air sampling control Articles

  • Ambient Air Sampling Methods

    Pollutants are nothing but any substance that may present in an atmosphere in such a concentration that it may harmful to surrounding, living organism or human being. Sampling and analysis of air pollutants is known as Air quality monitoring and it is major part of environmental monitoring. There are many advanced types of ambient air Sampling methods. we will learn here only which are most ...


    By Perfect Pollucon Services

  • Building Services Management - Air Sampling -

    Untitled Document Maintenance professionals are often the first responders to mold complaints in their facilities. building occupants can be exposed to fungal (mold) ...


    By EMSL Analytical, Inc.

  • Reducing NOx in Diesel Emissions | Spectroscopy Solutions

    Air pollution and NOx emissions from diesel engines are a global concern due to their potential impacts on human health. Researchers worldwide are developing new and improved methods to reduce NOx emissions. Infrared spectroscopy in the gas phase, which is made possible using FTIR gas cells from Specac, has an important role to play in this ...


    By Specac Limited

  • Area Monitoring: Diffusion Sampling

    Indoor and outdoor gas hazards that exist in open areas are usually monitored using diffusion-type sensors. A diffusion sensor has no active sample-drawing system; diffusion sensors rely on the ambient air movement and pressure to deliver the sample to the sensing element. Diffusion-type sensors are a reliable and cost-effective way to monitor open area gas hazards. When installing diffusion ...

  • Practical use of the ISCST3 model to select monitoring site locations for air pollution control

    We present an objective methodology for selection of the minimum number of sampling sites required to register the highest concentration values of air pollutants emitted from a continuous point source. The methodology is based on the analysis of 1-hour concentration values above a threshold value estimated by atmospheric dispersion models. The number and location of the air monitoring stations ...


    By Inderscience Publishers

  • Soil CO2 Flux Measurements -- Using the LI-8100 System to Collect Air Samples for Estimating Soil Trace Gas Flux

    Air samples can be collected from the same air stream used to measure soil CO2 flux with the LI-8100 Automated Soil CO2 Flux System, for estimating the flux of trace gas, such as methane (CH4), ammonia (NH3), nitrous oxide (N2O), isotopic species, etc. This application note describes a simple method for obtaining air samples from the LI- ...


    By LI-COR

  • Casella intrinsically safe TUFF personal air sampling pump and dBadge sound level meter are a hit down under with Australian department of defence

    Following a competitive tender process, the Australian Department of Defence has taken delivery of 180 TUFF personal air sampling pumps and 180 CEL-350 dBadge personal noise dosimeters from Casella CEL (www.casellameasurement.com; 01234 844100), leading global specialist in industrial hygiene and occupational health monitoring equipment. Ronald Azar, ...


    By Casella

  • Expanding Reservoir Air Filters

    In all vented tanks, the rise and fall of fluid levels is offset by a corresponding volume of incoming and outgoing air. Keeping the incoming replacement air clean is essential for contamination control and thus the reliability of hydraulic systems. While targeting the system's reliability, JLM Systems Limited has developed the OilMiser™ Reservoir Aspirator (ORA) kit. This product represents a ...


    By JLM Systems Ltd

  • Instrument air case study

    Application Moisture is measured in instrument air to ensure that the air is properly dried. Problem Instrument air is used through-out a facility to protect delicate electronics, instruments, and to operate key process actuators. Many instruments also use instrument air to operate various pneumatic operators they might possess. Too frequently, there is ...

  • A Breath of Fresh Air for Your

    As the full effect of the Federal Clean Air Act (CAA) Amendments continue to impact today’s industry, many companies will be required to install new or additional air pollution control equipment.  With over two decades of proven success, catalytic oxidation is a popular method for controlling volatile organic compound (VOC) emissions.During the past 25 years, industry has made progress in ...


    By The CMM Group, LLC

  • Boiler Dissolved Oxygen Control

    DISSOLVED OXYGEN CHEMISTRY Dissolved Oxygen (DO) is a measure of the amount of oxygen, usually thought of as a gas, that is dissolved in a liquid such as water. Oxygen is essential to life and is also the most common element found taking part in corrosion reactions. DO can be thought of as the fuel needed for the corrosion process to proceed. It is the corrosion reactions that necessitate ...


    By IC Controls Ltd.

  • Pure water pH measurement in low conductivity samples

    Normally, pH measurements are made in water with 1,000 to 10,000 uS/cm conductivity. The conductivity conies from dissolved solids, typically, salts plus net acid or base which explains the exhibited pH. These dissolved substances are in the solution in ion form, which makes such solutions conducting. With 1,000 uS/cm conductivity of mobile ions pH electrodes have a good circuit and give fast, ...


    By IC Controls Ltd.

  • Partial Flow Sampling System For Transient Engine Testing

    For on-highway engine manufacturers, meeting model year 2007 emissions levels represents a major measurement challenge. However, future off-road engine emissions testing requirements are anticipated to include not only lower steady-state emissions levels, but also the possibility of using transient cycle data. As a result, engine manufacturers are seeking more cost-effective methods of ...


    By Sierra Instruments, Inc.

  • Controlling Odors at Composting Facilities

    Untitled Document ...


    By BioCycle Magazine

  • The 10 Key Factors in Selecting a Stack Sampling Firm

    Summary: This document is a summary of the key factors that you should take into consideration when hiring a stack testing firm.This has been prepared in conjunction with the ASTM criteria for standard practice of testing companies.The ASTM criteria has been supplemented, based on 125 years of direct testing experience, which is the combined years of experience of the individuals that contributed ...

  • Odor Control Advances at Composting Facility

    The Rockland County (New York) Cocomposting Facility began operations in February, 1999, processing biosolids from the five publicly owned treatment works (POTWs) in the county. The Rockland County Solid Waste Management Authority (RCSWMA) owns the facility, but contracted with Waste Management of New York to design, build and operate (DBO) the 110 wet tons/day agitated bin composting facility ...


    By BioCycle Magazine

  • Putting infection control into practice in the workplace

    Healthcare workers are, like patients, subject to illness from a variety of airborne pathogens common to hospital settings. This risk increases during construction and renovation, as these endeavors release dust as well as disease-inducing microbes into the surrounding environment. Since more than one in five workplace illnesses in private industry occur in a hospital setting , hospitals ...

  • Analysers and next generation SRU control

    The history of on-line process analytics is a relatively short one. Development was driven by the need for process control of high value hydrocarbonbased products. The first on-line analyser applications came during the second war. Rapid development came in the 1970s with the advent of the microprocessor and resultant chemometric techniques. Led by Phillips Petroleum, Union Carbide and Dupont ...

  • Using Rn-222 to manage the air quality of air conditioned buildings in Hong Kong

    This paper proposes a pragmatic methodology to manage the air quality of an air conditioned building as well as optimizing energy consumption during venting. Radon-222 (Rn-222) is used as a tracer to quantify the specific production rates and resultant losses of pollutants for which the information is important in indoor air quality management. A term, indoor pollutant inventory, is introduced ...


    By SAGE Publications

  • The ‘ins and outs’ of air quality monitoring

    The National Institute for Health and Care Excellence (NICE) recently issued draft guidance on ‘Air pollution - outdoor air quality and health.’ In the following article Jim Mills, Managing Director of Air Monitors Ltd, explains why there will need to be more funding for monitoring if the mitigation measures mentioned in the guidance are to be implemented effectively. Jim also ...


    By Air Monitors Ltd.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you