Only show results available in Virginia? Ok

water leak Applications

  • Premium

    Water Leak Location for the Leak Detection Industry

    Our water leak location instruments are used to firstly identify leaks in water distribution networks (pre-locate) and then to pinpoint their position using one of our correlators and/or ground microphones.

    By Hermann Sewerin GmbH based in Gütersloh, GERMANY.

  • Premium

    Water Leak Location for the Water Utilities

    Sewerin`s water leak noise loggers are used to monitor water networks for early warning of water leaks. Alarms are sent via SMS or received by radio drive by. Our correlators and ground microphones are then used to pinpoint the water leak`s position. Our equipment is used to save water in many countries by all the world`s major water companies.

    By Hermann Sewerin GmbH based in Gütersloh, GERMANY.

  • Leak sealing solutions for wastewater

    Manhole Rehabilitation: Pipe sealing. SealGuard II High Flow repair. Barrel Joint or Low Flow crack HyperFlex repair. Curtain Grout w/soil rods or pattern grouting. Leaking Boot. Annulus Grouting (pipe within pipe).

    By SealGuard Inc. based in Gibsonia, PENNSYLVANIA (USA).

  • Leak detection for pressurized pipes

    By waterleak.eu based in Co. Kilkenny, IRELAND.

  • Premium

    Monitoring of leaks in heat exchangers

    The Situation

    A California refinery produces xylene for use as commercial product and a precursor for petrochemical manufacturing. A primary component to the production of xylene is the isolation and purification of the chemical from a complex mixture of petroleum hydrocarbons. Steam based heat exchangers are used to process the xylene. Inherent to the design and rough duty heat exchangers face during their operation, leaks can and do develop. When a heat exchanger leaks, xylene contaminates the steam and produces a number of problems ranging from loss of final product, contamination and fouling of steam transfer piping, and ultimately bio-fouling of cooling towers. Consistent and reliable monitoring for xylene or other petroleum hydrocarbons in cooling water or steam condensate can alleviate product loss and process equipment down time.

    By Turner Designs Hydrocarbon Instruments, Inc. based in Fresno, CALIFORNIA (USA).

  • Premium

    Oil Spill Eater II (OSE) for Energy storage and fuel storage leaks

    The OSEI Corporation manufactures a first response bioremediation product Oil Spill Eater II that has been used to clean up leaks around storage tanks from valve breaks, line breaks and small holes in tanks, as well as for tank sludge clean outs. OSE II has been cleaning up oil/hydrocarbon based spills including heavy oils, sludge, drilling mud, tailings as well as refined product since 1989.

    By OSEI - Oil Spill Eater International, Corp based in Dallas, TEXAS (USA).

  • Premium

    Monitoring of heat exchanger leaks in paper plant

    The Situation

    A paper plant in the Eastern United States uses 500 gallons per minute filtered pond water for cooling lubricating oil in its paper line. The resulting warmed water is diverted to an onsite pond. Because the water is used to cool lubricating oil, the plant could not reuse the water in its pulping process for fears of possible oil contamination of the paper pulp.

    By Turner Designs Hydrocarbon Instruments, Inc. based in Fresno, CALIFORNIA (USA).

  • Premium

    Flow & Energy Management Solutions for plant & machine

    Spire Metering offers several solutions for leakage detection. The flowmeters are used to monitor cooling water in machining process. They are used also in liquid process control and leakage detection applications.

    By Spire Metering Technology based in Marlborough, MASSACHUSETTS (USA).

  • Gas Monitoring and Leak Detection in Underwater Application for the Offshore Oil and Gas

    With over 300 sensors and systems sold world-wide and over 35 scientific users publications, Franatech is market leader for underwater methane detection and monitoring. Franatech is a developer and supplier of sensors for detection of gases in water. The company has more than 15 years experience in subsea applications, working with all kinds of sensing technologies. Coming from a scientific environment and further engaged in long term co-operation with universities and institutions, the company has been involved in several oil and gas projects, piloting the use of point sensors for continuous monitoring of gas leakages.

    By Franatech GmbH based in Lüneburg, GERMANY.

  • Dye Tracing

    Monitoring the dilution and movement of a tracer introduced into the water column provides an excellent means of determining the path that may be followed by a discharge and the rate at which dilution is likely to take place. Fluorescent dyes such as Rhodamine, Fluorescein or Agma are the most frequently used tracers for such investigations. Chelsea Technologies has been providing dye tracing systems for over 30 years. Typical applications include sub-sea pipeline leak detection, pollution studies, natural water flow analysis (rivers, lakes, ocean currents, cave water flows, groundwater filtration etc), sewer and storm water drainage analysis. The Chelsea systems can be configured for a wide variety of tracers, are highly sensitive, robust, and deliver real-time data. They can be moored, profiled, towed or affixed to ROV / AUV platforms.

    By Chelsea Technologies Group based in West Molesey, UNITED KINGDOM.

  • Electronic Bulk/ Domestic Water Meter

    ■■ EMS, Taiwan ■■ Intelligence Electronic Water Meter: - Class C Electronic Water Meter - Woltmann Electronic Water Meter - Multi-Jet Water Meter - Vortex Flow Meter - Magnetic Flow Meter - Ultrasonic Flow Meter - Gear Free - Magnet - Free - DMA (District Meter Areas) management - NRW (Non-revenue water) - AMR (Automatic Meter Reading) - MNF Log (Minimum night flow) - Monthly Water Consumption Log -Tamper-Proof Device - Water Leaking Detector - Bi-Directional Flow Indicator - ISO 4064:2005 / ISO 4064: 1993 - All Kinds of Transfer Interface (wired/ wireless) - Smart houses, smart building

    By Energy Management System Co., Ltd. based in Tainan City, TAIWAN.

  • Premium

    Oil in Water Analysis for Flowback or Produced Water

    The amount of water used in and produced by hydraulic fracturing of shale gas wells is in the millions of gallons per well. Whether the water is going to be taken off site for disposal or reused for re-injection, the flowback or produced water needs pretreatment to remove any residual oil from the water. Waiting for remote lab results can take several days to a week. InfraCal TOG/TPH Analyzers allow for oil in water testing at the well site in less than 10 minutes. The sampling requires a few simple steps that can be performed by non-technical personnel. The water is mixed with the extraction solvent, shaken, and then presented to the analyze for measurement. The same InfraCal TOG/TPH Analyzer can be used for TPH in soil if a spill or pond leak occurs to determine the contaminated area. The analyzer features: -Results in under 15 minutes -Detect levels as low as 10 ppm -Portable, rugged, lightweight, easy-to-use -Battery operable -Ideal for field or lab use

    By Spectro Scientific based in Chelmsford, MASSACHUSETTS (USA).

  • Dye penetrant wastewater treatment

    Dye penetrant wastewater includes the presence of a fluorescent dye at about 2-3% in the wastewater. Dye penetrants are used as a method of testing weld integrity to confirm there are no leaks. Dye Penetrant wastewater cannot be simply flushed down the drain. Many companies choose to avoid the headaches of labor-intensive wastewater treatment technologies such as chemical treatment or filtration and simply pay to haul the wastewater. This however, can become quite expensive.

    By ENCON Evaporators based in Hooksett, NEW HAMPSHIRE (USA).

  • Water tower retrofit for repair/replacement

    Cities, Towns, Sub Divisions, Mobile Home Courts, High Rise Buildings, and many others can use the Cycle Stop Valve (CSV) to turn any Submersible, Turbine, or Centrifugal pump into a variable flow, constant pressure system. The CSV maintains a constant pressure on the water system throughout a wide range of flow. Eliminating line breaks and leaks, while precisely providing any amount of water required, the CSV can conserve water as well as energy.

    By Cycle Stop Valves, Inc. based in Lubbock, TEXAS (USA).

  • Sewage Treatment Plants and Flow Sensors for Industry Application

    In sewage treatment plants, flow sensors are primarily installed for internal reasons. Ultrasonic flow meters are used to control the flow velocity in partially filled and fulfilled pressurized pipes, specific plant components, for leak detection or to control the use of additives. International regulations such as the EU-Directive for handling municipal waste water require flow metering for a continuous surveillance of waste water flow. Defective flow monitoring in sewage-treatment plants can therefore influence their operation, but there can also be legal or environmental consequences.

     

    By HydroVision GmbH based in Kaufbeuren, GERMANY.

  • Odour measurement on industrial sites like waste water treatment plants (WWTP), landfill, compost plant...

    CairNet is a simple and efficient way to monitor processes and plant surroundings via a wireless communicating network and autonomous (solar panel and battery). CairNet surveys fugitive emissions of toxic gases or odourous gases around waste water treatment plants (WWTP), allowing you to react quickly to gas leaks. CairNet allows the wireless survey of hundreds of measurement points within a 200m radius of the wireless receiver for a much efficient installation cost. Cairpol systems can be used for fugitive emissions and odour measurement on industrial sites like waste water treatment plants (WWTP), landfill, compost plant, along a street or motorway, or in any sensitive area. Read more https://www.environmental-expert.com/products/cairpol-cairnet-autonomous-real-time-pollution-monitoring-network-274828

    By Cairpol based in Poissy CEDEX 4, FRANCE.

  • Premium

    Mining & minerals solutions for acid mine drainage industry

    Through the application of modern mining technologies, WesTech helps to assure that the byproducts of minerals extraction process are made inert, reliably contained and kept from causing environmental damage. Implementation of WesTech tailings processing technology assures protection of the groundwater, surface waters, wildlife and communities which in the past have been the victims of tailings dam leaks and levy failures.

    By WesTech Engineering, Inc. based in Salt Lake City, UTAH (USA).

  • Premium

    Monitoring of hydroelectric dam sumps

    The Situation

    Hydroelectric dams produce electric power by harnessing the force of the water flowing through the dam. There are numerous sources for oil spillage:

    • The hydroelectric turbines are lubricated by lubrication oils.
    • The very large water control valves are normally hydraulic powered and are lubricated with various greases and oils.
    • Vehicles including fork lifts, trucks, etc., can spill oils and fuels.

    Any accidental spillage of oil or grease or intentional wash down water containing minor amounts of oils, greases, and detergents must be collected and treated before discharge to the river. These fluids along with any water leaks are collected in sumps in the dam and are regularly pumped out. In many cases, the volume of water is substantial.

    By Turner Designs Hydrocarbon Instruments, Inc. based in Fresno, CALIFORNIA (USA).

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you