Only show results available in Virginia? Ok

wastewater heat Applications

  • Premium

    Chemical Water Treatment for boiler water & heating systems

    In nearly all industrial areas steam is needed for different aims e.g. steam for process side, heating purpose or the generation of electricity. To reach the best efficiency of the boiler system an optimal boiler water treatment is essential. Disturbances in boilers caused by deposits, scaling, corrosion, local overheating or carryover into the steam reduce the operating safety and could lead to tremendous economic damages. Kurita delivers innovative technologies to prevent scale and corrosion in the whole boiler system - feed water tank, boiler, steam and condensate system.

    By Kurita based in Ludwigshafen, GERMANY.

  • Industrial and commercial water filtration for heating / cooling systems

    Heating or cooling systems, conventional or alternative, involve water. Over time that water picks up particles which in extreme cases can silt up entire heating systems, requiring expensive maintenance, repair or even replacement. A build-up of solids no thicker than a human hair inside pipework can reduce heat transfer by up to 30%, drastically reducing efficiency and increasing energy consumption.

    By Hydro-Gen Engineering Ltd based in Widnes, UNITED KINGDOM.

  • Industrial wastewater treatment

    Your customized wastewater treatment system – based on the VACUDEST Modular-System An integral part of H2O´s philosophy is the development of customized system solutions. Every industrial wastewater is different. The varity of applications requires a customized wastewater treatment system. Thus we don't have the VACUDEST wastewater treatment system "off the shelf". To ensure that a customized solution is affordable for our customers we developed the VACUDEST Modular-System. Continuous innovation for more cost efficiency We continuously improve our high quality VACUDEST wastewater treatment systems. We have made it our obligation to create genuine benefits through innovation: Self-cleaning heat exchangers, low maintenance systems and a reliable machine control system guarantee reliable processes. As a result, you receive a crystal clear distillate which meets the highest standards. The top quality, efficient and environment friendly VACUDEST vacuum distillation systems are the ri

    By H2O GmbH based in Steinen, GERMANY.

  • Thickening and dewatering of sludges for water and wastewater industry

    Both economic and ecological demands make maximum dewatering of sludge a most crucial step in the process flow, especially for the pulp and paper industry with their large quantities of sludge to handle. A highest possible dry content of dewatered sludge minimizes weight and volume, hence achieving the following objectives: reduction of transport and disposal cost. high heating value for incineration without additional fuel. With the sludge dewatering systems including both AKSE S disc thickener and AKUPRESS BX screw press BELLMER KUFFERATH Machinery offers plant and equipment able to dewater structured sludges to maximum dry contents.

    By BELLMER KUFFERATH Machinery GmbH based in Düren, GERMANY.

  • Sialex for the OEMs Application

    Our products are installed on many industrial areas and in the private household.We have also experience with fluids other than water, which will receive more attention in the future. Sialex is a production process employed in the manufacture of a range of fluid treatment devices. The initial product Sialex®Ring is an “After-sales” device. It is added to existing products (water pipes, in front of heat exchangers, water boilers etc.). Our devices are installed after the original device has been installed.

    By Phoenix Ring Manufaktur UG based in Erbach, GERMANY.

  • Premium

    Wastewater Treatment

    Many industrial and pharmaceutical processes generate wastewater with volatile contaminants that increase the COD and BOD to a point where discharging to municipal wastewater is very costly or not an option. These contaminants can be removed from the water by distillation, substantially lowering the disposal cost, and, in many cases, the removed components can be further purified and reused in the process. MEGTEC offers the following solutions to remove the volatile contaminants and make wastewater suitable for discharge to most municipal wastewater treatment plants: Stripping columns using direct steam or a reboiler Distillation columns using indirect steam heat sources Our technologies have been applied to a range of processes including wastewater treatment from industries such as Pharmaceutical, Semiconductor, Chemical and Petrochemical.

    By Babcock & Wilcox MEGTEC based in De Pere, WISCONSIN (USA).

  • Industrial water softening

    The presence of certain metal ions in water causes a variety of problems. These ions interfere with the action of soaps, lead to build up of limescale, which can foul plumbing, boilers, heating equipment. Water softening is the removal of calcium, magnesium, and certain other metal cations in hard water. The resulting soft water extends the lifetime of plumbing and heating equipment. Softening of low TDS ( Total Dissolved Solids ) water is done commonly with a Strong Acid Cation ( SAC ) exchange resin operating in the sodium form and regenerated with brine. PuriTech`s latest development is a very performant continuous ion exchanger, based on PuriTech`s innovative ION-IX technology which is based on true counter-current ion exchange.

    By PuriTech Ltd based in Herentals, BELGIUM.

  • Premium

    Chemical Water Treatment for cooling and processing water

    An optimal heat transfer is the most important point in every water cooled process. Scale, corrosion and biofouling negatively affect the heat transfer. Therefore Kurita develops for cooling and process water systems customized solutions, based on the combined treatments of scale & fouling prevention, corrosion inhibition, and biocides.

    By Kurita based in Ludwigshafen, GERMANY.

  • Premium

    Chemical Water Treatment for cleaning

    Deposits in water systems, especially in heat exchangers, result in a significant heat transfer reduction, in low efficiency and a loss of cooling capacity. Some systems, after long operational periods without any water conditioning or with inadequate treatment, need cleaning. Therefore Kurita Water Solutions proposes acidic, alkaline and neutral cleaners to remove deposits, scale, fouling, dirt, grime or impurities.

    By Kurita based in Ludwigshafen, GERMANY.

  • Premium

    Advanced water treatment equipments for desalination

    Areas that have no or limited surface water or groundwater may choose to desalinate seawater or brackish water to obtain drinking water. Reverse osmosis is the most common method of desalination, Sea Water Reverse Osmosis (SWRO) is a reverse osmosis desalination membrane process that has been commercially used since the early 1970s. Because no heating or phase changes are needed, energy requirements are low in comparison to other processes of desalination, though still much higher than other forms of water supply (including reverse osmosis treatment of wastewater).

    By Advanced Equipment and Services, Inc. (AESINC) based in Coconut Creek, FLORIDA (USA).

  • Cooling systems for filtration

    The installation of AZUD filtration equipments allows the reduction of the total solids in suspension in the water, and:

    • Helps to maintain an optimal efficiency of energy in the heat interchange process.
    • Reduce the accumulation of particles in the components of the cooling systems.
    • Reduce the growing of microorganisms. The higher or lower proliferation of these microorganisms is directly linked to the
    • higher or lower availability of organic nutrients which favour the development of the same.
    • When reducing the total quantity of suspended solids it is improved the efficiency in the application of chemical products to the treatment of water.
    • Decrease the frequency of maintenance labours.

    By Sistema Azud, S.A. based in Alcantarilla, SPAIN.

  • Industrial water Copper removal and recovery

    Pure copper is soft and malleable; a freshly exposed surface has a reddish-orange color. It is used as a conductor of heat and electricity, a building material, and a constituent of various metal alloys. Recycling is a major source of copper in the modern world. A combination of economic and regulatory factors are now at work to make metal recycle and water reuse very attractive.

    By PuriTech Ltd based in Herentals, BELGIUM.

  • Distributed Temperature Sensing Technology for Stream Monitoring

    Temperature is an important factor in streams ecosystems. Heat tracers have been used to characterize contaminant transport, infiltration rates and energy exchange with groundwater, the atmosphere and radiation. The dynamics of these complicated water bodies is also affected by seasonal and diurnal patterns making characterization particularly challenging. Utilizing temperature measurements that capture spatial and temporal variations at stream ecosystem interfaces provides a mechanism for detailed characterization.

    By Silixa Ltd based in Elstree, UNITED KINGDOM.

  • Ozone/UV systems for swimming pool water treatment

    Studies have proven that chlorine use has negative consequences due to the formation of byproducts, i.e. chlorinated organic compounds and chloramines. Irritation of eyes and mucous membranes, drying out the skin as well as “chlorine smell” are well known troubles. However, these byproducts also accelerate the corrosion in pool halls and significant risk is given by their toxicity (chloramines, combined chlorine) and/or carcinogenicity. Higher rate of asthma prevalence is one of the consequences. These are the reasons why the combined chlorine content - as a marker of chlorination byproducts presence - is to be monitored and why its limit values are specified by authorities. To meet the limits can be tedious and expensive because more water has to be changed and heated up. Chlorine disinfection is not sufficient to prevent infections caused by some waterborne pathogens as dangerous protozoan parasites Cryptosporidium parvum and Giardia lamblia.

    By Lifetech based in Brno, CZECH REPUBLIC.

  • Desalination Thermal Multi Stage Flash Technology (MSF)

    Aquatech MSF ( Multi Stage Flash) Desalination technology was developed more than fifty years ago, and were some of the first to install large size MSF equipment plants in Saudi Arabia, a key market in desalination. With our depth of technological expertise and experience in operating plants, we are positioned to offer the best support in design optimization and rehabilitation of existing facilities. Uses low pressure steam as heat source Highly reliable, and simple to operate & maintain Simpler supply water pretreatment Minimum down time so, higher availability factor High purity product water Provides thermal energy efficiency similar to the MED process Operates at a top brine temperature <110 °C to minimize scaling and to prevent corrosion

    By Aquatech International Corporation based in Canonsburg, PENNSYLVANIA (USA).

  • Cooling Towers and Process Water System Cleaning Applications Using Hydrogen Peroxide

    The unique properties of hydrogen peroxide (H2O2) make it a good technology for keeping cooling loops, process water loops and heat exchangers clean from fouling that can occur due to various contaminants in the water. Hydrogen peroxide works well in removing organic fouling on surfaces through mechanical means and in specific applications through biocidal mechanisms. Hydrogen peroxide can be used in a shock treatment mode where it is fed based on a timer set-up. It can also be used occasionally at higher concentrations for maintenance cleaning purposes of fouled heat exchangers, cooling water loops and process water loops. Performing an occasional shock cleaning of a heat exchanger with hydrogen peroxide can remove buildup from surfaces and can result in improved heat transfer efficiency. By removing surface fouling, hydrogen peroxide may also improve the efficiency of other biocides such as bleach, bromine and non-oxidizers.

    By USP Technologies based in Atlanta, GEORGIA (US) (USA).

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you