Only show results available in Virginia? Ok

water measurement equipment Applications

  • Premium

    Inspection of flow measuring equipment for hydraulic inspection

    Definition of Task: Metrologic inspection of flow measuring equipment according to German self-control ordination (EKVO). Inspection of flow measurement at relevant discharge point according to German regulations.

    By NIVUS GmbH based in Eppingen, GERMANY.

  • Laboratory equipments for basic petrophysical measurements using NMR

    Total Porosity BVI FFI CBW Permeability | NMR | GeoSepec2Basic petrophysical parameters (porosity, BVI, FFI, CBW and T2 cutoff) are calculated automatically by the LithoMetrix software installed on every GeoSpec from two measurements – one on a cleaned and saturated core plug, the other on the same plug after it has been centrifuged to irreducible water saturation. Each time, the LithoMetrix software generates a pore size distribution, and from these two pore size distributions automatically calculates the basic parameters. The integrated area under the saturated pore size distribution is a measure of the total porosity and is quantified by comparing to a measurement on a porosity standard supplied with the GeoSpec.

    By Oxford Instruments plc based in Abingdon, UNITED KINGDOM.

  • Disposal and Cleaning Equipment for Waste Water Industy

    Drinking water is not the only area requiring flow monitoring. The disposal and cleaning of waste water also requires flow meters. Waste water used to be dumped directly into the soil or an open channel. As awareness has increased, most discharges are now treated to assure long term sustainability. Modern water treatment plants are highly complex systems that require the use of flow sensors to monitor flow velocity in open channels for waste water discharge. Likewise facilities for waste water collection and clarification plants need regular data on flow rate. The use of radar non contact flow measurement and ultrasonic doppler flow meters are particularly efficient. HydroVision can complete flow measurements in all of these areas.

    By HydroVision GmbH based in Kaufbeuren, GERMANY.

  • Electronic pressure measurement devices for marine, shipbuilding, offshore

    The systems and equipment used in shipping and on board offshore facilities are exposed to severe climatic conditions, harsh environments and extremely high mechanical loads. Even when faced with these demanding conditions, the electronic pressure and level transmitters from BD|SENSORS must remain stable and continue functioning reliably. Thanks to optimised quality management, products such as the DMK 456, DMP 457 and LMK 458 have been perfected and thoroughly tested to ensure that they meet all these requirements.

    By BD Sensors GmbH based in Thierstein, GERMANY.

  • Measurement and control systems for the Indicating the level - mechanically

    Depending on the regulations, a steam boiler must be equipped with one or more direct and/ or indirect level gauges. With direct level gauges, the liquid level can be seen directly through a glass or mica window. The use of a transparent level gauge with background illumination gives operating staff a clear separation between the water and steam zones even when viewed at a relatively long distance. Bicolour level gauges (black and white or green and red) are very suitable for camera transmission to the measuring station because of their special design and the intense LED illumination. With indirect level gauges, the water level is transmitted by a magnetic system to a display panel on the outside of a pipe.

    By IGEMA GmbH based in Münster, GERMANY.

  • Premium

    Chlorine Dioxide Water Treatment for the Pig and Poultry Drinking Water Industry

    Successful pig and poultry farming demands that measures are taken to control the introduction and spread of infectious agents. Chlorine Dioxide has been used very successfully in farming and slaughterhouses as a processing aid that is added to maintain water of good microbial quality. CleanOxide Chlorine Dioxide is used for sanitising hard surfaces and processing equipment to assist in the prevention of the propagation and transmission of disease.

    By NW Solutions based in Perth, AUSTRALIA.

  • Premium

    Surface water quality testing for the environmental monitoring industry

    Aquaread stock a wide range of testing equipment designed to track a number of parameters and water quality testing measures. These can be used in many different bodies of water, including rivers, lakes, streams and seawater. The advantages of tracking water quality and testing for numerous parameters means that it is easier to notice changes which could cause damage to aquatic ecosystems. Early detection not only helps with monitoring water quality, but also helps to put mitigating measures in place. We have a wide range of parameters, although the most popular of these allow for surface water testing, pH, temperature, electrical conductivity and measuring levels of dissolved oxygen. These are standard measurements included in most standard Aquaprobes, although if you require more specific parameter testing then there are a number of additional parameters which can be added onto to the base Aquaprobe to compensate this.

    By Aquaread Limited based in Broadstairs, UNITED KINGDOM.

  • Premium

    TPH in Soil Remediation

    InfraCal TOG/TPH Analyzers allow for TPH (Total Petroleum Hydrocarbons) in soil testing at remediation sites such as leaking underground storage tanks and produced water evaporation ponds. Site managers can avoid having costly soil remediation equipment sit idle while waiting for off-site lab results. Sampling requires a few simple steps that can be performed by non-technical personnel. The soil is mixed with the extraction solvent, shaken, filtered, and then presented to the InfraCal Analyzer for measurement. Features include: - Results in under 15 minutes, including extraction ¨ Detect levels as low as 10 ppm ¨ Portable, rugged, lightweight, easy-to-use ¨ Battery operable ¨ Ideal for field or laboratory applications ¨ Factory calibration available

    By Spectro Scientific based in Chelmsford, MASSACHUSETTS (USA).

  • Kytola Oilan A4 for Paper Machine Circulating Lube Systems

    Searching for a solution to monitoring the water in your oil. Our on-line oil water content analyzer instantly shows changes in the lubrication oil water content. OILAN A4 detects water leaks in their early stages and helps to prevent expensive failures and down time of the lubricated machinery and Equipment. This Equipment measures the water content above the saturation point.

    By Kytola Instruments Oy based in Muurame, FINLAND.

  • Monitoring of Harmful Algae Blooms

    At frst it seems impossible: how can a sensor on board of a satellite circling the earth at an altitude of some 700 kilometers not only identify the total biomass of algae in the water, but also identify species of algae. This is related to what remote sensing specialists call the refectance spectrum of the water. The spectrum is a specifc fngerprint that is created by measuring the refection of water using extremely sensitive sensors, either onboard of a satellite or inside our equipment on the ground. We use a variety of algorithms to translate refectance spectra into concentrations of specifc compounds and phytoplankton species

    By BlueLeg Monitor BV based in JG Sneek, NETHERLANDS.

  • Environmental Monitoring

    Environmental monitoring is becoming more important every day in local, national and international policies, showing the environmental awareness demanded by society.

    This fact gives rise to an increase in the amount of legislation that obliges companies to law enforcement. Thus, the necessity of making more pollutants controls means high analysis expenses to the companies, which need to subcontract this service.

    Although applications in this area advance, there is still a clear demand to get new portable and versatile analysis systems for many different application fields such as pollution in environmental or waste waters, monitoring nutrients in agricultural or horticultural water as well as general process control in chemistry industry. Because of the number of enviromental analysis required, there is a need for screening and monitoring measurements of these compounds at contaminated areas.

    Traditional monitoring techniques are typically based on laboratory analysis of field-collected samples that require considerable effort and expense, and the sample may change before analysis. Moreover, the equipment currently available is too large and expensive and it cannot be made portable.Alternatively, microfluidic and electrochemical sensor technologies can contribute to the development of new portable monitoring systems, complementing standard analytical methods for different environmental monitoring applications.In this way, the decentralization and integration of all those typical analyses is the paramount importance in order to reduce cost, simplify the analytical process and make more accessible these technologies to end-users. The development of portable, robust, and accurate Lab-on-a-Chip systems to monitor priority compounds such as contaminants, explosives, chemical warfare agents, inorganic and organic ions is a demand of modern society. Portability allows analyses to be carried out outside of the laboratory, minimizing the risk of contaminating the sample and leading to a faster response time at a lower cost.

    Thus, MicruX solutions and technologies open the gate to develop portable and esay-handly Lab-on-a-Chip devices in order to improve pollutants in-situ analysis in a very economic and efficient way.

    By MicruX Technologies based in Oviedo, SPAIN.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you