process water test Applications in USA

  • Premium

    Deionized Water Testing

    Years ago, high purity water was used only in limited applications. Today, deionized (Dl) water has become an essential ingredient in hundreds of applications including: medical, laboratory, pharmaceutical, cosmetics, electronics manufacturing, food processing, plating, countless industrial processes, and even the final rinse at the local car wash.

    By Myron L Company based in Carlsbad, CALIFORNIA (USA).

  • Water-Wastewater Measurements / NO analyzers for measurement of nitrification processes

    NO analyzers for measurement of nitrification processes applied for treating high concentration nitrogen wastewaters by microbial nitric oxide production. Also, the conversion of N-nitrosomines to nitric oxide for the quantification of those compounds in wastewater impacted waters. View Water-Wastewater Measurement Products

    By Eco Physics Inc. based in Ann Arbor, MICHIGAN (USA).

  • Premium

    Reverse Osmosis Water Testing

    Osmosis is the phenomenon of lower dissolved solids in water passing through a semi-permeable membrane into higher dissolved solids water until a near equilibrium is reached. Reverse Osmosis (RO) is a membrane process of purification which removes most of the the total dissolved solids (TDS) in water by reversing the natural process of osmosis. Pressure is applied to a TDS-concentrated solution against a semi-permeable membrane, causing pure water to diffuse through the membrane. RO has become an important...

    By Myron L Company based in Carlsbad, CALIFORNIA (USA).

  • Premium

    Water Testing for Textile Manufacturing

    The textile manufacturing industry encompasses many and diverse processes that rely heavily on the use of water, energy, chemicals, and other resources. Wet spinning, sizing, desizing, scouring, bleaching, mercerization, dyeing and printing are just a few. Monitoring and controlling the pH, TDS/Conductivity/Salt Concentration, ORP (REDOX), and Temperature of the aqueous solutions used in these processes conserves costly resources, controls quality, and reduces the amount of pollution that must be treated before...

    By Myron L Company based in Carlsbad, CALIFORNIA (USA).

  • Premium

    Monitoring of phenol in water

    A plant located in the eastern United States manufactures phenolic resin for applications in plastics molding. This plant uses well water for cooling its reaction process and then discharges the water into a local creek.

    By Turner Designs Hydrocarbon Instruments, Inc. based in Fresno, CALIFORNIA (USA).

  • Drinking water testing

    Water is essential for life. It is part of the environment, being used in industrial processes and available as tap water. To secure the safety of water that is daily available, the amount of necessary microbiology tests to comply with regulatory requirements are increasing and are heavily relying on quick and accurate answers to confirm the identities of a broad selection of important micro-organisms.

    By Bruker Corporation based in Billerica, MASSACHUSETTS (USA).

  • Premium

    Monitoring Once Through Cooling Water

    Fluorescence-based oil in water monitors from Turner Designs Hydrocarbon Instruments have been used extensively in industrial water processes for more than 20 years. These low maintenance fluorescence monitors have no significant measurement disturbance from water turbidity or naturally occurring organics in the water. Oil in water monitors can help detect and prevent major oil spills that may cause significant environmental damage and regulatory compliance infractions.

    By Turner Designs Hydrocarbon Instruments, Inc. based in Fresno, CALIFORNIA (USA).

  • Drinking water solutions for the TOC removal efficiency

    Problem: Organic matter (UV254/TOC) in drinking water can react with chlorine to form harmful disinfection by-products (DBPs). Some removal of TOC is achieved through the conventional drinking water treatment processes, while carbon absorption may be used to further enhance the removal of TOC prior to chlorine disinfection.

    By Real Tech Inc. Distributor in WASHINGTON (USA).

  • Premium

    Waste water treatment plants Air quality control by TRS MEDOR

    Context & Challenges Globally, the wastewater treatment is the first public health issue. Urban development leads to urbanization near waste water treatment plant and extension of sewerage network. These aspects induce to an augmentation of sulfur compounds (H2S, mercaptans and sulfides) which are very corrosive, odorant and toxic. To monitor this compounds online CHROMATOTEC® offers high meteorological solutions. At the entrance of the waste water plants, where the waste water arrives, strongly smelling...

    By Chromatotec Group Office in Houston, TEXAS (USA).

  • Industrial solutions for ultrapure water monitoring

    Problem: Trace contamination in ultrapure water (UPW) can have detrimental effects on a manufacturing process in Semiconductor, Power Generation and Pharmaceutical industries. Onsite treatment is conducted to further remove trace impurities from source water.

    By Real Tech Inc. Distributor in WASHINGTON (USA).

  • Water measurement systems & sensors for water quality monitoring

    Effective water quality monitoring is the key to environmental protection of watercourses and for reliable process control and wastewater treatment. Discharge consents under EPR regulations dictate that water quality monitoring is undertaken to ensure that consented parameters are below the consented concentrations. Traditionally this has been done using water quality sampling methods but increasingly automatic water quality measurement sensors linked to real-time telemetry is seen as the most reliable and...

    By Isodaq Technology - Hydro-Logic Group Distributor in Chesterland, OHIO (USA).

  • Monitoring Oil and Grease in Wastewater

    Real time information speeds processing and saves time in the treatment of water and wastewater. Get a measurement in a few minutes extracting oil from water using S-316 extraction solvent and measuring the oil content using a Model OCMA-550 NDIR analyze

    By HORIBA Europe GmbH Office in CALIFORNIA (USA).

  • Waste water respirometry solutions for toxicity reduction tests

    In industrial manufacturing companies, before a new process comes on-line, it is important to measure the toxicity of the effluent stream. This is especially the case for companies who treat their own waste. From the toxicity value (EC50) obtained, it may be a cost-effective solution to simply discharge the effluent to the treatment works at a slow and defined rate to minimise damage to the activated sludge. Following a period of acclimatisation it is often possible to increase feed rates to the plant and this...

    By Strathkelvin Instruments Ltd. Distributor in MASSACHUSETTS (USA).

  • Water Data Management Solution for Meteorology Sector

    The management of hydro-meteorological data demands the highest process standards. Both recorded and derived data from various observation areas are archived together, edited in graphical and tabular form, analyzed, evaluated and presented. In order that these tasks are carried out efficiently and economically, the support of a specialized software solution is required. Our water data management solutions offer a comprehensive spectrum of functions for integrated collection, processing, quality control, evaluation...

    By KISTERS AG Office in Citrus Heights, CALIFORNIA (USA).

  • Drinking Water

    Ensuring safe drinking water is a complicated and resource intensive process involving stringent state and federal requirements. Failures in the system are not only costly but can pose serious threats to public health. Pumping tests provide needed data to ensure proper flow and aquifer levels. With DriveConnect technology in place it is possible to significantly minimize expensive lift station drawdown testing. Drive‑Chat enabled solutions can reduce costs with automated alerts and remote anywhere anytime...

    By DriveConnect based in Brandon, FLORIDA (USA).

  • CH4 Monitoring in Air

    CH4 (Methane) is a colorless, odorless natural gas that is used in a wide variety of industrial applications such as power generation and chemical production. It is also a byproduct of many biological and geological processes, fracking, and gas drilling. It is highly flammable and creates amounts of carbon monoxide as its combustion byproduct. Methane needs constant monitoring in waste water treatment (for co-generation) and to ensure proper process control (e.g. to determine burning efficiency). A quality CH4...

    By Unisearch Associates Inc. Office in Portland, OREGON (USA).

  • Odour measurement on industrial sites like waste water treatment plants (WWTP), landfill, compost plant...

    CairNet is a simple and efficient way to monitor processes and plant surroundings via a wireless communicating network and autonomous (solar panel and battery). CairNet surveys fugitive emissions of toxic gases or odourous gases around waste water treatment plants (WWTP), allowing you to react quickly to gas leaks. CairNet allows the wireless survey of hundreds of measurement points within a 200m radius of the wireless receiver for a much efficient installation cost. Cairpol systems can be used for fugitive...

    By ENVEA Cairpol (ex Environnement S.A) Distributor in Geneva, ILLINOIS (USA).

  • Premium

    Cleaners for Pharmaceuticals & biotechnology industry

    Our precision cleaners provide consistent results with every use and leave surfaces completely clean. They have been proven effective in critical cleaning applications including mixing tanks, tablet presses, fluid lines, batch process tanks, filter membranes, and other equipment. An economical 1-2% concentration in water is effective in removing gels, emulsifiers, oils, titanium dioxides, dyes, silicons, fragrances, petrolatum, paraffins, insoluble salts, oxides, blood and proteins.

    By International Products Corporation based in Burlington, NEW JERSEY (USA).

  • Premium

    Flow & Energy Management Solutions for Plant & Machine

    Spire Metering offers several solutions for leakage detection. The flowmeters are used to monitor cooling water in machining process. They are used also in liquid process control and leakage detection applications.

    By Spire Metering Technology, LLC. based in Marlborough, MASSACHUSETTS (USA).

  • Premium

    Hydrological and Environmental Monitoring Systems for Soil Monitoring Industy

    Over the past few decades, soil monitoring has become increasingly important. Environmental factors such as climate change, dwindling water resources, and threatened habitats are driving the need to monitor the environment and implement better policies to protect it. Many natural processes in the environment are driven by or in some ways related to soil hydrological processes. Monitoring soil moisture conditions provides important information for the protection of, and in the understanding of local and regional...

    By Stevens Water Monitoring Systems, Inc. based in Portland, OREGON (USA).

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you