The oil & gas industry faces water and wastewater treatment specific challenges. EVALED evaporators represent an effective solution for both downstream (onshore and offshore) and upstream plants, allowing ZLD (Zero Liquid Discharge).
Accurate online saybolt measurements from zero to +36.
- Quantify yellowness for manufacturing control and product uniformity.
- Ensure your product meets customer expectations
- Detect potential cross-over contamination in fill or supply lines in real-time
- Take the guess work our of product appearance standards
- Application Note #3067
Evaporative gas cooling and conditioning systems help protect your downstream equipment, enhance air pollution control performance, reduce gas volumes, and increase production capacity. Central to our systems are Turbotak atomizing nozzles, which introduce a controlled amount of finely atomized water into the hot gas stream to reduce and/or maintain gas temperature. The water evaporates, while absorbing heat from the gases, for free-flowing dust, zero liquid discharge, and minimal or no wall buildup.
Environics® Ambient Monitor Calibrator with Ozone Generators facilitate dynamic calibration of ambient air analyzers. These instruments automatically perform zero, precision, span and multi-point calibrations using NO, NO2, SO2, CO, O3, hydrocarbons and other gases of interest. All ozone generators are factory calibrated using a NIST traceable ozone standard. The Series 6100, Series 6103 and Series 9100 all meet or exceed U.S. Environmental Protection Agency requirements.
Evaporative gas cooling and conditioning systems use specially engineered atomizing nozzles that introduce a controlled amount of finely atomized water into the hot gas stream to reduce and/or maintain gas temperature. The water evaporates completely while absorbing heat from the gases, which results in free-flowing dust, zero liquid discharge, and minimal or no problems with scale buildup on the walls.
The process of electricity generation from fossil fuels such as coal, oil and natural gas is water-intensive. Between 40-50% of all water abstracted and used in developed countries is used in the generation of electricity. Thus, a reliable, abundant and predictable source of raw water supply to a power plant is a critical factor in site selection. Water supplies are required to provide various process waters for the following essential main purposes such as make-up water, cooling water for steam turbine condensers,...
The world`s appetite for electronic devices - from simple household appliances to sophisticated computers - has led to rapid growth of both these industries. Typically for the electronics industry, there are large waste gas streams (up to 400,000 Nm³/h) with relatively low concentrations of different solvents. The waste gases mainly occur in coating, cleaning and etching processes during the production of semiconductors, CDs/DVDs, Blue-ray discs, DVTs, TFT-LCD and plasma displays. The electronics industry...
Fiberglass Manhole Covers offer a great alternative to traditional heavy cast iron manholes; ZERO SCRAP VALUE for the would be thieves. Fully Traffic Rated Check This Out - Hand Drawn Red. Non Conductive. Non Corrosive. 30 Year + Minimum Lifespan. 1/4 Turn Lock Keeps the Vandals Out. Quality Stainless Steel Lock. Sewer, Wastewater, Water, Gas, Electric, Telco. Perfect for AMR, Radio Read, SCADA, Telemetry and Data Acquisition.
An important step of CEMS testing is verifying of gas analyzers linearity : this step is well performed with a 30 steps gas divider. With just one test gas reference and a zero gas (diluting gas), the required 5 or 10 scaled concentrations may be easily produced "just in time". 30 steps dilution are available to allow using test gases with concentration up to 3 or 6 times the gas analyzer span.