Visual inspection solutions for the aviation industries - Aerospace & Air Transport
The role of quality assurance in aerospace manufacture is becoming increasingly important. These inspections require the use of borescopes allowing engineers to properly and thoroughly assess different units of an aircraft: Turbines and engines, combustion chambers, low/high pressure compressors, wings, foils, cells etc.
Recently, aircraft have been required to have on-condition maintenance performed, which relies on the capability to detect failures before they happen, so preventive maintenance can be initiated. Borescopes are becoming instrumental and required to perform these types of inspections. If, during an inspection, maintenance personnel can find evidence that the equipment is approaching the end of its life, then it may be possible to delay the failure, prevent it from happening, or replace the equipment at the earliest convenience, rather than allowing the failure with severe consequences to occur. Modern airplan and helicopter engines are already equipped with endoscope bores, and our wide range of diameters allow for a variety of guide tubes to be used to properly access the inspection area, facilitating quick and easy inspections. Proper borescope inspections shorten aircraft downtimes and safely detect any service requirements.
Medit offers visually advanced inspection devices with its industrial videoscopes, fiberscopes and borescope systems, which make it easy to not only inspect turbines and other hard to reach areas, but to locate and monitor foreign damage.