SnowPure Water Technologies

Electrodeionization for Power Plants — Importance of Silica


Courtesy of SnowPure Water Technologies

Power plants use high purity water to drive steam turbines. Cogeneration and combined-cycle power plants are highly-efficient, using both exhaust turbines and high-pressure steam turbines. The steam must be of the highest purity.

In the 1960’s, boilers operated at 450°C (840°F) and 4MPa (40 atmospheres). Today’s leading edge combined cycle systems operate at 620°C (1150°F) and 30MPa (300 atmospheres).

To keep power efficiency high, maximize uptime, and minimize turbine maintenance, boiler makeup water must be ultrapure (17+ and have very little silica (SiO2).  Silica levels required are in the range of 5-20 ppb, depending on the boiler pressure. Under the boiler/turbine conditions, dissolved silica will form a glass on surfaces like the turbine blades.

Mixed Bed DI technology is a batch process, and requires duplex towers. There can be a spike in silica whenever the MB’s are swapped. Electrodeionization (EDI) is a continuous membrane process, so does not have this problem.

Today, state of the art boiler water makeup uses RO-RO-EDI or RO-GTM-EDI to achieve continuous low levels of silica feeding the boiler system. 1-5 ppb silica is achievable with the proper components and system design. GTM is a membrane-based CO2 removal technology that makes the EDI more efficient.

Customer comments

No comments were found for Electrodeionization for Power Plants — Importance of Silica. Be the first to comment!