Industrial Bevel Helical Gearbox, Guomao Reducer Group, helical parallel bevel speed gear box, manufacturer factory
Category: Gearboxes. Tags: helical-bevel, right-angle.
1.The gear is made of high strength low carbon alloy steel through carburization and quenching. The hardness of tooth surface may reach to HRC58-62. All gear adapts NC tooth grinding process, high in accuracy and good in contact performance
2.High in transmission efficiency single stage, more than 96.5 percent double stage, more than 93 percent three-stage, more 90 percent
3.Smooth and stable in run, low noise
4.Compact, light, long life, high bearing capacity
5.Easy to disassemble, inspect and assemble.
B. Mounting position
The gear units can be supplied for either horizontal or vertical installation. Other arrangements are also possible on request.
This gear reducer is an outer meshed involute helical tooth cylindrical gear speed reducer
It is widely applied to the fields of metallurgy mines hoisting transportation cement architecture chemical textile printing and dyeing pharmaceutical etc.
C. The suitable scope of speed reducer is as follows
1.The rotation of high speed shaft should not be more than 1500rpm
2.The circumferential velocity of gear transmission should not be more than 20 sec
3.The temperature of work environment should be 40 to 45 tem. If below 0 tem, before start, the lubricating oil should be pre-heated to above 0 tem. This speed reducer can be run at clockwise and counterclockwise direction