4-gas monitor Articles

  • Area monitoring of specific ppb-level constituents utilizing process gas chromatography

    ABSTRACT In most of the industrialized countries worldwide, increasingly stringent environmental regulations require the continuous reduction of a wide range of emission sources and components. Despite local variations concerning concentrations, absolute emission quantity, target priorities and timetables, regulations typically require active compliance and proof thereof. The impact of ...

  • Insitu analysis of ammonia slip and water vapor using a tunable diode laser for SCR/SNCR optimization and boiler tube surveillance in power plants

    ABSTRACT Environmental Regulations driven by the 1990 Clean Air Act require Power Plants to reduce NOx emissions. SCR's and SNCR's reduce NOx emission by injecting ammonia into the combustion flue gas. which ideally reacts with the NOx to form H?0 and Nj. The efficiency of the SCR SNCR is determined by monitoring the outlet for excess NH3. referred to as NH3 slip. The flue gas sample ...

  • Taking advantage of production waste - Case Study

    Recycling areas: Various scrap Company name: KME (Serravalle Copper Tubes) Located: Serravalle Scrivia (Alessandria), Italy Founded: 1886 Employees: 5700 KME is a leading global fabricator of copper and copper alloy semi-finished products. Each year 405.000 tons of copper and copper alloy semi-finished products (excluding copper wire) are produced. ...


    By Eldan Recycling A/S

  • Photodegradation of 4-chloronitrobenzene in the presence of aqueous titania suspensions in different gas atmospheres

    The photocatalytic degradation of 4-chloronitrobenzene (4-CNB) was carried out using Degussa P25 TiO2 as photocatalyst in three different gas atmospheres: nitrogen, oxygen, and ozone. The total organic carbon (TOC) and inorganic anions including chloride, nitrite, and nitrate anions were measured to monitor the mineralization processes, while the degradation of 4-CNB and the formation of ...


    By IWA Publishing

  • Landfill Gas Monitoring Procedures

     Purpose of Document The purpose of this document is to provide standardized procedures for California Integrated Waste Management Board (Board) inspectors to use when performing landfill gas (LFG) monitoring during routine disposal site inspections. The standardization of procedures is intended to produce an acceptable level of confidence in the monitoring. This document presumes that each ...


  • Gas Detection and Monitoring Systems

    In greenhouse applications, the accurate measurement of a number of environmental parameters such as carbon dioxide concentration, temperature, light intensity, water, humidity, pH and nutrient levels using sophisticated sensors is used to create a controlled environment for optimising plant growth rates while minimising energy usage. Carbon dioxide concentration is also one of the best ...


    By Edinburgh Instruments Ltd

  • Biofuels Gas Monitoring

    The Customer The Company is one of the world’s leading developers and producers of advanced fuels and green chemicals. The Process The Company uses a gasification process that breaks down wood chips, waste and other feedstock using plasma technology. The process produces a uniform synthetic gas (syngas) that is used to power their turbine engines. ...

  • Stack gas VOC monitoring

    POLLUTION S.r.l. manufactures POLARIS FID analyzer, a cutting-edge technology for the measurement of total hydrocarbons in ambient air and stack emission monitoring in accordance with EN 13526 and EN 12619. This analyser is based on Flame Ionization Detection (FID), a reference method technique to measure total hydrocarbons (THC, VOC, TOC). Polaris FID is a very handy instrument because it allows ...


    By Pollution Srl

  • Monitoring flammable gas in boiler houses

    The most common fuels in use for space and water heating are Oil, Natural Gas and Liquid Petroleum Gas (LPG). By far the most popular, clean and cost effective solutions are utilising Natural Gas or LPG. The traditional safety measure derived from the time of oil fired boiler houses is the use of a fusible link placed above the each boiler. The fusible link is intended to melt if it becomes ...

  • Case study - Monitoring landfill gas

    Infrared absorption Infrared absorption is usually the preferred method for measuring methane and carbon dioxide. Most gases absorb radiation in the infrared region. The wavelength of radiation that is absorbed is determined by the natural vibration frequencies of the molecule. These natural frequencies will depend on several factors. Thus different gas molecules have different natural ...


    By Geotech

  • FTIR gas monitor for diverse applications

    QUANTITECH, a leading supplier of environmental monitoring instrumentation, has recently supplied EURO Environmental Services in Ireland with a transportable Gasmet FTIR multiparameter gas analyser which EURO Environmental's Managing Director Geoff Fitzpatrick says, “is proving invaluable in many varied applications across a broad selection of industries.” With headquarters in Drogheda in Ireland ...


    By Quantitech Ltd

  • Green House Gas Flow Monitoring

    This article addresses the challenges and solutions to flow measurement of green house gases in various industry applications.  GHG flow monitoring regulations are discussed and addressed. Last year the EPA implemented new regulations entitled “Mandatory Reporting of Greenhouse Gases.” The new regulations called for certain facilities emitting 25,000 metric tons or more per year ...

  • The latest ground Gas monitoring innovations

    The latest Ground Gas monitoring innovations   The traditional methodology for ground gas monitoring has been ‘spot monitoring’ – taking event readings at various set times to predict the sub surface gas regime on both on Brownfield and Landfill sites.     This methodology is in general current practice under both the EU Landfill Directive ...


    By Shawcity Limited

  • When is a Nitrogen Monitor Not a Nitrogen Monitor?

    No matter what industry you work in, whether it be diving, agriculture, academia, aerospace or catering you will no doubt have your own industry specific language. My favourite take on this is this ...


    By Analox Sensor Technology

  • CR243/4 Boundary noise monitoring application case study

    Equipment Summary Invictus Environmental Noise Pole Monitor Noisehub Noise Monitoring System Software This is an example of a Boundary Noise Monitoring System that has been built ...


    By Cirrus Environmental

  • Monitoring Multiple Gas Hazards in Ice Arenas

    The equipment used in an arena such as an ice re-surfacer, ice edger, floor sweepers, lift trucks and other special equipment are more often powered by fuel than electricity. The exhaust produced by the gas, propane or diesel fuel powered machines emits, into the air, carbon monoxide (CO), nitrogen dioxide (NO2) and particulates. Ammonia (NH3) is commonly used in the ice chiller mechanical room ...

  • Wastewater Treatment Plant Monitors Greenhouse Gas Emissions

    Globally, little attention is paid to gaseous emissions from wastewater treatment processes. This contrasts greatly with the regulatory monitoring that is applied to the quality of water emissions from such facilities. However, in Helsinki, Finland, a large municipal wastewater treatment facility continuously monitors its emissions of greenhouse gases (GHGs) to help in the city’s efforts to ...


    By Gasmet Technologies Oy

  • A Portable High Speed Gas Chromatograph for Field Monitoring

    Over the last two decades a variety of portable or transportable gas chromatographs (GC) have been specifically designed for field use. Each instrument has introduced innovations that have simplified the task of on site air monitoring. Portable instrument users are well aware of the advantages of field sampling. These advantages include more representative results because there is no sample ...


  • Gas Monitoring for Ventilation Control and Energy Management

    The growing demand for underground and enclosed parking and maintenance garages (resulting from limitations on land availability) has increased the awareness and need for proper ventilation and control systems. In addition, increased health and safety programs have only added to the concerns of toxic and combustible gases in confined or enclosed spaces. Historically, ventilation and make-up air ...


    By Arjay Engineering Ltd.

  • PureAire Universal Gas Monitor Receives UL Listing

    PureAire is pleased to announce that its PureAire Universal Gas Monitor received the UL/CUL listing for models 99030 and 99031. PureAire’s Universalmonitors comply with national and international safety standards, including UL 61010-1, CSA C22.2 NO. 61010-1-12-CAN/CSA, and IEC/EN 31010-1.  Designed to protect against toxic gases including ammonia, bromine, chlorine, hydrogen ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you