and after the production process. The manner and frequency with which companies are required to monitor, document, report and rectify any escape of volatile gaseous compounds are established by regulations extremely rigid. The technology most widely used is the “Imaging Camera” or “sniffer technology.” “When we look for gas leaks, check all systems in places that may or may not have been previously identified. These controls are carried out regularly and are very important after a shutdown.

    By ETG Risorse e Tecnologia based in Montiglio, ITALY.

  • Premium

    Gas analysis & monitoring system for semiconductor

    The Cleanroom is a combined laboratory chemical, mechanical and / or electronic whose main characteristic is the presence of very pure air, that is a very low content of fine dust in suspension. In the process of semiconductor production, the airborne particles (micro-powder) go to irreparably damage the micro-photoetched that form the chip, creating an electronic circuit defective, and then discarded. This process has forced the improvement of industrial production environments, removing particles from the air, for two purposes: to increase the efficiency of production, increasing the yield of quality, and requirement of the manufacturer (of course based on the demand of the market) in shrink increasing the area of etching of semiconductors (just think of the USB storage media in a few years, went from 16 MB to 16 GB without changing the external dimensions).

    By ETG Risorse e Tecnologia based in Montiglio, ITALY.

  • Gas Analysis Systems for Catalysis, Thermal Analysis, Fermentation and Bio Fuels

    Hiden gas analysis systems provide for high sensitivity, wide dynamic range, real-time analysis of almost any gas and vapour. Hiden’s application specific gas analysis systems are tailored to meet the specific application requirements, and include a range of special sampling, vacuum pumping and vacuum accessories. Hot zone sampling accessories are included for evolved gas analysis from furnaces, and thermo gravimetric analysers, TGA, for example. Thermal analysis methods are vital for catalysis characterization. For thermal analysis including TPD/TPO/TPR, studies, Hiden gas analysis systems include enhanced pumping for hydrogen and special close coupled sampling to the TPD/TPO/TPR reactor for optimum thermal analysis response. In Biogas applications the simultaneous analysis of H2S, CO2, water vapour and CH4 in the PPM to 100% concentration range provides vital information for process development and process monitoring.

    By Hiden Analytical based in Warrington, UNITED KINGDOM.

  • Beverage Analysis

    Hiden gas analysis systems provide for high sensitivity, wide dynamic range, real-time analysis of almost any gas/vapour. Hiden’s application specific gas analysis systems are tailored to meet the specific application requirements, & include a range of special sampling, vacuum pumping and vacuum accessories. Hot zone sampling accessories are included for evolved gas analysis from furnaces, & thermo gravimetric analysers, TGA, for example. Thermal analysis methods are vital for catalysis characterization. For thermal analysis including TPD/TPO/TPR studies, Hiden gas analysis systems include enhanced pumping for hydrogen and special close coupled sampling to the TPD/TPO/TPR reactor for optimum thermal analysis response. In Biogas applications the simultaneous analysis of H2S, CO2, water vapour & CH4 in the PPM to 100% concentration range provides vital information for process development and process monitoring

    By Hiden Analytical based in Warrington, UNITED KINGDOM.

  • Chemical Industry Emissions Analysis

    The inherent flexibility of Procal analysers enables the instruments to be configured to meet Customer’s specific requirements. Their capability to monitor gas concentrations at elevated pressures and temperatures make Procal products ideal for process applications in the Chemical Industry.

    By Procal - Parker Hannifin Corp based in Peterborough, UNITED KINGDOM.

  • Exhaust Gas Emissions

    Hiden gas analysis systems provide for high sensitivity, wide dynamic range, real-time analysis of almost any gas/vapour. Hiden’s application specific gas analysis systems are tailored to meet the specific application requirements, & include a range of special sampling, vacuum pumping & vacuum accessories. Hot zone sampling accessories are included for evolved gas analysis from furnaces, & thermo gravimetric analysers, TGA, for example. Thermal analysis methods are vital for catalysis characterization. For thermal analysis including TPD/TPO/TPR studies, Hiden gas analysis systems include enhanced pumping for hydrogen and special close coupled sampling to the TPD/TPO/TPR reactor for optimum thermal analysis response. In Biogas applications the simultaneous analysis of H2S, CO2, water vapour & CH4 in the PPM to 100% concentration range provides vital ininformation for process development and process monitoring...

    By Hiden Analytical based in Warrington, UNITED KINGDOM.

  • Premium

    Research and commercial applications for the biogas industry

    Covering areas of substrate analysis, process simulation, gas flow measurement, as well as a series of bioreactors.

    By Bioprocess Control AB based in Lund, SWEDEN.

  • Premium

    Measurement solution for VOC emissions monitoring

    Protea has used our VOC gas analysers in many projects requiring the monitoring of complex mixes of VOCs. In the chemical and pharmaceutical industry, VOC abatement plants such as scrubbers and carbon-bed systems are typical installations where the use of Protea analysers and our VOC analysis expertise have proved valuable to plant operators. They prove a very powerful and flexible tool in both process gas measurements and VOC emissions monitoring. In the laboratory, Protea can deliver instruments with all the chemometric software and support to enable users to measure hundreds of gases.

    By Protea Limited based in Middlewich, UNITED KINGDOM.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you