Only show results available in Virginia? Ok

water booster Applications

  • Headworks Odor and Corrosion Control Using Hydrogen Peroxide

    Hydrogen Peroxide typically controls odors and corrosion at treatment plant headworks by direct oxidation of hydrogen sulfide (H2S) within the wastewater. In the direct oxidation mode, H2O2 is applied to the wastewater 5-30 minutes prior to the point where the odors are being released, generally as the wastewater line enters the plant boundary. The efficiency of hydrogen peroxide treatment depends upon the available reaction time, the level of iron in the wastewater (reaction catalyst), wastewater pH and temperature, and the initial and target levels of H2S odor. Under optimal conditions, effective dose ratios are 1.2 - 1.5 parts H2O2 per part dissolved sulfide, and can be reliably estimated through beaker tests. H2O2 + H2S → S0 + 2H2O Frequently, control of odors through the primary clarifiers is wanted. In such case, the mechanism of control is both direct oxidation of H2S (as it rises from the solids blanket), and prevention of odor generation (by supplying dissolved oxygen). Control is typically achieved with a booster dose of 1-2 mg/L H2O2 added to the clarifier influent. Higher doses or alternate modes of addition may be required in cases where: 1) hydraulic retention times are > 2-3 hours; 2) solids blanket depths are > 1-2 feet; 3) soluble BOD levels are > 200-300 mg/L; or 4) waste activated sludge is co-settled with the primary solids. 2H2O2 → O2 + 2H2O

    By USP Technologies based in Atlanta, GEORGIA (US) (USA).

  • Municipal and industrial pumping systems

    Watertronics provides cutting-edge pump systems to the Municipal market including cities, towns, and villages along with large government buildings, high-rises and skyscrapers.  We design custom pumping solutions to fit the broad spectrum of Municipal & Industrial needs, all with improved efficiencies designed to effectively reduce power and water consumption. From the small-horsepower modular booster designed to fit through a standard doorway to the high-horsepower water treatment facility with remote monitoring, Watertronics can provide the solution to most any Municipal water challenge.

    By Lindsay Corporation based in Omaha, NEBRASKA (USA).

  • Constant Pressure pump control valves

    For use with water well pumps and booster pumps, the Cycle Stop Valve (CSV) turns any pump into a variable flow, constant pressure system. Working in conjunction with a small pressure tank, the CSV is usually adjusted to the middle of the pressure switch range. IE; 40/60 PSI switch, 50 PSI CSV. The size of the pressure tank determines how much water can be used by the house, before the pressure drops to 40 PSI, and the pressure switch starts the pump. As long as flow rates in and around the house vary from 1 GPM to as much as the pump can produce, the CSV maintains a constant 50 PSI on the system. When there is no more flow required for the house, the CSV allows the little pressure tank to fill to 60 PSI, and the pump is shut off by the pressure switch.

    By Cycle Stop Valves, Inc. based in Lubbock, TEXAS (USA).

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you