Applications in Nevada

  • Premium

    Reverse Osmosis Water Testing

    Osmosis is the phenomenon of lower dissolved solids in water passing through a semi-permeable membrane into higher dissolved solids water until a near equilibrium is reached. Reverse Osmosis (RO) is a membrane process of purification which removes most of the the total dissolved solids (TDS) in water by reversing the natural process of osmosis. Pressure is applied to a TDS-concentrated solution against a semi-permeable membrane, causing pure water to diffuse through the membrane. RO has become an important process for a wide variety of applications including: medical, laboratory, desalination, industrial wastewater, Deionized (Dl) pretreatment, and drinking water.

    By Myron L Company Distributor in NEVADA (USA).

  • Premium

    Deionized Water Testing

    Years ago, high purity water was used only in limited applications. Today, deionized (Dl) water has become an essential ingredient in hundreds of applications including: medical, laboratory, pharmaceutical, cosmetics, electronics manufacturing, food processing, plating, countless industrial processes, and even the final rinse at the local car wash.

    By Myron L Company Distributor in NEVADA (USA).

  • Premium

    Circuit Board Cleanliness Testing

    Contamination of circuit boards can bring about severe degradation of insulation resistance and dielectric strength. Cleanliness of completed circuit boards is, therefore, of vital interest. For those companies who have established circuit board cleaning procedures, the MIL Spec P-28809 has been used as a guideline for control. Now a simple `on line` test for the relative measurement of ionic contamination has been developed. This fast and economical method for testing circuit board cleanliness uses a Myron L Company Ultrameter II™ 4P or 6P, a suitable container, and a mixture of Dl (deionized) water and alcohol.

    By Myron L Company Distributor in NEVADA (USA).

  • Premium

    Boiler Water Testing / Cooling Tower Water Testing

    Boilers and cooling towers share two major water related problems: deposits and corrosion. As steam is generated by a boiler or water evaporating from a cooling tower, dissolved minerals are left behind, increasing the concentration of these minerals. Additional minerals are introduced via the water added to makeup the water lost to steam/evaporation. Eventually, the minerals reach a level (or cycle) of concentration that will cause either loss of efficiency due to scale or damage from corrosion. This level can be determined by the Ryznar or Langlier indices and correlated to a conductivity or TDS range. Most people recognize problems associated with corrosion. Effects from scale deposits, however, are equally important. For example, as little as 1/8` of scale can reduce the efficiency of a boiler by 18% or a cooling tower heat exchanger by 40%!

    By Myron L Company Distributor in NEVADA (USA).

  • Premium

    Pool Water Testing / Spa Water Testing

    Anyone and everyone who is responsible for operating and maintaining a swimming pool or spa has to test, monitor, and control complex, interdependent chemical factors that affect the quality of water bathers are immersed in. Additionally, aquatic facilities operators must be familiar with all laws, regulations, and guidelines governing what these parameters should be.

    By Myron L Company Distributor in NEVADA (USA).

  • Premium

    Oxidation Reduction Potential (ORP)/Redox

    Oxidation Reduction Potential or Redox is the activity or strength of oxidizers and reducers in relation to their concentration. Oxidizers accept electrons, reducers lose electrons. Examples of oxidizers are: chlorine, hydrogen peroxide, bromine, ozone, and chlorine dioxide. Examples of reducers are sodium sulfite, sodium bisulfate and hydrogen sulfide. Like acidity and alkalinity, the increase of one is at the expense of the other.

    By Myron L Company Distributor in NEVADA (USA).

  • Premium

    Water Testing for Environmental Applications

    Keeping the water in our lakes, rivers, and streams clean requires monitoring of water quality at many points as it gradually makes its way from its source to our oceans. Over the years ever increasing environmental concerns and regulations have heightened the need for increased diligence and tighter restrictions on wastewater quality. Control of water pollution was once concerned mainly with treating wastewater before it was discharged from a manufacturing facility into the nation`s waterways. Today, in many cases, there are restrictions on wastewater that is discharged to city sewer systems or to other publicly owned treatment facilities. Many jurisdictions even restrict or regulate the runoff of stormwater — affecting not only industrial and commercial land, but also residential properties as well.

    By Myron L Company Distributor in NEVADA (USA).

  • Premium

    Water Testing for Horticulture

    Modern growing practices include scientific evaluations of soil, water, fertilizers, diseases, etc. While some tests are best performed by a laboratory, others can be easily conducted on location, saving time and money. Three tests in particular, EC, pH, and ALKALINITY, can reveal valuable information about water quality, soil salinity, and fertilizer concentration. MyronL Company’s portable AGRI-METERS provide you with a simple, fast, and accurate means of testing these parameters.

    By Myron L Company Distributor in NEVADA (USA).

  • Premium

    Fountain Solutions

    Accurate fountain (dampening) solution concentration control is essential for consistent, high-quality results in lithography. Low concentration can cause drying on the non-image area of the plate resulting in tinting, scumming, blanket piling, etc. High concentrations, on the other hand, bring about over-emulsification of the ink. This results in weakening of color strength and changes in ink rheology (body and flow properties). Correct concentration will allow the non-image areas of the plate to be appropriately wetted.

    By Myron L Company Distributor in NEVADA (USA).

  • Premium

    Water Testing for Automatic Rinse Tank Controls

    Proper rinsing is one of the most important steps in quality manufacturing or metal finishing. Plenty of low cost, good quality water for rinsing has been available in the past, so rinse water conservation has been largely ignored. Today, this is no longer true. Tap water costs have increased dramatically. Various new regulations are now in effect which limit the allowable volume of wastewater. Others require wastewater treatment. Still other laws tax the amount of water going down the sewer. These factors have all encouraged many manufacturers and platers to invest in automatic rinse tank control systems. Many platers using automatic control systems for the first time are pleased to discover a reduction in water usage of up to 80%.

    By Myron L Company Distributor in NEVADA (USA).

  • Premium

    Water Testing for Textile Manufacturing

    The textile manufacturing industry encompasses many and diverse processes that rely heavily on the use of water, energy, chemicals, and other resources. Wet spinning, sizing, desizing, scouring, bleaching, mercerization, dyeing and printing are just a few. Monitoring and controlling the pH, TDS/Conductivity/Salt Concentration, ORP (REDOX), and Temperature of the aqueous solutions used in these processes conserves costly resources, controls quality, and reduces the amount of pollution that must be treated before discharge of effluent wastes. This can be done manually with handheld instruments or automatically with in-line monitor/controllers.

    By Myron L Company Distributor in NEVADA (USA).

  • Premium

    Elimination of mercaptan odor for wastewater lagoons

    Wastewater lagoons are utilized to collect and stabilize wastewater. Approximately one third of all U.S. secondary waste treatment facilities employ some type of pond system. Lagoons can become septic, or contain compounds that product significant odors.

    By Carus Corporation Office in Sparks, NEVADA (USA).

  • Premium

    Water oxidation for private an public drinking water

    Carus permanganates have been used in private and public drinking water applications for more than 40 years. Municipal drinking water plants use CAIROX® and AQUOX® potassium permanganates, and CARUSOL® liquid permanganate in both ground water (well) and surface water for Pretreatment, Pre-oxidation and Organics Removal. Today, municipal water providers face increased challenges as more stringent regulations are enacted and public awareness regarding water quality becomes heightened.

    By Carus Corporation Office in Sparks, NEVADA (USA).

  • Premium

    Hydrogen sulfide removal in sludge management

    In the treatment of sanitary sewage, bio-solids are separated from the liquid. These bio-solids are concentrated and dewatered using filter presses, centrifuges, or other devices. Hydrogen sulfide and mercaptans are released during the dewatering operation.  Carus permanganates react quickly and produce immediate results for hydrogen sulfide removal in order to provide a safe, odor free environment and minimize corrosion due to sulfides.

    By Carus Corporation Office in Sparks, NEVADA (USA).

  • Premium

    Grease removing in wastewater pipes

    Whether a collection system is handling domestic, commercial, or industrial waste; grease accumulation causes problems in wet wells, lift stations and pipelines. Problems with grease include interference with wet well level controls, reduced wet well capacity, plugging of pipes and pumps, and unsafe working conditions.

    By Carus Corporation Office in Sparks, NEVADA (USA).

  • Premium

    Purifications solutions for air and purification industry

    Carus Corporation is the manufacturer of a series of manganese based catalysts, called CARULITE® catalysts. These Hopcalite type catalysts are used for breathable air purification, emission air purification, and process air purification.

    By Carus Corporation Office in Sparks, NEVADA (USA).

  • Premium

    Product and services for industrial - refineres industry

    For industrial customers, we offer cost-effective and environmentally attractive alternatives to oxidize, precipitate, segregate and remove unwanted pollutants, contaminants and by-products from waste streams and industrial processes. Whether using our time-proven CAIROX®, AQUOX®, and LIQUOX® permanganate-based products, our manganese based CARULITE® catalyst, or any of our other newly developed technologies, our long history and unmatched experience and environmentally friendly expertise provides customer specific solutions to many diverse industries.

    By Carus Corporation Office in Sparks, NEVADA (USA).

  • Premium

    Remediation solutions for soil & water remediation industry

    Carus Corporation has been an active participant in the remediation industry since the late 1990s. Our Carus Remediation Technologies (CRT) team is dedicated to the support and growth ofin situchemical oxidation (ISCO), bioremediation and other emerging technologies.

    By Carus Corporation Office in Sparks, NEVADA (USA).

  • Premium

    Corrosion Control in water for municipal drinking water

    Carus products are used for the control of corrosion and discolored water in many municipalities

    By Carus Corporation Office in Sparks, NEVADA (USA).

  • Data analysis and visualization tools for 3D Geologic Modeling

    EVS , MVS, and EnterVol are essential tools for geologists and geophysicists. No longer are you limited to 2D fence diagrams and crude guesses. Discover dozens of new ways to interpret your site`s boring logs as a group in 3D.

    EVS-PRO and MVS have the ability to build extremely complex geologic models directly from boring logs using indicator kriging in addition to our layered approach. Both EVS and MVS can create complex models that accurately represent subsurface lithology as seen in the video below:

    By C Tech Development Corporation based in Henderson, NEVADA (USA).

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you