air monitoring procedure Articles

  • Designing and Implementing Perimeter Air Monitoring Programs

    Perimeter or fenceline ambient air quality and meteorological monitoring programs have become increasingly valuable at hazardous waste, landfill, dredging, ports, and MGP remediation sites. Air quality monitoring programs protect public health and reduce owner liability ...


    By AECOM

  • A Procedure for Determining Volumetric Shrinkage of an Unsaturated Soil

    Measurement of unsaturated soil volumes can be used to monitor drying shrinkage and allows calculation of the volumetric air content/moisture content relationship. From this relationship, the onset of significant desaturation can be established as a bound to the validity of conventional soil testing under saturated conditions and of conventional analysis procedures for the particular ...


    By ASTM International

  • Design methodology for background air pollution monitoring site selection in an urban area

    We present an air monitoring site selection procedure to determine the minimum number and location of monitoring stations to identify the occurrence of background concentrations greater than a reference value in an urban area. The objective technique reported here is based on the analysis of concentrations estimated using an urban dispersion model for at least one year of hourly information. As ...


    By Inderscience Publishers

  • Selection of Particulate Monitors

    The installation and operation of continuous particulate emission monitors in industrial processes has become well developed and common practice in industrial stacks and ducts over the past 30 years reflecting regulatory monitoring requirements. It supports requirements originating from LAPPC (Local Air Pollution Prevention and Control), IPPC (Integrated Pollution Prevention and Control), WID ...

  • Low-Flow (Minimal Drawdown) Ground-Water Sampling Procedures

    Untitled Document Background The Regional Superfund Ground Water Forum is a group of ground-water ...


    By Solinst Canada Ltd.

  • Monitoring Environmental Quality

    ' In order to determine the effectiveness of actions to improve environmental quality it is necessary to be able to measure relevant environmental parameters at a level of detail which is accurate enough to distinguish the anticipated changes. However, the establishment and maintenance of monitoring systems is time-consuming and expensive and therefore the scale of such systems needs to be kept ...


    By The World Bank

  • Asbestos monitoring – what monitor should I be using?

    Asbestos is the name given to a group of minerals that occur naturally as masses of strong, flexible fibres that can be separated into thin threads and woven. These fibres are not affected by heat and do not conduct electricity. Asbestos is chemically, relatively stable. For these reasons, asbestos has been widely used in many industries.  These four types are classified as follows:  ...


    By Shawcity Limited

  • Ambient Air Sampling Methods

    Pollutants are nothing but any substance that may present in an atmosphere in such a concentration that it may harmful to surrounding, living organism or human being. Sampling and analysis of air pollutants is known as Air quality monitoring and it is major part of environmental monitoring. There are many advanced types of ambient air Sampling methods. we will learn here only which are most ...


    By Perfect Pollucon Services

  • Continous Emission Monitoring (CEMs)

    Presented in Track B1: CEMs at EUEC 2011,January 31 Phoenix, Arizona   B1.1  | Particulate CEM for wet FGD plant William Averdieck |  Managing ...

  • Instrument air case study

    Application Moisture is measured in instrument air to ensure that the air is properly dried. Problem Instrument air is used through-out a facility to protect delicate electronics, instruments, and to operate key process actuators. Many instruments also use instrument air to operate various pneumatic operators they might possess. Too frequently, there is ...

  • General Air Sampling Guidelines (PDF)

    This Standard Operating Procedure (SOP) provides guidance in developing and implementing sampling plans to assess the impact of hazardous waste sites on ambient air. It presents the United States Environmental Protection Agency/Environmental Response Team's (U.S. EPA/ERT's) approach to air sampling and monitoring and identifies equipment requirements. It is not within the scope of this SOP to ...

  • A Breath of Fresh Air for Your

    As the full effect of the Federal Clean Air Act (CAA) Amendments continue to impact today’s industry, many companies will be required to install new or additional air pollution control equipment.  With over two decades of proven success, catalytic oxidation is a popular method for controlling volatile organic compound (VOC) emissions.During the past 25 years, industry has made progress in ...


    By The CMM Group, LLC

  • Baseline data in air quality impact studies

    The main objective of this paper is to explain not only the importance of the baseline data in air quality studies but also the general procedures and steps involved in the baseline data collection. Special considerations on the instruments and measurements for a perfect baseline data collection are also emphasized in this paper. As an example, an adequate baseline data collection procedure which ...


    By Inderscience Publishers

  • California Air Resources Board (CARB) places higher restrictions on air pollution

    As part of the California Global Warming Solutions Act (AB 32) the Air Resources Board (ARB) has approved an early action measure to reduce high-global warming potential (GWP) greenhouse gas (GHGs) emissions by establishing new legislation and defining requirements related to improved monitoring of AC/HVAC systems, enforcement of regulations, reporting of refrigerant usage, and recovery, ...


    By Verisae

  • Dry Air Scrubber for Propylene Oxide

    Background For decades, Advanced Air Technologies, Inc. has been the leader in air scrubber  technology for abatement of Ethylene Oxide (EtO) emissions.   In fact, AAT, Inc. was founded in 1987 on a unique dry scrubbing, chemi-sorption process for EtO.  The result is a series of fixed bed “Safe-Cell II” dry scrubbers, consisting of the DR-490, DR-50, and ...

  • Air quality assessment in the EU: room for improvement?

    Different modelling approaches are used to design and assess air quality plans across Europe. This study assessed the strengths and weaknesses of these different approaches. The researchers conclude that a large variety of models is in use, without a preferred or standard model having emerged yet. They identify integrating local-scale and large-scale models and verifying models with measurements ...

  • Compressed breathing air safety - how important is it?

    At first glance the physiological demands of the firefighter, the scuba diver and the hospital patient have little in common. One is trained to deal with fire and rescue, one swims underwater and one is concerned with either regaining or improving their health. Yet all three depend to some extent on a safe source of compressed breathing air, which is where our gas detection systems come in. ...


    By Analox Sensor Technology

  • AirTest CO2 monitors & the seattle school district case study

    Background Siemens Building Technology provides the building control solutions for the Seattle School District. The school district has been installing CO2 monitors in gyms, auditoriums and some school classrooms as a way to ensure good air quality and a healthy teaching environment. They are also now realizing that there is an energy benefit to CO2 control in that they can control fresh air ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you