A two-stage Jet-Venturi scrubber/packed tower system solved a number of pollution problems for an Albany, Oregon, company.
The Zirconium Extraction Div. of Teledyne Wah Chang produces highquality reactor-grade zirconium and hafnium ozide using a chemical separation process. The zirconium and the hafnium are chlorinated and then formed into pure metals for the nuclear and chemical process industries.
The processing of zirconium produces silicon tetrachloride (SiCI4) as a byproduct. The crude inorganic chemical is stored in a tank farm, processed into pure SiCI4 , and sold as a raw material to other chemical processors. Because the silicon tetrachloride generates hydrochloric acid (HCI) fumes when it comes in contact with moisture, the plant needed a way to eliminate fugitive emissions to conform with EPA requirements and a scrubber system that would contain any potentially hazardous fumes that might escape when workers performed maintenance in the tank farm.
To perform efficiently, the system required a scrubber close to the tank farm and designed to handle an inlet flow rate of 3000 to 4000 acfm. In addition, it had to handle an outlet gas concentration of 100 ppm of SiCI4 , based on an inlet concentration of 10 percent by volume, and have an overall efficiency of 99.9 percent.
The company selected a two-stage system-Model 18 x 18-66V Jet-Venturi Fume Scrubber/Separator unit and 48T-12H Packed Tower-from the Clean Air Group, LLC. This system was selected for three reasons:
- It could handle the sticky gel formed when silicon tetrachloride decomposed in water
- It has a high liquid-to-gas ration that provides efficient gas scrubbing of HCI
- Any HCI that may escape is easily scrubbed by the packed tower.
The fume scrubber is designed to entrain and scrub large volumes of gases without the use of baffles or moving parts. Motivating fluid (generally water) leaves the nozzle in a hollow cone spray, creating a draft that draws the gases and vapors into the moving stream where they are continuously scrubbed and absorbed.
Excessive fouling is prevented with the use of a Chevron impact type separator element developed for applications in which solids buildup is anticipated. A continuous washing action keeps the blades clean at all times.
For the second stage of the process, a scrubber material in the packed tower handles residual low concentrations of SiCI4 and HCI. It channels the gas flow upward, through a packed bed; the scrubbing liquid flows down by gravity over the packing.
The packing material had to be selected carefully to prevent solids plugging. Molded polypropylene loops, called Spiral Pac®, were used to obtain a maximum mass transfer area. Liquids and gases come in contact with inside and outside surfaces, preventing gel buildup and providing the high HCI scrubbing capacity.