Only show results available in Virginia? Ok

remote air monitoring Applications

  • Premium

    Ambient air quality monitoring solutions for remote sensing of ship emissions

    New regulation forces ships to lower the emissions of SO2. Ships travelling in SECA areas has to either run on low sulphur fuel, or install SO2 scrubbers. To measure the SO2 emissions from a ship is not an easy task. OPSIS provides the Port Authorities with a unique measurement principle where the emissions from the ship is measured remotely. Light is passing the emissions and by analyzing the light, concentrations of SO2 can be measured.

    By Opsis AB based in Furulund, SWEDEN.

  • Dust monitoring and Sand Storm Monitoring

    The frequency and intensity of dust and sand storms in many parts of the world are steadily increasing due to droughts and climate change. The severity of such storms is anticipated to increase over the coming years. These dust storms may last hours or days and cause huge damage and imposed a heavy toll on society with its physical effects, such as visibility reduction, heavy winds, red sky, hailstone and severe lightning. Such Dust storms, have a negative impact on human health, and industrial products and activities. They reduce visibility, layer on skin and cloths, infiltrate buildings and find their way into food and drinking water leaving a permanent sandy feeling in your mouth. Traditional dust monitoring instruments whether they be purely filter based gravimetric samplers or continuous monitors utilising Tapered Element Oscillating Microbalance (TEOM) or Beta Attenuation (BAM) simply are unable to cope with the high dust loads created by these storms. The filters on these instruments are quickly clogged and no further measurements are possible until a service technician visits to replace filters and filter tapes. In dust storm events this is impossible. Therefore, over the past few years a need for alternate technology which are non filter based, can cope with extremely high dust loads, require minimal maintenance and can operate off solar power has been employed in regions such as the Gobi Desert of China for the continuous monitoring of dust storm events. These instruments have demonstrated that an instrument can measure dust storm events with maintenance performed only once every 12 months. That it is possible to communicate remotely and that these systems can not only provide an early warning for dust events but have the accuracy and sensitivity to be an extremely useful tool in gauging hourly changes of visibility. Infact such instruments have been utilised by a number of EPAs around the world, including all Australian EPAs for the purpose of measuring ambient visibility as well as providing an accurate indication of rising dust events.

    By Ecotech Pty Ltd based in Knoxfield, AUSTRALIA.

  • Premium

    Ambient air quality monitoring solutions for PM2.5/PM10 particulate monitoring

    OPSIS provides real-time, flexible monitoring of particulate matter in the ambient air. Particulate matter monitoring with OPSIS, is a cost-effective solution, is ideally suited for use in modern monitoring stations. It can be remote controlled and includes automatic calibration, features that frees time. The SM200 meets the new regulation for automatic monitoring of PM10 and PM2.5. It also meets the new regulation for particulate matter sampling on filter membranes for further analysis of cadmium, nickel, PAH and other substances.

    By Opsis AB based in Furulund, SWEDEN.

  • Airport Environmental Monitoring

    Water pollution from airport run-off is increasingly coming under public and government scrutiny. As environmental regulations tighten, the ability to monitor for aviation fuel contamination from runway run-off has become essential.

    Monitoring sites at airports can be extremely challenging often with no power or telephone lines available and with limited access for maintenance. Chelsea’s robust UviLux Hydrocarbon Sensor with its low power consumption and high accuracy is ideally suited for this application. Installed at various locations around the airport, deployed with it’s own integrated anti-biofouling system, utilising the GSM network, the monitoring sites send data to a secure ftp site, where any internet enabled device can access the data. In this way the systems act as any early warning system allowing any hydrocarbon discharge to be detected in real-time.

    Optional environmental monitoring features include remote control to allow the user to turn equipment on and off, change the sample rate and detection range. There is also a facility to allow SMS text and email alarm notifications triggered by user-defined set-points together with customised web pages, data displays and automated data downloads via an ftp server.

    Airport runoff can contain high concentrations of various pollutants, in particular polycyclic aromatic hydrocarbons (PAHs) and polychlorinated biphenyls (PCBs), the environmental levels of which have to be monitored. An understanding of the magnitude of contamination due to airport runoff water is important for the effective management of airport infrastructure. Chelsea’s robust UviLux Hydrocarbon Sensor with its low power consumption and high accuracy is ideally suited to the airport environment.

    By Chelsea Technologies Group based in West Molesey, UNITED KINGDOM.

  • Premium

    Air sampling & monitoring systems for commercial nuclear industry

    Since 1973, HI-Q has directly and successfully served the commercial nuclear industry worldwide with reliable, High Quality (HI-Q), continuous duty air sampling equipment, systems and accessories. For over 30 years, our products, professional design capability, and consumables have been used in remote & internal air monitoring programs including stack sampling system designs which implement the “shrouded probe” per ANSI N13.1 1999 design specifications.

    By HI-Q Environmental Products Company based in San Diego, CALIFORNIA (USA).

  • Environmental monitoring solutions for the industrial sites industry

    Industrial facilities, Superfund sites and other remediation sites. QED Environmental Systems has been a leading manufacturer of air-powered environmental pumps, control equipment and supplies for groundwater remediation, groundwater sampling, landfill leachate and methane condensate pumping since 1982. QED also manufactures high-performance, cost-effective air strippers for groundwater and process water, plus solar-powered, wireless remote data collection systems. Customer service and support includes the industry`s largest in-house engineering staff and a worldwide network of trained, equipped local representatives.

    By QED Environmental Systems, Inc. - A Graco Company based in Dexter, MICHIGAN (USA).

  • Radionuclide Monitoring for Nuclear Power Plants

    The continuing establishment of nuclear power stations around the world pose unique environmental challenges for their operators. Ecotech provides air samplers to nuclear power plants for sampling of radionuclides. A nuclear power plant`s radionuclide monitoring network enables continuous sampling of airborne particles onto sample filters contained within High Volume Air Samplers. These filters are then analysed in a laboratory in order to screen for any radiation releases. The challenge has always been to obtain a sufficiently large volume through the filter in order to exceed the laboratory methods minimum detection limits. Ecotech`s MegaVol Sampler, samples at a flow rate of between 120-150 m3/hr providing a high flow rate in order to collect a sufficient sample mass for laboratory analysis. The MegaVol will maintain volumetric flow rate at a preset volume until the filter is either changed or overloaded. The MegaVol can be equipped with a 3G modem in order to remotely monitor flow rate and other diagnostic parameters such as temperature, pressure and wind speed and direction.

    By Ecotech Pty Ltd based in Knoxfield, AUSTRALIA.

  • Premium

    Visual inspection solutions for the borescope for engine inspection

    Visual inspections of engines and other hard to visualize places are an important part of ongoing automotive maintenance. Rigid and flexible borescopes are a great way to visually inspect engines without having to dismantle the engine block, as they allow you to remotely visualize dark, small, and hard to reach places. Routine inspection with a borescope will allow you identify problem areas and to replace or repair parts before they are causing problem. Flexible borescopes can also be used to track through parts of a fluid or air system to find leaks or blockages in hoses.

    By Medit Inc. based in Winnipeg, MANITOBA (CANADA).

  • Premium

    Visual inspection solutions for the duct HVAC camera

    Duct (HVAC) cleaning is an important part of maintaining good air quality in any building, if ducts are not being cleaned properly, air polluted by dust and other fine particles that can be harmful, will be circulated throughout the system. The best way to ensure ducts are being cleaned completely is to visually inspect them, this can now be accomplished using HVAC inspection cameras. These CCTV cameras are composed of a digital inspection camera attached to a push rod to enable the camera to access all parts of the duct work. With these HVAC cameras, small, normally inaccessible places in duct work can now be remotely visually inspected during and after cleaning to ensure a thorough job is done.

    By Medit Inc. based in Winnipeg, MANITOBA (CANADA).

  • Environmental monitoring solutions for the oil refineries & petrochemical industry

    Air-powered submersible pumps, equipment for free product recovery and groundwater remediation, groundwater sampling. QED Environmental Systems has been a leading manufacturer of air-powered environmental pumps, control equipment and supplies for groundwater remediation, groundwater sampling, landfill leachate and methane condensate pumping since 1982. QED also manufactures high-performance, cost-effective air strippers for groundwater and process water, plus solar-powered, wireless remote data collection systems. Customer service and support includes the industry`s largest in-house engineering staff and a worldwide network of trained, equipped local representatives.

    By QED Environmental Systems, Inc. - A Graco Company based in Dexter, MICHIGAN (USA).

  • Environmental monitoring solutions for the site remediation industry

    Air-powered submersible pumps, equipment for free product recovery and groundwater remediation, air strippers, groundwater sampling. QED Environmental Systems has been a leading manufacturer of air-powered environmental pumps, control equipment and supplies for groundwater remediation, groundwater sampling, landfill leachate and methane condensate pumping since 1982. QED also manufactures high-performance, cost-effective air strippers for groundwater and process water, plus solar-powered, wireless remote data collection systems. Customer service and support includes the industry`s largest in-house engineering staff and a worldwide network of trained, equipped local representatives.

    By QED Environmental Systems, Inc. - A Graco Company based in Dexter, MICHIGAN (USA).

  • Environmental monitoring solutions for the department of defense and department of energy (DOD-DOE) industry

    Equipment for free product recovery and groundwater remediation, and air strippers for military bases and other federal facilities. QED Environmental Systems has been a leading manufacturer of air-powered environmental pumps, control equipment and supplies for groundwater remediation, groundwater sampling, landfill leachate and methane condensate pumping since 1982. QED also manufactures high-performance, cost-effective air strippers for groundwater and process water, plus solar-powered, wireless remote data collection systems. Customer service and support includes the industry`s largest in-house engineering staff and a worldwide network of trained, equipped local representatives.

    By QED Environmental Systems, Inc. - A Graco Company based in Dexter, MICHIGAN (USA).

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you