Only show results in Virginia? Ok

process water quality Applications

  • Premium

    Wastewater: Suitability of the quality of water

    When the wastewater from a process cannot be disposed of to the sewerage line or through normal channels because the solids content of the waste water is higher than allowed by the local authorities, the installation of an AZUD filtration system can reduce the solids level, allowing an acceptable quality of waste water to be disposed of.

    By Sistema Azud, S.A. based in Alcantarilla, SPAIN.

  • Premium

    Process water treatment

    Process water covers the wide range of boiler feed water, cooling water for heat exchangers or engine, chemicals dilution, etc. It should typically have a conductivity ranging from 0,1 to 50 uS/cm, with little to no hardness to avoid scaling in heating system. Oxygen and carbon dioxide should be removed to prevent corrosion. Depending on your application, the water quality requirements can vary: Boiler feed water characteristic. Cooling water quality. Tap water or fresh groundwater are the most widely used...

    By Lenntech Water Treatment based in Delfgauw, NETHERLANDS.

  • Industrial solutions for process water control

    Problem: Water is fundamental for numerous manufacturing processes. Contaminated or poor quality process water can cause significant operational problems and compromise the quality of the product.

    By Real Tech Inc. based in Whitby, ONTARIO (CANADA).

  • Treatment of Process Water within Industry

    Water is used for a wide variety of purposes in industrial production. Water has to be treated, so that sufficient amounts are available in the quality required for production. Process water must generally be re-treated after it has been used, so that it can either be discharged according to regulations or returned to the water cycle.

    By EnviroChemie GmbH based in Rossdorf bei Darmstadt, GERMANY.

  • Water quality monitoring for municipal wastewater industry

    Real Tech’s analyzers can be used in municipal wastewater treatment applications to ensure environmental compliance and to increase process efficiency by continuously monitoring the incoming loads and making process adjustments accordingly to optimize aeration rates, and nutrient and chemical dosing.

    By Real Tech Inc. based in Whitby, ONTARIO (CANADA).

  • Water measurement systems & sensors for water quality monitoring

    Effective water quality monitoring is the key to environmental protection of watercourses and for reliable process control and wastewater treatment.  Discharge consents under EPR regulations dictate that water quality monitoring is undertaken to ensure that consented parameters are below the consented concentrations.  Traditionally this has been done using water quality sampling methods but increasingly automatic water quality measurement sensors linked to real-time telemetry is seen as the most...

    By Isodaq Technology - Hydro-Logic Group based in Bromyard, UNITED KINGDOM.

  • Water quality monitoring for textile industry

    Wastewater from a textile facility contains a variety of dyes and organic chemicals from the manufacturing processes that are often difficult to treat. Spectral analysis is well suited for monitoring waste streams to identify problematic dyes prior to treatment. Continuous monitoring of effluent wastewater for BOD and COD helps to ensure effective treatment and quality of effluent to ensure regulatory goals are met prior to discharge.

    By Real Tech Inc. based in Whitby, ONTARIO (CANADA).

  • Premium

    Ozone Water Treatment for Activated Sludge Process Plants

    Ozone breaks up filaments and improves settling characteristics of the sludge... Filamentous sludge is a common problem at activated sludge plants. With ozonation of the return sludge flow it is possible to reduced the amount of filamentous bacteria in the sludge and significantly increased the settling properties of the sludge.This in turn means better performance of the activated sludge process. When a bioreactor is connected to the sludge line the removal of the damaging filamentous bacteria means higher...

    By Primozone Production AB based in Löddeköpinge, SWEDEN.

  • Premium

    Environmental dewatering solutions for industrial wastewater processing

    TenCate Geotube technology provides cost-effective and sure dewatering and containment in a wide variety of industries.  In Power and Utility, Pulp and Paper and other general industries that produce sludge, TenCate Geotube dewatering technology enables the recovery of valuable materials, provides structural stability, improves water quality, or just reduces storage footprint by sometimes 50 to 80%.  The dewatering containers can be custom-sized to the application, placed in available space between...

    By TenCate Geosynthetics Netherlands bv based in AE in Nijverdal, NETHERLANDS.

  • Water quality monitoring systems for high water purifier industry

    The monitoring of “Ultra Pure Water” or “High Purity Water” requires the lowest possible detection limits for process analyzers. Resistivity is often around 18 MΩ. Dedicated instruments can detect infinitely small amounts (ppt e.g. parts per trillion) of ions.

    By SWAN Analytische Instrumente AG based in Hinwil, SWITZERLAND.

  • Process design & engineering services for water treatment industry

    Waste water is any water that has been adversely affected in quality by anthropogenic influence. Municipal wastewater is usually conveyed in a combined sewer or sanitary sewer, and treated at a wastewater treatment plant or septic. Treated wastewater is discharged into receiving water via an effluent sewer.

    By Proxion Process based in Manchester, UNITED KINGDOM.

  • Water quality monitoring for semiconductor industry

    Water is fundamental to the manufacturing process in a semiconductor facility. Electronic components are rinsed or washed several times during the producing process with ultrapure water (UPW) to remove residue. Continuous monitoring of organic constituents (TOC) on the influent city water assist with UPW production. Good quality waste streams for the manufacturing process can also be monitored for reuse potential.

    By Real Tech Inc. based in Whitby, ONTARIO (CANADA).

  • Water quality monitoring for chemical industry

    Chemical plants that produce high quantities of phenols (plastics, pesticides and pharmaceutical industries) and other aromatic organic compounds are excellent candidates for wastewater characterization via spectral analysis. Chemicals that contain conjugated double bonds absorb UV radiation remarkably well. The benefits include higher precision in process control as well as optimization of wastewater treatment.

    By Real Tech Inc. based in Whitby, ONTARIO (CANADA).

  • Laser detection solutions for water-quality monitoring

    The technology of Spectral Fluorescence Signatures (SFS) is a very sensitive and selective tool to monitor many industrial processes on site and in real-time. The SFS analyzer series – SFS-Scanner and Instant Screener spectrofluorometers - are capable of detecting target substances even in complex mixtures without any pre-treatment of the samples.

    By Laser Diagnostic Instruments AS based in Tallinn, ESTONIA.

  • Water treatment for meat processing

    Water is one of the single biggest raw materials used in meat processing, and its quality is of great importance to prevent contamination of food product. The use of contaminated water in the processing plant can spread infection across the whole food batch. This is a cause of serious concern to the food industry, consumers and regulatory bodies, besides that, it causes financial losses and food scare. Chlorine dioxide, a very powerful biocide, has a number of advantages over other products commonly used in...

    By Applied Oxidation LLC based in Chattanooga, TENNESSEE (USA).

  • Biological wastewater processes for municipal treatment plants

    Biowater have knowledge and competence to help in designing and building new systems and upgrade existing infrastructure based on biotechnology as CFIC, MBBR and IFAS solutions.

    The Company offers cost-effective solution that allows municipal plants to both increase their treatment capacity and upgrade the effluent quality with minimal civil works.

    By Biowater Technology AS based in Tonsberg, NORWAY.

  • Process monitoring and controlling for wastewater treatment industry

    Automation can save money, optimise a process and give warning of potential breeches of discharge consent. However, instrument selection is fundamentally important if a control system is to function efficiently. The measurement device must accurately and quickly respond to process variations and it must be reliable in operation if the control system is to function as intended. Designed properly, energy and chemical use can be significantly reduced, saving money and ultimately improving effluent quality.

    By Pollution & Process Monitoring Ltd based in Sevenoaks, UNITED KINGDOM.

  • Water quality monitoring for pulp & paper industry

    Pulp and paper waste streams are exceptionally well suited for spectral analysis due to the high concentration of UV/Vis light absorbing organics in their process water and waste streams. Continuous monitoring of the organic load by means of COD/BOD correlations will help ensure the treatment process is carried out in the most efficient way possible by optimizing aeration rates and nutrient dosing while also making sure that all the regulatory goals are met.

    By Real Tech Inc. based in Whitby, ONTARIO (CANADA).

  • Premium

    Waste water treatment plants Air quality control by TRS MEDOR

    Context & Challenges Globally, the wastewater treatment is the first public health issue. Urban development leads to urbanization near waste water treatment plant and extension of sewerage network. These aspects induce to an augmentation of sulfur compounds (H2S, mercaptans and sulfides) which are very corrosive, odorant and toxic. To monitor this compounds online CHROMATOTEC® offers high meteorological solutions. At the entrance of the waste water plants, where the waste water arrives, strongly...

    By Chromatotec Group based in Val de Virvée, FRANCE.

  • Water quality monitoring for food & beverage industry

    Wastes that are rich in starch such as those that occur in potato processing industries require a balanced addition of other macronutrients such as nitrogen and phosphorus. In order to optimize the dosing of these nutrients it is essential to have a good idea about the organic load entering the biological treatment reactor. Measurement of colour can help with quality control and flavour consistency.

    By Real Tech Inc. based in Whitby, ONTARIO (CANADA).

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you