Cavern reinforcement & lining design using phase2

0
- By:

Courtesy of Rocscience Inc.

Cavern Reinforcement and Lining Design is a note prepared by Dr. Evert Hoek in response to a technical support question, submitted to Rocscience, on the issue of reinforcement and shotcrete lining design for an underground cavern in a good quality rock mass at a depth of 880 m below surface. The analysis presented here was carried out using the program Phase2 8.0.

Introduction

This note has been prepared in response to a technical support question submitted to Rocscience on the issue of reinforcement and shotcrete lining design for an underground cavern in a good quality rock mass at a depth of 880 m below surface. The analysis presented here was carried out using the program Phase2 8.0.

Customer comments

No comments were found for Cavern reinforcement & lining design using phase2. Be the first to comment!