Anguil Environmental Systems, Inc.

Case Study - New Media Makes RTO Gas Usage A Rarity!

- By:

Courtesy of Courtesy of Anguil Environmental Systems, Inc.


Tekra Corporation has always had an eye on their energy conservation. They are a custom coater of plastic films in Wisconsin where state regulations require over 98% of the Volatile Organic Compounds (VOCs) emitted from their process be destroyed in an oxidizer system. While considering their first oxidizer system, Tekra's Engineers did their homework and invested in an early model Regenerative Thermal Oxidizer (RTO). While at the time RTOs were not the cheapest oxidizer option capital-wise, Tekra knew that long-term, an RTO was their best choice for reliable air pollution control, lower operating costs and a smaller carbon footprint. 'We have always tried to be a Green Company' said Zachary Gernetz, Project Engineer for Tekra.

In 2003, it was time for Tekra to replace their aging RTO system and they turned to Anguil Environmental Systems, Inc. out of Milwaukee, WI.  The equipment of choice was again an RTO, although Anguil's RTO had significant advantages over the previous model including: 95% TER (Thermal Energy Recovery), lower horsepower, lower operating temperatures and better options for turndown and idle modes.

'Tekra went so far as to have us install a small odometer-style meter right on the front of the control panel for the Anguil RTO showing exactly how many BTUs they were saving over their previous unit.' says Greg Blando, Service Manager for Anguil.


Tekra's focus on achieving better energy efficiency did not end there.  With a new nationwide focus on green business practices and energy costs on the rise, they again challenged Anguil to perform even better in 2009. Anguil studied the temperature charts of the RTO system and took air samples during peak VOC loading production runs and determined that the 95% TER of the system could be pushed closer to 97% without creating any adverse high-temperature conditions in the RTO.  Thermal Efficiency of an RTO relates to the ceramic media inside of this type of oxidizer which captures, and then utilizes energy from combustion to pre-heat the incoming, untreated airstream.

'A 2% improvement in TER may not sound all that impressive,' says Mike Scholz, Project Engineer for Anguil. 'But most RTOs out there today were designed to achieve about 95% TER. The natural gas required by those systems is directly tied to that 5% of energy lost. Getting back 2 of the 'lost 5%' is actually a 40% reduction in energy lost. In practical terms, that 2% improvement in TER can translate into 40% less on your RTO natural gas bill.' In addition, the enhanced performance at Tekra put their oxidizer into a self-sustaining mode more often, meaning the fuel value in the VOC-laden exhaust gases are enough to operate the RTO and no auxiliary fuel is needed - hence fewer greenhouse gases emitted.


Because of advances in RTO ceramic heat recovery media, Anguil is routinely able to provide RTO operators like Tekra with a performance upgrade by either adding to the top of existing media beds or at times replacing the top several layers of existing beds with new extruded ceramic media blocks. 'With this type of project, payback is king,' comments Lee Kottke - a manufacturer's rep for Anguil closely involved in the Tekra relationship. 'That's why it is exciting that Anguil can achieve this level of success with only partial media change-outs. That keeps the project cost down and payback periods very reasonable.'

There are other possible effects on project payback to consider. Deeper media beds may require the relocation of chamber instrumentation - like thermocouples. Also, higher efficiency media styles can come with increased backpressure and electrical horsepower cost. Often, however - as in the case of Tekra's RTO - the electrical penalty is minor compared to the natural gas savings.

Gernetz said that with two coaters, running a variety of coating weights and line speeds, it is difficult to get an exact dollar savings. However, prior to the media replacement their RTO often required natural gas to maintain temperature when only treating the exhausts from one coating line. Post retrofit, 'the RTO rarely requires natural gas even when only one coater is operating and never when both are on.' says Gernetz. Zach added, 'Jobs that were never self-sustaining before are now, so I know that the media retrofit is saving us money.' He estimates a 2 year payback for this retrofit.

Considering some enhancements to your RTO?  Think about this:

  • Up until recently, most RTOs were designed with 95% Thermal Energy Recovery (TER%) or less.
  • Rule of Thumb for a self-check: If the average RTO outlet temperature is more than 100°F higher than the RTO inlet temperature your actual TER% is probably less than 95%.
  • Even a small increase in TER% can have a dramatic effect on RTO fuel usage. In some cases, a bump in TER% could eliminate RTO fuel use entirely.
  • Advances in ceramic media have allowed Anguil to improve TER% in RTOs by only replacing a portion of the existing ceramic media beds, improving payback periods.
  • Anguil has performed this retrofit on numerous RTOs, regardless of original manufacturer, and we offer free savings analysis for those interested.

According to Chris Anguil, President of Anguil Environmental Systems, Inc - 'When I reflect on the relationship between Anguil and Tekra, it strikes me how RTOs - while such a huge leap forward in energy efficiency over previous oxidizer styles - are continuing to evolve. Advances in media and advances in controls mean there is still room for efficiency improvements on any RTO system out there - regardless of age. Anyone owning an RTO should follow Tekra's lead and continue to ask if they can do even better energy efficiency-wise. We applaud Tekra's commitment to environmental compliance and energy efficiency and thank them for challenging us with this opportunity.' 

Customer comments

  1. By Dietmar Decker on

    Good article! But: What is new? Thermal efficiency of >95% and temperature difference of only 80 °F (!) is technical standard in Europe since many years. With new features as Energy management system and/or heat storage systems, the energy consumption can be reduced in addition. Regards, Dietmar Decker KBA-MetalPrint, Germany

  2. By Kevin Summ on

    Mr. Decker, Thank you for the comments. The efficiency and destruction requirements throughout Europe are certainly higher, a trend we anticipate seeing elsewhere in the world very soon. However, up until just recently regenerative thermal oxidizers specifically have been limited to 95% thermal energy recovery because of limitations with the internal ceramic media. New advances in this thermal recovery material have just now made 97%+ thermal energy recovery even possible. Please let me know if I can answer any more questions.