Applications in Nepal

  • Premium

    Road tunnel atmosphere monitoring

    CODEL`s road tunnel monitors are designed exclusively for road tunnel applications. It offers a family of tunnel sensors that provide all the essential measurements necessary to monitor the tunnel atmosphere.

    By Codel International Ltd Distributor in Kathmandu, NEPAL.

  • Premium

    Tunnel solutions for the light sensors

    According to the International Committee on Illumination CIE recommendations, luminance should be monitored as the luminance contained within in a conical field of view, subtending an angle of 20º. It is recommended that a luminance photometer is mounted in the tunnel approach road approximately 120 - 200 metres from the portal, depending on the approach speed of the vehicles and their stopping distance. The purpose of monitoring the luminance at the portal is to adjust the level of light intensity inside the road tunnel to the light intensity outside so that drivers do not have to adjust their eyes quickly or become affected by the “black hole” effect where they decelerate rapidly and become a hazard to other road users.

    By Codel International Ltd Distributor in Kathmandu, NEPAL.

  • Premium

    Monitoring solutions for the flue gas desulphurisation

    Most large coal fired plants have a flue gas desulphurisation (FGD) plant to lower SO2 levels to below emission limit levels. The CODEL GCEM 40 series is used to monitor SO2 levels after the FGD to ensure they are below required levels and to ensure that the process is not too efficient and using too much sorbent. In addition, many plants monitor pre and post the FGD to ascertain the efficiency of the plant.

    By Codel International Ltd Distributor in Kathmandu, NEPAL.

  • Premium

    Monitoring solutions for the marine industry

    While land-based industry has been subject to strenuous emissions regulations over the past decades, air emissions from sea-going ships’ machinery has so far been largely unregulated. As a result, according to EU statistics, ships have become the single biggest source of sulphur dioxide (SO2) within the EU. The US EPA (US Environmental Protection Agency) reports similar findings, i.e., that the proportion of air pollutants released which can be attributed to the shipping industry is increasing. MARPOL Annex VI aims to reduce emissions from ships through international regulations, which hopefully will discourage states from enacting unilateral regulations problematic to the shipping industry.

    By Codel International Ltd Distributor in Kathmandu, NEPAL.

  • Premium

    Monitoring solutions for the opacity and dust monitoring

    There is a requirement for many small boiler operators to monitor Opacity to determine the smoke density emitted from the boiler. On small boilers we recommend the DCEM 1001 Opacity monitor; this simple, low cost monitor   has high efficiency air purges use compressed air to ensure that optical surfaces are virtually free of dust or debris contamination. This ensures minimal maintenance is required on the sensors.

    By Codel International Ltd Distributor in Kathmandu, NEPAL.

  • Premium

    Monitoring solutions for the dust collectors

    Most industrial processes have dust collectors of some form or other, the most popular being filter bag houses. Very few of these are covered by regulation other than to have a broken bag detector to prevent nuisance dusts escaping and creating a local nuisance. The CODEL StakGard is a low cost Tribo-electric monitor that directly measures mass particulate concentration by sensing the
    frictional charge created when particles collide with a conductor. The advanced electronics of the StakGard detect this signal and present it to the operator via a unique modulating LED display.

    By Codel International Ltd Distributor in Kathmandu, NEPAL.

  • Premium

    Monitoring solutions for the dust monitors areas

    For large combustion plants and power plants we offer the DCEM 2100 particulate monitor. This monitor is certified to EN 15267 part 3 QAL 1 for all industrial processes including waste incineration. It offers outputs in Transmission, Opacity and mg/m3 (when calibrated against a Standard Reference Method). The DCEM 2100 offers real-time zero and span calibration and an efficient air purge system to prevent optical contamination.

    By Codel International Ltd Distributor in Kathmandu, NEPAL.

  • Premium

    CO gas monitoring for coal pulverising mills

    Our range of safety analysers can offer early detection of fire / explosive conditions. From CO monitors for pulverising coal mills through to UV flame and smoke detectors installed on oil rigs and the cross-channel passenger shuttles, operated by Eurotunnel.

    By Codel International Ltd Distributor in Kathmandu, NEPAL.

  • Premium

    Tunnel solutions for the extractive areas

    In some countries they do not allow tunnel atmosphere monitors to be mounted on the tunnel wall; also, where there is a single bore it is very difficult to gain access for maintenance purposes. The TunnelTech 400 series are extractive gaseous pollutant and visibility monitors and extract a gas and dust sample from the tunnel bore and carry to a remote analyser. This allows maintenance to take place without affecting tunnel traffic flow.

    By Codel International Ltd Distributor in Kathmandu, NEPAL.

  • Premium

    Tunnel solutions for the tunnel air flow

    Tunnel ventilation systems are designed to enable a sufficient throughput of air to be maintained to ensure a safe operating environment for users. These systems consume large amounts of power and need to be operated as efficiently as possible. To do this it is necessary to know the effectiveness of the system in terms of air flow and direction developed within the tunnel. The TunnelTech 301 is a single point ultrasonic flow monitor that is unaffected by traffic flow and sound reflections. It is designed to withstand the harsh tunnel environment and has a working range of 0-20 metres/second in both directions.

    By Codel International Ltd Distributor in Kathmandu, NEPAL.

  • Premium

    Monitoring solutions for the flow monitoring areas

    Many large combustion plants are now required to monitor mass emissions of major pollutants and to do so requires an accurate measurement of stack gas velocity. The VCEM 5100 is certified to EN 15267 part 3 QAL 1 for all industrial processes including waste incineration. It has several key advantages, firstly the sensors optics are not in contact with the hot and dusty environment, the VCEM 5100 can monitor gases at temperatures exceeding 10000C and the analyser requires minimal maintenance. The VCEM 5100 can be used in extremely dust environments such as SCR’s when dust loadings exceed 10g/m3. The VCEM 5100 is in full compliance with EN/ISO 16911 part 2.

    By Codel International Ltd Distributor in Kathmandu, NEPAL.

  • Premium

    Monitoring solutions for the flow combustion efficiency areas

    Combustion efficiency is of major importance on small boiler plants and the best way to monitor this is by monitoring CO2 emissions. CODEL offer the Model 1010 Cross-Duct CO monitor. Using Infra-red Gas Filter Correlation technology to filter out interferences such as dust and other gases. The Model 1010 has low maintenance requirements and meets the needs of most boiler applications. In addition to small boilers the Model 1010 is also used on Animal carcass incinerators and Crematoriums.

    By Codel International Ltd Distributor in Kathmandu, NEPAL.

  • Premium

    Fire detection solutions for the power stations sector

    One of the main hazards in a power station is a fire in a coal rich environment; the latter can often become an explosion with consequential damage to human life and capital equipment.

    By Codel International Ltd Distributor in Kathmandu, NEPAL.

  • Premium

    Stack emissions monitoring

    Monitoring stack emissions is a fundamental requirement for most industrial processes. Our gas analysers, dust monitors and flow monitors are designed for a wide range of applications and can operate as a fully integrated system or as stand alone instruments.

    By Codel International Ltd Distributor in Kathmandu, NEPAL.

  • Premium

    Fire detection solutions for the oil rigs

    The worse event that can befall on off shore oil rig is fire. The Model 125 is a smoke monitor designed to operate in hazardous areas, especially in oil rig air conditioning and ventilation ducts. The electronics are contained in an explosion proof container rated as EEX de II B T5; the sensing head uses fibre optic cables to transmit the near infra-red light to a reflector where it is returned to another fibre optic cable. The light level is then monitored by a photo-electric cell. The Model 125 gives an output in opacity which is transmitted to the rig safety systems.

    By Codel International Ltd Distributor in Kathmandu, NEPAL.

  • Premium

    Tunnel solutions for the visibility monitor

    The TunnelTech 101 Visibility Monitor (VIS), is an essential part of any road or rail tunnel safety system. It monitors the Visibility within the tunnel and ensures that the tunnel ventilation system provides sufficient clean air for drivers to clearly see the road ahead. The TunnelTech 102 Cold smoke monitor (CSM detects smoke from a fire to rapidly warn the operator of the hazard. Secondly, used in combination with other TunnelTech 101 VIS monitors, the operator can quickly detect the locus of the fire if it is also equipped with the optional PT 101 temperature sensor to accurately measure ambient air temperature in a range of -15 to 1050C.

    By Codel International Ltd Distributor in Kathmandu, NEPAL.

  • Premium

    Tunnel solutions for the gaseous pollutants

    The TunnelTech 200 series are primarily gas monitors with optional Visibility capability. Most use Infra-red absorption technology to monitor gaseous pollutants and those with a visibility channel use optical attenuation for that application. All TunnelTech 200 analysers except the TunnelTech 205 use the same rugged corrosion resistant enclosures and have an optional Data Display unit. As there is only one moving part so reliability levels are very high and maintenance levels very low.

    By Codel International Ltd Distributor in Kathmandu, NEPAL.

  • Premium

    Monitoring solutions for the De-NOx plants

    In recent years the number of Selective Catalytic Reduction (SCR) and Selective Non-Catalytic Reduction (SNCR) plants for De-NOx have increased significantly. Continuous analysis of NOx prior to the de-NOx plant is often required to measure the concentration generated by the combustion process. This may be required to provide feed-forward to the Ammonia/Urea injection system and also to allow the effectiveness of the reduction process to be assessed. Continuous analysis of NOx post-reduction is required to allow the effectiveness of the reduction process to be assessed. It may also be beneficial to monitor NH3 slippage at this stage by calculating from the pre and post NOx levels if excess Ammonia/Urea is being applied.

    By Codel International Ltd Distributor in Kathmandu, NEPAL.

  • Premium

    Monitoring solutions for the gas analysers areas

    Most large coal fired power plants and combustion processes are required to monitor CO, NO and NO2 (NOx), SO2 and possibly CO2; in addition the analyser has to be normalised to Standard conditions. For this application CODEL offers the five channel GCEM 40 series which uses Infrared absorption to measure these gases plus moisture, pressure and temperature.  The analyser can be configured for single channel operation to monitor any of these gases plus CH4 and HCl.

    By Codel International Ltd Distributor in Kathmandu, NEPAL.

  • EMAIV

    UIZ designed and developed Environmental Monitoring and Interactive Visualization Application.

    By UIZ Umwelt und Informationstechnologie Zentrum Office in Kathmandu, NEPAL.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you